The DOI matches its Crossref record.
Bending Fatigue Study of Sputtered ITO on Flexible Substrate
Abstract
Recently, there has been a tremendous rise in production of portable electronic devices. To produce flexible devices, flexible substrates should replace conventional glass substrates. Indium-tin-oxide (ITO) is the preferred transparent conducting layer used in the display technology. Although ITO has excellent sheet resistance and very good optical properties, ITO can crack at very low tensile strains which might cause failure in the conductive layer because of the unusual structure of a very thin film of brittle ceramic material applied to a polymer substrate. Therefore, the mechanics of ITO on flexible substrates has been thoroughly considered in the design and manufacturing of flexible devices. In a typical roll-to-roll manufacturing process, many challenges exist during the travel of the coated web over the rollers which produce bending stresses that might cause failure even if the stresses are below the yield strength of the material. Therefore, the high cycle bending fatigue of ITO thin films on flexible substrates is of a significant importance. In this work, high cycle bending fatigue experiments were conducted on ITO coated PET substrate. The effect of bending diameter, bending frequency, and sample width on the change in electrical resistance was investigated. High magnification images were obtained to observe crack initiation and propagating in the ITO layer. The goal of this work is to establish a baseline for a comprehensive reliability study of ITO thin films on flexible substrate. It was found that bending diameters as well as the number of bending cycles have a great influence on the electrical conductivity of the ITO layer.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
The Role of Graphene and Other 2D Materials in Solar Photovoltaics
Das, S., Pandey, D., Thomas, J., & Roy, T. (2019) · Advanced Materials · doi:10.1002/adma.201802722 · Cited by 449
Harris, K. D., Elias, A. L., & Chung, H.-J. (2016) · Journal of Materials Science · doi:10.1007/s10853-015-9643-3 · Cited by 403
Chemical formation of soft metal electrodes for flexible and wearable electronics
Wang, D., Zhang, Y., Lu, X., Ma, Z., Xie, C., & Zheng, Z. (2018) · Chemical Society Reviews · doi:10.1039/c7cs00192d · Cited by 307
Failure criterion of silver nanowire electrodes on a polymer substrate for highly flexible devices
Kim, D., Kim, S.-H., Kim, J. H., Lee, J.-C., Ahn, J.-P., & Kim, S. W. (2017) · Scientific Reports · doi:10.1038/srep45903 · Cited by 32
Metadata
- Authors
- Alzoubi, K., Hamasha, M. M., Lu, S., & Sammakia, B.
- Venue
- Journal of Display Technology
- Published
- 2011-11
- Volume
- 7
- Issue
- 11
- Pages
- 593-600
- ISSN
- 1551-319X (ISSN-L)
- 1558-9323
- OpenAlex
- W2107344115
- Cited by
- 210
- References
- 0
- FWCI
- 18.35
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Bending Fatigue Study of Sputtered ITO on Flexible Substrate. https://app.cochat.ai/papers/10.1109/jdt.2011.2151830
- The paper
- Alzoubi, K., Hamasha, M. M., Lu, S., & Sammakia, B. (2011). Bending Fatigue Study of Sputtered ITO on Flexible Substrate. Journal of Display Technology. https://doi.org/10.1109/jdt.2011.2151830
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.