The DOI matches its Crossref record.
A 1.8-V digital-audio sigma-delta modulator in 0.8-μm CMOS
Abstract
Oversampling techniques based on sigma-delta (/spl Sigma//spl Delta/) modulation offer numerous advantages for the realization of high-resolution analog-to-digital (A/D) converters in low-voltage environment. This paper examines the design and implementation of a CMOS /spl Sigma//spl Delta/ modulator for digital-audio A/D conversion that operates from a single 1.8-V power supply. A cascaded modulator that maintains a large full-scale input range while avoiding signal clipping at internal nodes is introduced. The experimental modulator has been designed with fully differential switched-capacitor integrators employing different input and output common-mode levels and boosted clock drivers in order to facilitate low voltage operation. Precise control of common-mode levels, high power supply noise rejection, and low power dissipation are obtained through the use of two-stage, class A/AB operational amplifiers. At a sampling rate of 4 MHz and an oversampling ratio of 80, an implementation of the modulator in a 0.8-/spl mu/m CMOS technology with metal-to-polycide capacitors and NMOS and PMOS threshold voltages of +0.65 V and -0.75 V, respectively, achieves a dynamic range of 99 dB at a Nyquist conversion rate of 50 kHz. The modulator can operate from supply voltages ranging from 1.5-2.5 V, occupies an active area of 1.5 mm/sup 2/, and dissipates 2.5 mW from a 1.8-V supply.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
Analog-to-digital converter survey and analysis
Walden, R. H. (1999) · IEEE Journal on Selected Areas in Communications · doi:10.1109/49.761034 · Cited by 2,186
Optimal design of a CMOS op-amp via geometric programming
Hershenson, M. D., Boyd, S. P., & Lee, T. H. (2001) · IEEE Transactions on Computer-Aided Design of Integrated Circuits and Systems · doi:10.1109/43.905671 · Cited by 548
Low Voltage, Low Power, Inverter-Based Switched-Capacitor Delta-Sigma Modulator
Chae, Y., & Han, G. (2009) · IEEE Journal of Solid-State Circuits · doi:10.1109/jssc.2008.2010973 · Cited by 333
Digitally Enhanced Software-Defined Radio Receiver Robust to Out-of-Band Interference
Ru, Z., Moseley, N. A., Klumperink, E., & Nauta, B. (2009) · IEEE Journal of Solid-State Circuits · doi:10.1109/jssc.2009.2032272 · Cited by 308
Van Helleputte, N., Konijnenburg, M., Pettine, J., Jee, D.-W., Kim, H., Morgado, A., Van Wegberg, R., Torfs, T., Mohan, R., Breeschoten, A., et al. (2015) · IEEE Journal of Solid-State Circuits · doi:10.1109/jssc.2014.2359962 · Cited by 253
“The second stage operates as class A/AB [19] and helps to drive the by enhancing the slew rate (SR).”
Metadata
- Authors
- Rabii, S., & Wooley, B. A.
- Venue
- IEEE Journal of Solid-State Circuits
- Published
- 1997-06
- Volume
- 32
- Issue
- 6
- Pages
- 783-796
- ISSN
- 0018-9200 (ISSN-L)
- OpenAlex
- W1551666193
- Cited by
- 232
- References
- 0
- FWCI
- 4.63
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.