Future railway services-oriented mobile communications network
The DOI matches its Crossref record; 9 of the 9 references it cites were found in a registry or an index.
Abstract
The future development of the railway is highly desired to evolve into a new era where infrastructure, trains, travelers, and goods will be increasingly interconnected to provide high comfort, with optimized door-to-door mobility at higher safety. For this vision, it is required to realize seamless high data rate wireless connectivity for railways. To improve the safety and comfort of future railways, wireless communications for railways are required to evolve from only voice and traditional train control signaling services to various high data rate services including critical high-definition (HD) video and other more bandwidth-intensive passenger services, such as onboard and wayside HD video surveillance, onboard real-time high data rate services, train multimedia dispatching video streaming, railway mobile ticketing, and the Internet of Things for railways. Corresponding mobile communications network architecture under various railway scenarios including inter-car, intra-car, inside station, train-to-infrastructure and infrastructure- to-infrastructure are proposed in this article. Wireless coverage based on massive MIMO for railway stations and train cars is proposed to fulfill the requirement of high-data-rate and high spectrum efficiency. The technical challenges brought by the massive MIMO technique are discussed as well.
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
In the citing paper
“Wireless communications and optical fiber can both be employed for inter-car communications. Nevertheless, the latter is less advised since it may be costly to wire a train for network access, and rewiring may be necessary each time the train is reconfigured [3].”
From Towards the Internet of Smart Trains: A Review on Industrial IoT-Connected Railways (2017) · cites this paper as [3]
In the citing paper
“These links must be bidirectional, with high data rates and latencies lower than 100 ms while traveling at speeds up to 350 km/h or even higher [3]. Jointly with an availability of 98–99% mandatory to comply with Reliability, Availability, Maintainability and Safety (RAMS) requirements.”
From Towards the Internet of Smart Trains: A Review on Industrial IoT-Connected Railways (2017) · cites this paper as [3]
In the citing paper
“For instance, massive Multiple-Input Multiple-Output (MIMO) and 3D beamforming may be used with many users to enhance the system capacity [3].”
From Towards the Internet of Smart Trains: A Review on Industrial IoT-Connected Railways (2017) · cites this paper as [3]
Citations
Cites
Noncooperative Cellular Wireless with Unlimited Numbers of Base Station Antennas
Marzetta, T. L. (2010) · IEEE Transactions on Wireless Communications · doi:10.1109/twc.2010.092810.091092 · Cited by 6,302 · cited 1×
“In the railway station and inside the car, where the transmission rate and system capacity need to be improved, massive MIMO can be used, which has been proved theoretically to achieve high data rate, high spectral efficiency, and high energy efficiency [7].”
MethodChallenges Toward Wireless Communications for High-Speed Railway
Ai, B., Briso-Rodriguez, C., Cheng, X., Kurner, T., Zhong, Z.-D., Guan, K., He, R.-S., Xiong, L., Matolak, D. W., & Michelson, D. G. (2014) · IEEE Transactions on Intelligent Transportation Systems · doi:10.1109/tits.2014.2310771 · Cited by 498 · cited 2×
“However, 7.2 GHz bandwidth may be demanded for HD video services.”
BackgroundInfluentialSelf-citationAssessment of LTE-R Using High Speed Railway Channel Model
Guan, K., Zhong, Z., & Ai, B. (2011) · 2011 Third International Conference on Communications and Mobile Computing · doi:10.1109/cmc.2011.34 · Cited by 111 · cited 1×
“With the increasing demand for new railway services such as railway multimedia dispatching communication and railway emergency communication, Long Term Evolution for Railway (LTE-R) is now under discussion [1, 2].”
BackgroundSelf-citationPushing the Limits of LTE: A Survey on Research Enhancing the Standard
Schwarz, Š., Ikuno, J. C., Šimko, M., Taranetz, M., Wang, Q., & Rupp, M. (2013) · IEEE Access · doi:10.1109/access.2013.2260371 · Cited by 65 · cited 1×
“Once the models agree, the system-level models can easily be scaled to hundreds of users, higher bandwidth and longer transmit durations with high likelihood to correctly resemble such behavior [10].”
BackgroundSelf-citationThroughput Maximizing Multiuser Scheduling with Adjustable Fairness
Schwarz, Š., Mehlführer, C., & Rupp, M. (2011) · International Conference on Communications · doi:10.1109/icc.2011.5963489 · Cited by 65
Self-citationA Novel Link Error Prediction Model for OFDM Systems with HARQ
Ikuno, J. C., Mehlführer, C., & Rupp, M. (2011) · International Conference on Communications · doi:10.1109/icc.2011.5962464 · Cited by 32 · cited 2×
“Classical hybrid automatic repeat request (HARQ) methods [11] may not work as expected due to high speeds.”
