Aerosol filtration efficiency of household materials for homemade face masks: Influence of material properties, particle size, particle electrical charge, face velocity, and leaks
Open accessThe DOI matches its Crossref record; the references it cites are not checked yet.
Abstract
As a consequence of the COVID-19 pandemic caused by the SARS-CoV-2 virus, the widespread daily use of face masks is promoted worldwide. Particle-size dependent filtration efficiencies (FE; dp = 30 nm–10 µm), applying a particle counting approach, and additionally pressure drops (Δp) were determined for 44 samples of household materials and several medical masks. Huge FE differences were found between sample materials and for different particle sizes, spanning from <10% up to almost 100%. Minimum FE were determined for dp = 50–500 nm particles with significantly larger values for dp = 30 nm particles and especially for those with dp > 2.5 µm. Measurements at different numbers of layers showed that stacks of textiles can be treated as separate filters and total FE and Δp can readily be estimated from the features of the individual layers, leaving laborious measurements of individual combinations obsolete. For many materials, electrostatic attraction contributes strongly to overall FE for particles up to 100 nm diameter. Measurements with defined leaks showed that already a small fractional leak area of 1–2% can strongly deteriorate total FE. This is especially the case for particles smaller than 5 µm diameter, where FE dropped by 50% or even two thirds. Our measurements show that by stacking an adequate number of layers of many fabrics, decent filtration efficiencies can be reached for homemade face masks over large particle size ranges with acceptable pressure drop across the material. Very important, however, is good fit of the masks to minimize leak flows and selection of non-hazardous mask material.
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
In the citing paper
“The ability of materials used in homemade face coverings to remove particulates is completely dependent on the characteristics of the fabric, such as the weave type and fiber structure [4, 62, 81], as well as number of fabric layers.”
From The protective performance of reusable cloth face masks, disposable procedure masks, KN95 masks and N95 respirators: Filtration and total inward leakage (2021) · cites this paper as [81]
In the citing paper
“A systematic investigation by Drewnick et al. [81] of 44 fabrics observed filtration efficiencies varying from ~10% to ~80% (penetration from 20% to 90%).”
From The protective performance of reusable cloth face masks, disposable procedure masks, KN95 masks and N95 respirators: Filtration and total inward leakage (2021) · cites this paper as [81]
In the citing paper
“The data sets employed by Wagner et al. represent a range of mask fit conditions including human subjects, mannikins, and non-leaking custom apparatus [11,20,21,22], but all are likely a best case compared to the range of actual public practice because they were laboratory tested with due diligence and proper usage.”
From Comparative Mask Protection against Inhaling Wildfire Smoke, Allergenic Bioaerosols, and Infectious Particles (2022) · cites this paper as [22]
In the citing paper
“The higher mask efficiencies predicted for larger allergens compared to sub-micrometer smoke and breathing-generated particles is consistent with numerous, particle size-dependent laboratory mask studies (e.g., [11,20,21,22]).”
From Comparative Mask Protection against Inhaling Wildfire Smoke, Allergenic Bioaerosols, and Infectious Particles (2022) · cites this paper as [22]
Citations
The citation lists are queued
They are fetched later and appear here then.
References 39 · Cited by 199
Research works printed but not linked: 8
- Klompas M., 2020, J. Am. Med. Assoc.
- Leopoldina – German National Academy of Sciences., 2020, Coronavirus pandemic – Measures relevant to health
- Li Y., 2020, MedRxiv
- Morawska L., 2020, Clin. Infect. Dis.
- WHO (World Health Organization)., 2014, Infection prevention and control of epidemic- and pandemic-prone acute respiratory infections in health care
- WHO (World Health Organization)., 2020, Country & technical guidance – Coronavirus disease (COVID-19)
- WHO (World Health Organization)., 2020, Advice on the use of masks in the context of COVID-19. Interim guidance
- WHO (World Health Organization)., 2020, Coronavirus disease 2019 (COVID-19): Situation Report – 66, March 26, 2020
Metadata
- Authors
- Drewnick, F., Pikmann, J., Fachinger, F., Moormann, L., Sprang, F., & Borrmann, S.
- Affiliations
- Max Planck Institute for Chemistry (DE)
- Johannes Gutenberg University Mainz (DE)
- Corresponding author
- Drewnick, Frank
- Venue
- Aerosol Science and Technology
- Publisher
- Informa UK Limited
- Published
- 2020-10-08
- Volume
- 55
- Issue
- 1
- Pages
- 63-79
- ISSN
- 0278-6826 (ISSN-L)
- 1521-7388
- OpenAlex
- W3084263207
- Cited by
- 199
- References
- 39
- Citations by year
- 2026: 8 · 2025: 12 · 2024: 26 · 2023: 26 · 2022: 46 · 2021: 77 · 2020: 3
- FWCI
- 21.37
- Type
- journal article
- Language
- en
- Open access
- hybrid
- doi.org
- Licence
- Locations
- Aerosol Science and Technology (publishedVersion, cc-by)
- MPG.PuRe (Max Planck Society) (submittedVersion)
- Topics
- Health Sciences › Medicine › Pulmonary and Respiratory Medicine › Infection Control and Ventilation
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Aerosol Filtration and Electrostatic Precipitation
- Physical Sciences › Environmental Science › Global and Planetary Change › COVID-19 impact on air quality
- Keywords
- aerosol filtration efficiency, home textiles, particle size dependence, electrostatic attraction, pressure drop, mask leak, mask fit, surgical masks, COVID-19 pandemic, SARS-CoV-2, particle counting
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Aerosol filtration efficiency of household materials for homemade face masks: Influence of material properties, particle size, particle electrical charge, face velocity, and leaks. https://app.cochat.ai/papers/10.1080/02786826.2020.1817846
- The paper
- Drewnick, F., Pikmann, J., Fachinger, F., Moormann, L., Sprang, F., & Borrmann, S. (2021). Aerosol filtration efficiency of household materials for homemade face masks: Influence of material properties, particle size, particle electrical charge, face velocity, and leaks. Aerosol Science and Technology. https://doi.org/10.1080/02786826.2020.1817846
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.