The DOI matches its Crossref record; 14 of the 14 references it cites were found in a registry or an index.
Switching condition and loss modeling of GaN-based dual active bridge converter for PHEV charger
Abstract
The dual active bridge converter is examined as the DC/DC stage of a battery charger for the plug-in hybrid electric vehicle where both load voltage and load current have very wide operating range. The load current for sinusoidal charging scheme could swing down to zero. To optimize the battery charger under this charging scheme, a DAB loss model over wide load range is needed. Traditional DAB analysis focus on the loss model within the full zero-voltage-switching (ZVS) region where all DAB switches have ZVS. Beyond this region, the switching conditions of the DAB switches are more complicated with mixed states of ZVS, hard-switching (HS), or partial zero-voltage-switching (PZVS). This paper investigates the DAB operating and switching conditions with the consideration of the resonant transition and deatime, and identified the boundaries among hard-switching, partial zero-voltage-switching, and zero-voltage-switching conditions. Based on this, accurate DAB loss model can be derived. The loss model was verified by experimental measurement of a 500 kHz GaN DAB converter.
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Citations
Cites
A three-phase soft-switched high-power-density DC/DC converter for high-power applications
Doncker, R. W. A. A. D., Divan, D. M., & Kheraluwala, M. H. (1991) · IEEE Transactions on Industry Applications · doi:10.1109/28.67533 · Cited by 2,566
Performance characterization of a high-power dual active bridge DC-to-DC converter
Kheraluwala, M. N., Gascoigne, R. W., Divan, D. M., & Baumann, E. D. (1992) · IEEE Transactions on Industry Applications · doi:10.1109/28.175280 · Cited by 1,502
Closed Form Solution for Minimum Conduction Loss Modulation of DAB Converters
Krismer, F., & Kolar, J. W. (2011) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2011.2157976 · Cited by 635
Optimal ZVS Modulation of Single-Phase Single-Stage Bidirectional DAB AC–DC Converters
Everts, J., Krismer, F., den Keybus, J. V., Driesen, J., & Kolar, J. W. (2014) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2013.2292026 · Cited by 508
Xue, L. L., Shen, Z., Boroyevich, D., Mattavelli, P., & Diaz, D. (2015) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2015.2413815 · Cited by 423
Self-citationNew Core Loss Measurement Method for High-Frequency Magnetic Materials
Mu, M., Li, Q., Gilham, D. J., et al. (2013) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2013.2286830 · Cited by 243
Modeling and optimization of bidirectional dual active bridge DC-DC converter topologies
Krismer, F. (2010) · Repository for Publications and Research Data (ETH Zurich) · doi:10.3929/ethz-a-006395373 · Cited by 232
Extending the ZVS operating range of dual active bridge high-power DC-DC converters
Oggier, G. G., Leidhold, R., García, G. O., Oliva, A., Balda, J. C., & Barlow, F. (2006) · IEEE Power Electronics Specialists Conference (PESC) · doi:10.1109/pesc.2006.1712142 · Cited by 169
GaN-FET based dual active bridge DC-DC converter
Costinett, D. J., Nguyen, H., Zane, R. A., et al. (2011) · Conference proceedings/Conference proceedings - IEEE Applied Power Electronics Conference and Exposition · doi:10.1109/apec.2011.5744779 · Cited by 111
An adaptive dead-time control scheme for high-switching-frequency dual-active-bridge converter
Li, J., Chen, Z., Shen, Z., et al. (2012) · Conference proceedings/Conference proceedings - IEEE Applied Power Electronics Conference and Exposition · doi:10.1109/apec.2012.6165996 · Cited by 67
Xue, L. L., Mu, M., Boroyevich, D., et al. (2015) · IEEE Applied Power Electronics Conference and Exposition (APEC) · doi:10.1109/apec.2015.7104411 · Cited by 50
Self-citationXue, L. L., Diaz, D., Shen, Z., et al. (2013) · Conference proceedings/Conference proceedings - IEEE Applied Power Electronics Conference and Exposition · doi:10.1109/apec.2013.6520557 · Cited by 38
Self-citationBi-directional PHEV battery charger based on normally-off GaN-on-Si multi-chip module
Xue, L. L., Shen, Z., Mu, M., et al. (2014) · IEEE Applied Power Electronics Conference and Exposition (APEC) · doi:10.1109/apec.2014.6803529 · Cited by 33
Self-citationEfficiency optimized AC charging waveform for GaN bidirectional PHEV Battery Charger
Xue, L. L., Mattavelli, P., Boroyevich, D., et al. (2014) · European Conference on Power Electronics and Applications · doi:10.1109/epe.2014.6910869 · Cited by 4
Self-citation
Cited by
Sorted by citations
He, P., & Khaligh, A. (2017) · IEEE Transactions on Transportation Electrification · doi:10.1109/tte.2016.2630927 · Cited by 501
A Review of Bidirectional On-Board Chargers for Electric Vehicles
Yuan, J., Dorn-Gomba, L., Callegaro, A. D., Reimers, J., & Emadi, A. (2021) · IEEE Access · doi:10.1109/access.2021.3069448 · Cited by 390
Metadata
- Authors
- Xue, L., Boroyevich, D., & Mattavelli, P.
- Affiliations
- Virginia Tech (US)
- University of Padua (IT)
- Venue
- 2016 IEEE Applied Power Electronics Conference and Exposition (APEC)
- Publisher
- IEEE
- Published
- 2016-03
- Pages
- 1315-1322
- ISSN
- 1048-2334 (ISSN-L)
- OpenAlex
- W2397615492
- Cited by
- 28
- References
- 14
- Citations by year
- 2026: 2 · 2025: 2 · 2022: 2 · 2021: 4 · 2020: 8 · 2018: 3 · 2017: 5 · 2016: 2
- FWCI
- 4.69
- Type
- conference paper
- Language
- en
- Open access
- closed
- Locations
- Conference proceedings/Conference proceedings - IEEE Applied Power Electronics Conference and Exposition (publishedVersion)
- Padua Research Archive (University of Padova) (submittedVersion)
- Topics
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Advanced DC-DC Converters
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Wireless Power Transfer Systems
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Electromagnetic Compatibility and Noise Suppression
- Keywords
- dual active bridge converter, GaN switches, DC-DC converter, switching conditions, hard switching, zero-voltage switching, resonance transitions, wide load range
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
