Heat transport in thin dielectric films
Abstract
Heat transport in 20–300 nm thick dielectric films is characterized in the temperature range of 78–400 K using the 3ω method. SiO2 and SiNx films are deposited on Si substrates at 300 °C using plasma enhanced chemical vapor deposition (PECVD). For films >100 nm thick, the thermal conductivity shows little dependence on film thickness: the thermal conductivity of PECVD SiO2 films is only ∼10% smaller than the conductivity of SiO2 grown by thermal oxidation. The thermal conductivity of PECVD SiNx films is approximately a factor of 2 smaller than SiNx deposited by atmospheric pressure CVD at 900 °C. For films <50 nm thick, the apparent thermal conductivity of both SiO2 and SiNx films decreases with film thickness. The thickness dependent thermal conductivity is interpreted in terms of a small interface thermal resistance RI. At room temperature, RI∼2×10−8 K m2 W−1 and is equivalent to the thermal resistance of a ∼20 nm thick layer of SiO2 .
Integrity signals
Registry
Cites
Statistics
Claims the paper makes
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
The frequency-independent data for SiO2 is consistent with measurements of SiO2 thin films where no thermal conductivity reduction from bulk due to boundary scattering was observed.
“This frequencyindependent data is consistent with measurements of SiO 2 thin films where there was no observed thermal conductivity reduction from bulk due to boundary scattering 24,31 .”
From Broadband phonon mean free path contributions to thermal conductivity measured using frequency domain thermoreflectance (2013) · cites this paper as [31]
No citation lists for this paper
No citation lists for this paper yet — checked again daily.
References 17 · Cited by 732
- Authors
- Lee, S.-M., & Cahill, D. G.
- Affiliations
- University of Illinois Urbana-Champaign (US)
- Venue
- Journal of Applied Physics
- Publisher
- AIP Publishing
- Published
- 1997-03-15
- Volume
- 81
- Issue
- 6
- Pages
- 2590-2595
- ISSN
- 0021-8979 (ISSN-L)
- 1089-7550
- OpenAlex
- W2019297315
- Cited by
- 732
- References
- 17
- Citations by year
- 2026: 17 · 2025: 22 · 2024: 24 · 2023: 30 · 2022: 24 · 2021: 36 · 2020: 37 · 2019: 36 · 2018: 41 · 2017: 37 · 2016: 29 · 2015: 30 · 2014: 47 · 2013: 30 · 2012: 30
- FWCI
- 11.42
- Type
- journal article
- Language
- en
- Open access
- closed
- Locations
- Journal of Applied Physics (publishedVersion)
- Funders
- National Science Foundation
- U.S. Department of Energy (FG02-91ER45439)
- Topics
- Physical Sciences › Materials Science › Materials Chemistry › Thermal properties of materials
- Physical Sciences › Engineering › Electrical and Electronic Engineering › 3D IC and TSV technologies
- Physical Sciences › Engineering › Computational Mechanics › Heat Transfer and Numerical Methods
- Keywords
- heat transport, dielectric thin films, thermal conductivity, interfacial thermal resistance, SiO2 thin films, plasma-enhanced chemical vapor deposition, film thickness dependence, low-temperature thermal conductivity, 3ω method
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review