The DOI matches its Crossref record; 2 of the 2 references it cites were found in a registry or an index.
Calculation of Peridotite Partial Melting from Thermodynamic Models of Minerals and Melts, IV. Adiabatic Decompression and the Composition and Mean Properties of Mid-ocean Ridge Basalts
Abstract
Composition, mean pressure, mean melt fraction, and crustal thickness of model mid-ocean ridge basalts (MORBs) are calculated using MELTS. Polybaric, isentropic batch and fractional melts from ranges in source composition, potential temperature, and final melting pressure are integrated to represent idealized passive and active flow regimes. These MELTS-derived polybaric models are compared with other parameterizations; the results differ both in melt compositions, notably at small melt fractions, and in the solidus curve and melt productivity, as a result of the self-consistent energy balance in MELTS. MELTS predicts a maximum mean melt fraction (∼0·08) and a limit to crustal thickness (≤15 km) for passive flow. For melting to the base of the crust, MELTS requires an ∼200°C global potential temperature range to explain the range of oceanic crustal thickness; conversely, a global range of 60°C implies conductive cooling to ∼50 km. Low near-solidus productivity means that any given crustal thickness requires higher initial pressure in MELTS than in other models. MELTS cannot at present be used to model details of MORB chemistry because of errors in the calibration, particularly Na partitioning. Source heterogeneity cannot explain either global or local Na–Fe systematics or the FeO–K2O/TiO2 correlation but can confound any extent of melting signal in CaO/Al2O3.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
The volume and composition of melt generated by extension of the lithosphere
McKENZIE, D., & BICKLE, M. J. (1988) · Journal of Petrology · doi:10.1093/petrology/29.3.625 · Cited by 2,951 · cited 12×
“Accurate quantitative modeling ofof experimental peridotite melting data (Klein & Lang- muir, 1987; McKenzie & Bickle, 1988; Niu & Batiza, absolute values of compositional variables and phase proportions as functions of pressure, potential tem-1991; Kinzler & Grove, 1992a, 1992b; Langmuir et…”
BackgroundMethodResultInfluentialHirth, G., & Kohlstedt, D. L. (1996) · Earth and Planetary Science Letters · doi:10.1016/0012-821x(96)00154-9 · Cited by 1,599
Cited by
Connolly, J. A. D. (2005) · Earth and Planetary Science Letters · doi:10.1016/j.epsl.2005.04.033 · Cited by 2,246
Temperatures in ambient mantle and plumes: Constraints from basalts, picrites, and komatiites
Herzberg, C., Asimow, P. D., Arndt, N., Niu, Y., Lesher, C. M., Fitton, J. G., Cheadle, M. J., & Saunders, A. D. (2007) · Geochemistry, Geophysics, Geosystems · doi:10.1029/2006gc001390 · Cited by 905
Self-citationGhiorso, M. S., Hirschmann, M. M., Reiners, P. W., & Kress, V. C. (2002) · Geochemistry, Geophysics, Geosystems · doi:10.1029/2001gc000217 · Cited by 891
Mantle solidus: Experimental constraints and the effects of peridotite composition
Hirschmann, M. M. (2000) · Geochemistry, Geophysics, Geosystems · doi:10.1029/2000gc000070 · Cited by 867
NIU, Y. (2004) · Journal of Petrology · doi:10.1093/petrology/egh068 · Cited by 806
Metadata
- Authors
- ASIMOW, P. D.
- Venue
- Journal of Petrology
- Publisher
- Oxford University Press (OUP)
- Published
- 2001-05-01
- Volume
- 42
- Issue
- 5
- Pages
- 963-998
- ISSN
- 0022-3530 (ISSN-L)
- 1460-2415
- OpenAlex
- W2133264142
- Cited by
- 183
- References
- 2
- FWCI
- 5.87
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Calculation of Peridotite Partial Melting from Thermodynamic Models of Minerals and Melts, IV. Adiabatic Decompression and the Composition and Mean Properties of Mid-ocean Ridge Basalts. https://app.cochat.ai/papers/10.1093/petrology/42.5.963
- The paper
- ASIMOW, P. D. (2001). Calculation of Peridotite Partial Melting from Thermodynamic Models of Minerals and Melts, IV. Adiabatic Decompression and the Composition and Mean Properties of Mid-ocean Ridge Basalts. Journal of Petrology. https://doi.org/10.1093/petrology/42.5.963
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.