The DOI matches its Crossref record; 17 of the 17 references it cites were found in a registry or an index.
On thermoelectric and pyroelectric energy harvesting
Open accessAbstract
This paper deals with small-power energy harvesting from heat. It can be achieved using both thermoelectric and pyroelectric effects. In the first case, temperature gradients are necessary. The main difficulty of thermoelectric energy harvesting is imposing a large temperature gradient. This requires huge heat flows because of the limited surface heat exchanges and the large heat conductivity of thermoelectric materials. This results in a drastic decrease of power and the efficiency of conversion. In case of pyroelectric energy harvesting, a time varying temperature is necessary. Although such a temperature time profile is hard to find, the overall optimization is easier than the thermoelectric strategy. Indeed, it depends much less on heat exchange between the sample and the outer medium, than on heat capacity that dimensions optimization may easily compensate. As a consequence, it is shown that the efficiency and output power may be much larger using pyroelectric energy harvesting than thermoelectric methods. For instance, using a limited temperature gradient due to the limited heat exchange, a maximum efficiency of 1.7% of Carnot efficiency can be expected using a thermoelectric module. On the contrary, a pyroelectric device may reach an efficiency up to 50% of Carnot efficiency. Finally, an illustration shows an estimation of the output power that could be expected from natural time variations of temperature of a wearable device. Power peaks up to 0.2 mW cm −3 were found and a mean power of 1 µW cm −3 on average was determined within 24 h testing.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Thermoelectric Cooling and Power Generation
DiSalvo, F. J. (1999) · Science · doi:10.1126/science.285.5428.703 · Cited by 3,240
A study of low level vibrations as a power source for wireless sensor nodes
Roundy, S., Wright, P. K., & Rabaey, J. (2003) · Computer Communications · doi:10.1016/s0140-3664(02)00248-7 · Cited by 2,819
Giant Electrocaloric Effect in Thin-Film PbZr 0.95 Ti 0.05 O 3
Mischenko, A. S., Zhang, Q., Scott, J. F., Whatmore, R. W., & Mathur, N. D. (2006) · Science · doi:10.1126/science.1123811 · Cited by 1,713
Toward energy harvesting using active materials and conversion improvement by nonlinear processing
Guyomar, D., Badel, A., Lefeuvre, E., & Richard, C. (2005) · IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control · doi:10.1109/tuffc.2005.1428041 · Cited by 1,049
Self-citationImproving Power Output for Vibration-Based Energy Scavengers
Roundy, S., Leland, E. S., Baker, J., Carleton, E., Reilly, E., Lai, E., Otis, B., Rabaey, J. M., Sundararajan, V., & Wright, P. K. (2005) · IEEE Pervasive Computing · doi:10.1109/mprv.2005.14 · Cited by 1,031
An electromagnetic, vibration-powered generator for intelligent sensor systems
Glynne-Jones, P., Tudor, M. J., Beeby, S. P., & White, N. M. (2004) · Sensors and Actuators A: Physical · doi:10.1016/j.sna.2003.09.045 · Cited by 773
Thermoelectrics, an environmentally-friendly source of electrical power
Rowe, D. M. (1999) · Renewable Energy · doi:10.1016/s0960-1481(98)00512-6 · Cited by 393
Mischenko, A. S., Zhang, Q., Whatmore, R. W., Scott, J. F., & Mathur, N. D. (2006) · Applied Physics Letters · doi:10.1063/1.2405889 · Cited by 374
Review of some lesser-known applications of piezoelectric and pyroelectric polymers
Lang, S. B., & Muensit, S. (2006) · Applied Physics A · doi:10.1007/s00339-006-3688-8 · Cited by 277
Pyroelectric energy conversion: Optimization principles
Sebald, G., Lefeuvre, E., & Guyomar, D. (2008) · IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control · doi:10.1109/tuffc.2008.680 · Cited by 274
Self-citation
Cited by
Piezoelectric and ferroelectric materials and structures for energy harvesting applications
Bowen, C. R., Kim, H. A., Weaver, P. M., & Dunn, S. (2014) · Energy Environ. Sci. · doi:10.1039/c3ee42454e · Cited by 1,223
Ferroelectricity and Antiferroelectricity of Doped Thin HfO2‐Based Films
Park, M. H., Lee, Y. H., Kim, H. J., Kim, Y. J., Moon, T., Kim, K. D., Müller, J., Kersch, A., Schroeder, U., Mikolajick, T., et al. (2015) · Advanced Materials · doi:10.1002/adma.201404531 · Cited by 1,189
Pandey, R., Vats, G., Yun, J., Bowen, C. R., Ho‐Baillie, A. W. Y., Seidel, J., Butler, K. T., & Seok, S. I. (2019) · Advanced Materials · doi:10.1002/adma.201807376 · Cited by 1,069
Smart Textiles for Electricity Generation
Chen, G., Li, Y., Bick, M., & Chen, J. (2020) · Chemical Reviews · doi:10.1021/acs.chemrev.9b00821 · Cited by 931
Pyroelectric materials and devices for energy harvesting applications
Bowen, C. R., Taylor, J., LeBoulbar, E., Zabek, D., Chauhan, A., & Vaish, R. (2014) · Energy Environ. Sci. · doi:10.1039/c4ee01759e · Cited by 836
Metadata
- Authors
- Sebald, G., Guyomar, D., & Agbossou, A.
- Venue
- Smart Materials and Structures
- Publisher
- IOP Publishing
- Published
- 2009-09-23
- Volume
- 18
- Issue
- 12
- Pages
- 125006
- ISSN
- 0964-1726 (ISSN-L)
- 1361-665X
- OpenAlex
- W2116638530
- Cited by
- 305
- References
- 17
- FWCI
- 15.31
- Type
- journal article
- Language
- en
- Open access
- bronze
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: On thermoelectric and pyroelectric energy harvesting. https://app.cochat.ai/papers/10.1088/0964-1726/18/12/125006
- The paper
- Sebald, G., Guyomar, D., & Agbossou, A. (2009). On thermoelectric and pyroelectric energy harvesting. Smart Materials and Structures. https://doi.org/10.1088/0964-1726/18/12/125006
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.