The DOI matches its Crossref record; 6 of the 6 references it cites were found in a registry or an index.
The Evaporation of Atoms, Ions and Electrons from Caesium Films on Tungsten
Abstract
Precision methods for measuring the number of caesium atoms adsorbed on tungsten are described. With these methods for determining $\ensuremath{\theta}$ (the fraction of the tungsten surface covered with Cs), the rates of atom, ion and electron emission are measured as functions of $\ensuremath{\theta}$ and $T$, the filament temperature. The rate of atom evaporation, ${\ensuremath{\nu}}_{a}$, increases rapidly with $\ensuremath{\theta}$ and with $T$. At low filament temperatures and high pressures of Cs vapor the concentration of adsorbed Cs atoms approaches a limit 3.563\ifmmode\times\else\texttimes\fi{}${10}^{14}$ atoms ${\mathrm{cm}}^{\ensuremath{-}2}$ of true filament surface (one Cs atom for four tungsten atoms). This film ($\ensuremath{\theta}=1$) exhibits all the characteristics of a true monatomic layer. The formation of a second layer begins only at filament temperatures corresponding to nearly saturated Cs vapor. A theory of the formation of a second and of polyatomic layers is given and experiments supporting it are described. The heat of evaporation (given by the Clapeyron equation) for Cs atoms from clean tungsten is 2.83 volts (65,140 calories), 1.93 volts or 44,473 calories at $\ensuremath{\theta}=0.67, \mathrm{and} 1.77$ volts or 40,757 calories at $\ensuremath{\theta}\ensuremath{\simeq}1$. The adsorbing tungsten surface after proper aging is homogeneous, except that about 0.5 percent of it (active spots) can hold Cs more firmly than the rest. The procedure in obtaining electron (${\ensuremath{\nu}}_{e}$) and ion (${\ensuremath{\nu}}_{p}$) emission for zero field and the large changes in the effect of external field with $\ensuremath{\theta}$ are described. From both ${\ensuremath{\nu}}_{e}$ and ${\ensuremath{\nu}}_{p}$ the contact potential ${V}_{c}$ is calculated, agreeing, except for very concentrated films, with ${V}_{c}$ calculated entirely from data on neutral atom evaporation. At constant temperature the electron emission increases to a maximum at $\ensuremath{\theta}=0.67$ and decreases as $\ensuremath{\theta}=1$ is approached. The positive ion emission increases rapidly to a maximum at $\ensuremath{\theta}\ensuremath{\simeq}0.01$ and then decreases. The work function (exponent in Dushman type equation) for electrons at $\ensuremath{\theta}=0.67$ is 1.70 volts (clean tungsten=4.62 volts). The work function for ions is 1.91 volts at $\ensuremath{\theta}=0, \mathrm{and} 3.93$ volts at $\ensuremath{\theta}=0.67$. It is shown by experiment that the saturated ion current from a clean hot (1200-1500\ifmmode^\circ\else\textdegree\fi{}K) tungsten filament is an accurate measure (experimental error of about 0.2 percent) of the number of atoms striking the filament per second. The condensation coefficient ($\ensuremath{\alpha}$) for atoms striking a tungsten filament is proved by experiment to be unity from $\ensuremath{\theta}=0$ to nearly 1. The important bearing of this fact and of the experimentally observed existence of surface migration or diffusion on the mechanism of evaporation and condensation in dilute and concentrated films is discussed. In addition surface migration is correlated with irregular ion evaporation rates occurring when two phases (dilute and concentrated films of Cs) exist on the tungsten surface. Transient effects in which $\ensuremath{\theta}$ changes with time are studied and entirely explained by the observed rates of evaporation and condensation. This and other facts are used to justify a surface phase postulate according to which all the properties of the adsorbed film are uniquely determined by $\ensuremath{\theta}$ and $T$.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
The adsorption of gases on plane surfaces of glass, mica and platinum
Langmuir, I. (1918) · Journal of the American Chemical Society · doi:10.1021/ja02242a004 · Cited by 23,242
THE CONSTITUTION AND FUNDAMENTAL PROPERTIES OF SOLIDS AND LIQUIDS. PART I. SOLIDS.
Langmuir, I. (1916) · Journal of the American Chemical Society · doi:10.1021/ja02268a002 · Cited by 9,997
Self-citationJeans, J. (2009) · Cambridge University Press eBooks · doi:10.1017/cbo9780511694370 · Cited by 574
Thermionic Phenomena Caused by Vapors of Rubidium and Potassium
Killian, T. J. (1926) · Physical Review · doi:10.1103/physrev.27.578 · Cited by 187
Contact Potential Measurements with Adsorbed Films
Langmuir, I., & Kingdon, K. H. (1929) · Physical Review · doi:10.1103/physrev.34.129 · Cited by 134
Self-citationThe Condensation and Evaporation of Gas Molecules
Langmuir, I. (1917) · Proceedings of the National Academy of Sciences · doi:10.1073/pnas.3.3.141 · Cited by 51
Self-citation
Cited by
Molecular beam investigation of adsorption kinetics on bulk metal targets: Nitrogen on tungsten
King, D. A., & Wells, M. G. (1972) · Surface Science · doi:10.1016/0039-6028(72)90232-4 · Cited by 709
Metadata
- Authors
- Taylor, J. B., & Langmuir, I.
- Venue
- Physical Review
- Publisher
- American Physical Society (APS)
- Published
- 1933-09-15
- Volume
- 44
- Issue
- 6
- Pages
- 423-458
- ISSN
- 0031-899X (ISSN-L)
- OpenAlex
- W1970342738
- Cited by
- 842
- References
- 6
- FWCI
- 14.35
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.