BackgroundSelf-citationPredictive Quantization on the Stiefel Manifold
Schwarz, Š., & Rupp, M. (2014) · IEEE Signal Processing Letters · doi:10.1109/lsp.2014.2354258 · Cited by 23 · cited 1×
“Theoretically, sufficient (quantized) feedback information is required in order to guarantee high data rate transmissions [12].”
BackgroundSelf-citationSocial Network Services for Rail Traffic Applications
Ai, B., Cheng, X., Yang, L., Zhong, Z.-D., Ding, J.-W., & Song, H. (2014) · IEEE Intelligent Systems · doi:10.1109/mis.2014.101 · Cited by 22 · cited 1×
“High-speed railway (HSR), intercity railway, subway, light rail, and other rail traffic systems have brought much convenience for people’s travel with less energy consumption and air pollution compared to cars and airplanes.”
BackgroundSelf-citationWireless relay networks using multiple frequency bands
Kikkawa, T., & Sanada, Y. (2010) · doi:10.1109/isita.2010.5649017 · Cited by 1 · cited 1×
“By using the multihop technique at different frequency bands [8], higher frequency bands can be used inside the car for large bandwidth wireless coverage.”
Method
Research works printed but not linked: 4
- 2013, Scenarios, Requirements and KPls for 5G Mobile and Wireless System, METIS project Deliv D1 1
- zhong, 2009, Fundamental Theory of GSM-P Wireless Networks Beijing Jiaotong Univ Publishing House
- 2014, 11. Smart, Green and Integrated Transport Revised, EC Decision C, Horizon 2020 Work Programme, 4995, 2014
- 2014, Technical Specification Group Radio Access Network: Study on 3D Channel Model for LTE, 3GPP Release 12 V12 0 0
Cited by
A Survey of 5G Channel Measurements and Models
Wang, C.-X., Bian, J., Sun, J., Zhang, W., & Zhang, M. (2018) · IEEE Communications Surveys & Tutorials · doi:10.1109/comst.2018.2862141 · Cited by 594
“HST scenario is assumed to be one of the typical scenarios for 5G systems [2], [137].”
BackgroundHe, D., Ai, B., Guan, K., Wang, L., Zhong, Z., & Kürner, T. (2019) · IEEE Communications Surveys & Tutorials · doi:10.1109/comst.2018.2865724 · Cited by 422
“New network architectures are proposed for various applications [19]–[21].”
Self-citation5G Key Technologies for Smart Railways
Ai, B., Molisch, A. F., Rupp, M., & Zhong, Z.-D. (2020) · Proceedings of the IEEE · doi:10.1109/jproc.2020.2988595 · Cited by 357
“The feasibility of using massive MIMO in several HSR scenarios has been investigated in [126].”
MethodSelf-citationTowards the Internet of Smart Trains: A Review on Industrial IoT-Connected Railways
Fraga-Lamas, P., Fernández-Caramés, T., & Castedo, L. (2017) · Sensors · doi:10.3390/s17061457 · Cited by 267
“For instance, massive Multiple-Input Multiple-Output (MIMO) and 3D beamforming may be used with many users to enhance the system capacity [3].”
BackgroundInfluentialHuang, J., Wang, C.-X., Feng, R., Sun, J., Zhang, W., & Yang, Y. (2017) · IEEE Journal on Selected Areas in Communications · doi:10.1109/jsac.2017.2699381 · Cited by 241
“The systems also have advantages in terms of compact dimensions, energy efficiency, flexibility, and adaptivity that would make them ideally suited for 5G communication systems [29]–[32] including high-speed railway systems [33], [34].”
Background
Metadata
- Authors
- Ai, B., Guan, K., Rupp, M., Kurner, T., Cheng, X., Yin, X.-F., Wang, Q., Ma, G.-Y., Li, Y., Xiong, L., & Ding, J.-W.
- Affiliations
- Beijing Jiaotong University (CN)
- TU Wien (AT)
- Peking University (CN)
- Venue
- IEEE Communications Magazine
- Published
- 2015-10
- Volume
- 53
- Issue
- 10
- Pages
- 78-85
- ISSN
- 0163-6804 (ISSN-L)
- 1558-1896
- OpenAlex
- W1946587052
- Cited by
- 224
- References
- 9
- Citations by year
- 2026: 3 · 2025: 9 · 2024: 10 · 2023: 12 · 2022: 13 · 2021: 18 · 2020: 31 · 2019: 32 · 2018: 33 · 2017: 39 · 2016: 23 · 2015: 1
- FWCI
- 15.41
- Type
- journal article
- Language
- en
- Open access
- closed
- Locations
- IEEE Communications Magazine (publishedVersion)
- Topics
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Advanced MIMO Systems Optimization
- Physical Sciences › Engineering › Media Technology › Telecommunications and Broadcasting Technologies
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Millimeter-Wave Propagation and Modeling
- Keywords
- railway communication, massive MIMO, railway stations, spectral efficiency, railway safety, passenger service
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.