The DOI matches its Crossref record; 3 of the 3 references it cites were found in a registry or an index.
On the relationship of high coercivity and L1 ordered phase in CoPt and FePt thin films
Abstract
The microstructure and the room-temperature hysteretic magnetic properties of sputtered, 10 nm thin films of equiatomic binary alloys of CoPt and FePt were characterized using transmission electron microscopy (TEM) and a superconducting quantum interference device (SQUID) magnetometer. A transformation from an atomically disordered, face-centered-cubic structure to the L10 ordered structure occurred during postdeposition annealing and was characterized using digital analysis of dark-field TEM images. The transformation was observed to follow first-order nucleation and growth kinetics, and the ordered volume fraction transformed was quantified at numerous points during the transformation. The ordered volume fraction was then compared to the magnetic coercivity data obtained from the SQUID magnetometer. In contrast to the relationship most commonly described in the literature, that the highest coercivity corresponds to a two phase ordered/disordered mixture, the maximum value for coercivity in this study was found to correspond to the fully ordered state. Furthermore, in samples that were less than fully ordered, a direct relationship between ordered volume fraction and coercivity was observed for both CoPt and FePt. The proposed mechanism for the high coercivity in these films is an increasing density of magnetic domain wall pinning sites concurrent with an increasing fraction of ordered phase.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Introduction to magnetic materials
(2009) · Materials Today · doi:10.1016/s1369-7021(09)70091-4 · Cited by 5,615
High anisotropy L1/sub 0/ thin films for longitudinal recording
Coffey, K. R., Parker, M. A., & Howard, J. K. (1995) · IEEE Transactions on Magnetics · doi:10.1109/20.490108 · Cited by 285
Self-citationOn the High-Energy Product Fe–Pt Permanent Magnet Alloys
Watanabe, K., & Masumoto, H. (1983) · Transactions of the Japan Institute of Metals · doi:10.2320/matertrans1960.24.627 · Cited by 89
Cited by
Monodisperse FePt Nanoparticles and Ferromagnetic FePt Nanocrystal Superlattices
Sun, S., Murray, C. B., Weller, D., Folks, L., & Moser, A. (2000) · Science · doi:10.1126/science.287.5460.1989 · Cited by 6,137
Recent Advances in Chemical Synthesis, Self‐Assembly, and Applications of FePt Nanoparticles
Sun, S. (2006) · Advanced Materials · doi:10.1002/adma.200501464 · Cited by 1,005
Hard-Magnet L10-CoPt Nanoparticles Advance Fuel Cell Catalysis
Li, J., Sharma, S., Liu, X., Pan, Y.-T., Spendelow, J. S., Chi, M., Jia, Y., Zhang, P., Cullen, D. A., Xi, Z., et al. (2019) · Joule · doi:10.1016/j.joule.2018.09.016 · Cited by 532
Deciphering chemical order/disorder and material properties at the single-atom level
Yang, Y., Chen, C.-C., Scott, M. C., Ophus, C., Xu, R., Pryor, A., Wu, L., Sun, F., Theis, W., Zhou, J., et al. (2017) · Nature · doi:10.1038/nature21042 · Cited by 357
Size‐Dependent Chemical and Magnetic Ordering in L 10‐FePt Nanoparticles
Rong, C. ‐., Li, D., Nandwana, V., Poudyal, N., Ding, Y., Wang, Z. L., Zeng, H., & Liu, J. P. (2006) · Advanced Materials · doi:10.1002/adma.200601904 · Cited by 338
Metadata
- Authors
- Ristau, R. A., Barmak, K., Lewis, L. H., Coffey, K. R., & Howard, J. K.
- Venue
- Journal of Applied Physics
- Publisher
- AIP Publishing
- Published
- 1999-10-15
- Volume
- 86
- Issue
- 8
- Pages
- 4527-4533
- ISSN
- 0021-8979 (ISSN-L)
- 1089-7550
- OpenAlex
- W2049106317
- Cited by
- 342
- References
- 3
- FWCI
- 7.41
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.