The DOI matches its Crossref record; 7 of the 7 references it cites were found in a registry or an index.
The Lindemann and Grüneisen Laws
Open accessAbstract
The Lindemann assumption of direct contact of neighboring atoms at fusion is replaced by the criterion that melting occurs when the root-mean-square amplitude of thermal vibration reaches a critical fraction $\ensuremath{\rho}$, presumed the same for all isotropic monatomic solids, of the distance of separation of nearest-neighbor atoms. The Debye-Waller theory of the temperature dependence of the intensity of Bragg reflection of x-rays is used, without further assumptions, to derive a generalized Lindemann law. In contrast to the Lindemann form, all physical quantities involved in this formulation are evaluated at the fusion point, and departure of the average energy of an atomic oscillation from the equipartition value is taken into account by the quantization factor of the Debye-Waller theory. If the Gr\"uneisen constant ${\ensuremath{\gamma}}_{m}$ of the solid at fusion is evaluated by its definition from the Debye frequency of the solid, use of the generalized Lindemann law and Clapeyron's equation permits one to express ${\ensuremath{\gamma}}_{m}$ in terms of the bulk modulus of the solid at melting and the latent heat and volume change of fusion. By means of Gr\"uneisen's law applied to the solid at fusion, ${\ensuremath{\gamma}}_{m}$ can be expressed likewise in terms of the corresponding bulk modulus, thermal expansion, volume, and heat capacity at constant volume; the two evaluations of ${\ensuremath{\gamma}}_{m}$ connect the Lindemann and Gr\"uneisen laws. These relations permit one to evaluate the slope and curvature of a fusion curve as functions of ${\ensuremath{\gamma}}_{m}$, and thus to express in terms of ${\ensuremath{\gamma}}_{m}$ the conditions that a fusion curve be normal in the sense of Bridgman. Experimental fusion data on 13 cubic metals are used to evaluate the constant of proportionality (inversely proportional to $\ensuremath{\rho}$) in the Lindemann frequency; the values are reasonably constant. The corresponding values of $\ensuremath{\rho}$ for Al and Cu show reasonable agreement with values deduced from x-ray intensity measurements. The average $\ensuremath{\rho}$ seems significantly below values estimated by Gr\"uneisen. Good agreement with the cubic metals is found for hexagonal close-packed elements, but not for elements with more complex lattices, in general. The two evaluations of the Gr\"uneisen constant ${\ensuremath{\gamma}}_{m}$ of the solid at fusion are shown to be in good agreement, experimentally, for 14 elements checked, but agreement fails for the elements Ga, Bi, and Sb, which show abnormal fusion curves.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Elasticity and constitution of the Earth's interior
Birch, F. (1952) · Journal of Geophysical Research · doi:10.1029/jz057i002p00227 · Cited by 2,540
Introduction to Chemical Physics
FOWLER, R. H. (1943) · Nature · doi:10.1038/152488a0 · Cited by 811
(1930) · Science · doi:10.1126/science.71.1830.92-a · Cited by 206
The Variation with Temperature of the Principal Elastic Moduli of NaCl near the Melting Point
Hunter, L. P. (1942) · Physical Review · doi:10.1103/physrev.61.84 · Cited by 110
On the vibrational spectrum of at three-dimensiional lattice
Blackman, M. (1937) · Proceedings of the Royal Society of London A Mathematical and Physical Sciences · doi:10.1098/rspa.1937.0081 · Cited by 106
Grüneisen Parameter for a Solid under Finite Strain
Gilvarry, J. J. (1956) · Physical Review · doi:10.1103/physrev.102.331 · Cited by 48
Self-citationGrüneisen's Constant for Some Metals
Gilvarry, J. J. (1955) · The Journal of Chemical Physics · doi:10.1063/1.1740606 · Cited by 33
Self-citation
Cited by
Tight-binding potentials for transition metals and alloys
Cleri, F., & Rosato, V. (1993) · Physical Review B · doi:10.1103/physrevb.48.22 · Cited by 1,940
Lattice instabilities in metallic elements
Grimvall, G., Magyari-Köpe, B., Ozoliņš, V., & Persson, K. A. (2012) · Reviews of Modern Physics · doi:10.1103/revmodphys.84.945 · Cited by 595
Melting and superheating of crystalline solids: From bulk to nanocrystals
Mei, Q. S., & Lu, K. (2007) · Progress in Materials Science · doi:10.1016/j.pmatsci.2007.01.001 · Cited by 592
Eutectics: formation, properties, and applications
Yu, D., Xue, Z., & Mu, T. (2021) · Chemical Society Reviews · doi:10.1039/d1cs00404b · Cited by 351
Pressure-energy correlations in liquids. IV. “Isomorphs” in liquid phase diagrams
Gnan, N., Schrøder, T. B., Pedersen, U. R., Bailey, N. P., & Dyre, J. C. (2009) · The Journal of Chemical Physics · doi:10.1063/1.3265957 · Cited by 336
Metadata
- Authors
- Gilvarry, J. J.
- Venue
- Physical Review
- Publisher
- American Physical Society (APS)
- Published
- 1956-04-15
- Volume
- 102
- Issue
- 2
- Pages
- 308-316
- ISSN
- 0031-899X (ISSN-L)
- OpenAlex
- W2133403032
- Cited by
- 424
- References
- 7
- FWCI
- 15.19
- Type
- journal article
- Language
- en
- Open access
- green
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.