The DOI matches its Crossref record.
Form and capacitance of parallel-plate capacitors
Abstract
In basic electrostatics, the formula for the capacitance of parallel-plate capacitors is derived, for the case that the spacing between the electrodes is very small compared to the length or width of the plates. However, when the separation is wide, the formula for very small separation does not provide accurate results. In our previously published papers, we used the boundary element method (BEM) to derive formulas for the capacitance of strip and disk capacitors that are applicable even when the separation is large. In this paper, we present results and formulas for the capacitances of square and rectangular capacitors.>
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
In the citing paper
“So, the suggested model from basic electrostatics assuming uniformity of the generated e-field and charge distribution on the conducting plates is not valid (Nishiyama and Nakamura, 1994; Catalan-Izquierdo et al., 2009).”
From Influence of Back Electrostatic Field on the Collection Efficiency of an Electrostatic Lunar Dust Collector (2014) · cites this paper as Nishiyama and Nakamura, 1994
Citations
Cites
No references could be resolved yet.
Research works printed but not linked: 17
- 10.1109/33.56178 · DOI
- 10.1109/33.232065 · DOI
- 10.1007/978-3-642-48860-3 · DOI
- brebbia, 1978, The Boundary Element Method for Engineers
- atkinson, 1989, An Introduction to Numerical Analysis
- nishiyama, 1992, Capacitance of disk capacitors by the boundary element method, Proc First European Conf on Numerical Methods in Engineering, 397
- nishiyama, 1989, Edge correction of strip cpapcitors by the boundary element method, Proc 11th Conf Boundary Element Methods in Engineering, 173
- landau, 0, Electrodynamics of Continuous Media Institute of Physical Problems
- 10.1109/TIM.1979.4314754 · DOI
- 10.1109/33.16649 · DOI
- wheeler, 1983, Transmission line properties of a strip on a dielectric sheet on a plate, IEEE Trans Electron Devices, ed 30, 183
- 10.1002/j.1538-7305.1969.tb04274.x · DOI
- 10.1109/TIM.1985.4315253 · DOI
- 10.1109/TMTT.1971.1127658 · DOI
- 10.1109/TIM.1984.4315224 · DOI
- hayt, 1989, Engineering Elecrtromagnetic
- kirchhoff, 1877, Zur theorie des kondensators, Monatsb Akad Will Berlin, 144
Cited by
Sorted by citations
Afshar-Mohajer, N., Thakker, Y., Wu, C.-Y., & Sorloaica-Hickman, N. (2014) · Aerosol and Air Quality Research · doi:10.4209/aaqr.2013.12.0353 · Cited by 8
“So, the suggested model from basic electrostatics assuming uniformity of the generated e-field and charge distribution on the conducting plates is not valid (Nishiyama and Nakamura, 1994; Catalan-Izquierdo et al. , 2009).”
Metadata
- Authors
- Nishiyama, H., & Nakamura, M.
- Affiliations
- Fujifilm (Japan) (JP)
- Tamagawa University (JP)
- ORCID
- Nakamura, M.
- Venue
- IEEE Transactions on Components, Packaging, and Manufacturing Technology: Part A
- Published
- 1994
- Volume
- 17
- Issue
- 3
- Pages
- 477-484
- ISSN
- 1070-9886 (ISSN-L)
- OpenAlex
- W2143340328
- Cited by
- 144
- References
- 0
- Citations by year
- 2026: 13 · 2025: 9 · 2024: 16 · 2023: 10 · 2022: 10 · 2021: 4 · 2020: 8 · 2019: 12 · 2018: 7 · 2017: 10 · 2016: 8 · 2015: 7 · 2014: 8 · 2013: 4 · 2012: 2
- FWCI
- 0.00
- Type
- journal article
- Language
- en
- Open access
- closed
- Locations
- IEEE Transactions on Components Packaging and Manufacturing Technology Part A (publishedVersion)
- Topics
- Physical Sciences › Physics and Astronomy › Atomic and Molecular Physics, and Optics › Electromagnetic Scattering and Analysis
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Electrical and Electromagnetic Research
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Electromagnetic Simulation and Numerical Methods
- Keywords
- parallel plate capacitor, capacitance, electrode geometry, boundary element method, electrostatics
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
