The DOI matches its Crossref record; 4 of the 4 references it cites were found in a registry or an index.
Calculation of Peridotite Partial Melting from Thermodynamic Models of Minerals and Melts. III. Controls on Isobaric Melt Production and the Effect of Water on Melt Production
Abstract
We present a rigorous calculation of the isobaric entropy (S) change of the melting reaction for peridotite (∂S/∂F)Prxn, where F is the melt fraction. Calculations at 1 and 2 GPa for fertile and depleted peridotite show that (∂S/∂F)Prxn varies as a function of extent of melting, temperature, and residual mineral assemblage. Changes in reaction stoichiometry cause discontinuous changes in (∂S/∂F)Prxn. Although calculated (∂S/∂F)Prxn varies by about a factor of two (from ∼0.25 to ∼0.5 J/K per g), such variations have relatively little effect on the formation of melt during adiabatic upwelling and a characteristic value suitable for peridotite partial melting at least up to 3 GPa is 0.3 J/K per g. Calculated variations in isobaric melt productivity, (∂F/∂T)P, are large and have a significant effect on calculated adiabatic productivity, (∂F/∂P)S. For partial melting of fertile peridotite, MELTS calculations suggest that near-solidus productivities are greatly reduced relative to productivities at higher melt fraction, owing to the incompatible behavior of Na2O and the effect of this component on the liquidus temperature of partial melts. This behavior can also be demonstrated in simple model systems. Calculated near-solidus productivity for fractional or incremental batch melting of peridotite is lower than for batch melting, but after a small amount of melting (∼2%), productivity for the fractional or incremental batch melting case is greater than that of batch melting. This too can be demonstrated both by MELTS calculations and by calculations in simple model systems. Productivities for systems enriched in incompatible components are systematically lower than those depleted in such components, though the total melt produced at any given temperature will be greater for an enriched system. Exhaustion of clinopyroxene from peridotite residua decreases calculated productivity by about a factor of four, and therefore extensive partial melting of harzburgitic residues is inhibited. Calculated isothermal addition of water to hot peridotite causes melting to increase roughly linearly with the abundance of water added to the system, in agreement with the trend recognized earlier for Mariana trough basalts. Melt production for calculated addition of a subduction fluid (45 wt % H2O, 45% Na2O, 10% K2O) is only slightly greater than for pure water. If water addition to peridotite is not forced to be isothermal by an externally imposed heat sink or by buffering from low variance chemical reactions, then it will approach isenthalpic conditions, which will reduce melt production per increment of water added by about a factor of two. For heating of peridotite containing minor amounts of H2O, calculations suggest that the extent of melting will remain small (<5%) until the temperature is sufficient to generate significant melt for an equivalent dry peridotite. Small degrees of melting deep in mantle source regions caused by alkalis, CO2, and H2O probably result in several distinct melting regimes where melt productivities are very small and melt compositions are strongly influenced by high concentrations of alkalis and/or volatiles. Such regions are almost certainly in the garnet peridotite stability field, and owing to the small extents of melting and low productivities in these deep melting zones, they are likely regions for development of extreme U-series disequilibria.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
The volume and composition of melt generated by extension of the lithosphere
McKENZIE, D., & BICKLE, M. J. (1988) · Journal of Petrology · doi:10.1093/petrology/29.3.625 · Cited by 2,951 · cited 3×
“Although the calculations have inaccuracies, the of fusion (DS fus) (McKenzie & Bickle, 1988; Scott, 1992;extent of agreement with melting experiments on periIwamori et al., 1995).”
BackgroundHirth, G., & Kohlstedt, D. L. (1996) · Earth and Planetary Science Letters · doi:10.1016/0012-821x(96)00154-9 · Cited by 1,599
Generation of arc basalt magmas and thermal structure of the mantle wedge in subduction zones
Tatsumi, Y., Sakuyama, M., Fukuyama, H., & Kushiro, I. (1983) · Journal of Geophysical Research: Solid Earth · doi:10.1029/jb088ib07p05815 · Cited by 529
An evaluation of the global variations in the major element chemistry of arc basalts
Plank, T., & Langmuir, C. H. (1988) · Earth and Planetary Science Letters · doi:10.1016/0012-821x(88)90135-5 · Cited by 487
Cited by
A new parameterization of hydrous mantle melting
Katz, R. F., Spiegelman, M., & Langmuir, C. H. (2003) · Geochemistry, Geophysics, Geosystems · doi:10.1029/2002gc000433 · Cited by 1,061
Ghiorso, M. S., Hirschmann, M. M., Reiners, P. W., & Kress, V. C. (2002) · Geochemistry, Geophysics, Geosystems · doi:10.1029/2001gc000217 · Cited by 891
Self-citationMantle solidus: Experimental constraints and the effects of peridotite composition
Hirschmann, M. M. (2000) · Geochemistry, Geophysics, Geosystems · doi:10.1029/2000gc000070 · Cited by 867
Self-citationWATER, MELTING, AND THE DEEP EARTH H2O CYCLE
Hirschmann, M. M. (2006) · Annual Review of Earth and Planetary Sciences · doi:10.1146/annurev.earth.34.031405.125211 · Cited by 631
Self-citationThe influence of H2O on mantle wedge melting
GROVE, T., CHATTERJEE, N., PARMAN, S., & MEDARD, E. (2006) · Earth and Planetary Science Letters · doi:10.1016/j.epsl.2006.06.043 · Cited by 507
Metadata
- Authors
- Hirschmann, M. M., Asimow, P. D., Ghiorso, M. S., & Stolper, E. M.
- Venue
- Journal of Petrology
- Publisher
- Oxford University Press (OUP)
- Published
- 1999-05-01
- Volume
- 40
- Issue
- 5
- Pages
- 831-851
- ISSN
- 0022-3530 (ISSN-L)
- 1460-2415
- OpenAlex
- W2163031935
- Cited by
- 190
- References
- 4
- FWCI
- 8.02
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Calculation of Peridotite Partial Melting from Thermodynamic Models of Minerals and Melts. III. Controls on Isobaric Melt Production and the Effect of Water on Melt Production. https://app.cochat.ai/papers/10.1093/petroj/40.5.831
- The paper
- Hirschmann, M. M., Asimow, P. D., Ghiorso, M. S., & Stolper, E. M. (1999). Calculation of Peridotite Partial Melting from Thermodynamic Models of Minerals and Melts. III. Controls on Isobaric Melt Production and the Effect of Water on Melt Production. Journal of Petrology. https://doi.org/10.1093/petroj/40.5.831
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.