Integrated Three-Port Converter for Solar-Charged Electric Vehicle Applications
The DOI matches its Crossref record; 26 of the 26 references it cites were found in a registry or an index.
Abstract
Adding onboard solar generation to electric vehicles (EVs) is one way to help reduce their charging needs and/or increase their driving range. To maximize the potential benefit, differential power processing (DPP) converters can be implemented to maximize solar energy capture in partial shading conditions. Furthermore, an isolated high step-up converter is required to transfer solar energy to the high-voltage battery, and a buck converter is useful to create an efficient direct path from the solar cells to the low-voltage accessory bus. If implementing these power electronic requirements with separate converters, the component count is high and power density can suffer. Thus, this article proposes the first multiport converter with solar DPP, an isolated high-voltage output port, and a low-voltage port, which is uniquely suited for solar-charged EVs. The switch count is low, and a simple control strategy is proposed to allow separate control of the two output ports. A 200-W experimental prototype is built and tested and shows a peak efficiency of 96.7% when solar power is flowing to both the high-voltage and low-voltage ports.
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Citations
Cites
Cd-Free Cu(In,Ga)(Se,S)2 Thin-Film Solar Cell With Record Efficiency of 23.35%
Nakamura, M., Yamaguchi, K., Kimoto, Y., Yasaki, Y., Kato, T., & Sugimoto, H. (2019) · IEEE Journal of Photovoltaics · doi:10.1109/jphotov.2019.2937218 · Cited by 1,323
Resonant Switched-Capacitor Converters for Sub-module Distributed Photovoltaic Power Management
Stauth, J. T., Seeman, M. D., & Kesarwani, K. (2013) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2012.2206056 · Cited by 287
A PWM and PFM Hybrid Modulated Three-Port Converter for a Standalone PV/Battery Power System
Sun, X., Shen, Y., Li, W., & Wu, H. (2015) · IEEE Journal of Emerging and Selected Topics in Power Electronics · doi:10.1109/jestpe.2015.2424718 · Cited by 144
Poshtkouhi, S., Palaniappan, V., Fard, M., et al. (2011) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2011.2173353 · Cited by 144
Enhancing Microinverter Energy Capture With Submodule Differential Power Processing
Qin, S., Barth, C. B., & Pilawa-Podgurski, R. C. N. (2015) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2015.2464235 · Cited by 131
Zhang, J., Wu, H., Qin, X., & Xing, Y. (2015) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2015.2448696 · Cited by 128
Uno, M., & Sugiyama, K. (2018) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2018.2828984 · Cited by 115
Mobarak, M. H., Kleiman, R. N., & Bauman, J. (2021) · IEEE Transactions on Transportation Electrification · doi:10.1109/tte.2020.2996363 · Cited by 104 · cited 1×
“By modeling the effect of adding PV cells to all upwards-facing vehicle surfaces, Mobarak et al. [3] showed that on average, such a large-scale solar EV (SEV) could reduce annual net vehicle energy consumption by 21.5% in Los Angeles and 17.5% in De-troit.”
BackgroundInfluentialSelf-citationUno, M., & Kukita, A. (2014) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2014.2331456 · Cited by 101
Capacitor-Less Photovoltaic Cell-Level Power Balancing using Diffusion Charge Redistribution
Chang, A. H., Avestruz, A.-T., & Leeb, S. B. (2014) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2014.2340403 · Cited by 85
Cited by
Sunny, A. C., & Debnath, D. (2024) · IEEE Journal of Emerging and Selected Topics in Industrial Electronics · doi:10.1109/jestie.2024.3392776 · Cited by 14
“In partially isolated converters (PICs), one of the ports (usually the load port) is isolated using a high-frequency trans-former [34], [35], [36], [37], [38], [39], [40], [41], [42], [43], [44], [45], [46], [47], [48].”
BackgroundChanu, L. N., & Subramanian, B. (2025) · IEEE Access · doi:10.1109/access.2025.3603687 · Cited by 10
“However, differential power processing is overlooked in [139] and adopted in [140] to maximize solar power during partial shading conditions for PV-EV charging applications.”
Gupta, A., & Joshi, D. (2024) · International Journal of Circuit Theory and Applications · doi:10.1002/cta.4234 · Cited by 9
“The researchers 5,19,21,22,27 – 29 have proposed numerous non-isolated multiport converters, emphasizing the need for more efficient and cost-effective solutions for hybrid renewable energy systems as shown in Table 1.”
V2G and G2V Modes of Grid-Connected Solar EV Battery Charger with Harmonic Compensation
Bhargav, A., & Sarkar, I. (2024) · IEEE International Conference on Sustainable Energy and Future Electric Transportation (SEFET) · doi:10.1109/sefet61574.2024.10718240 · Cited by 6
“To overcome the above issues, the authors in [10] have implemented an isolated unidirectional EV charging system.”
MethodPerformance assessment of solar-powered electric vehicles integrated with a novel DC converter
Xiong, B., Ma, X., Xue, L., et al. (2026) · Energy · doi:10.1016/j.energy.2026.140983 · Cited by 3
Metadata
- Authors
- Sadeghpour, D., & Bauman, J.
- Affiliations
- McMaster University (CA)
- Venue
- IEEE Transactions on Industrial Electronics
- Published
- 2024-07
- Volume
- 71
- Issue
- 7
- Pages
- 6907-6917
- ISSN
- 0278-0046 (ISSN-L)
- 1557-9948
- OpenAlex
- W4385834100
- Cited by
- 18
- References
- 26
- Citations by year
- 2026: 6 · 2025: 8 · 2024: 4
- FWCI
- 1.33
- Type
- journal article
- Language
- en
- Open access
- closed
- Licence
- Locations
- IEEE Transactions on Industrial Electronics (publishedVersion)
- Funders
- Natural Sciences and Engineering Research Council of Canada
- Topics
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Advanced DC-DC Converters
- Physical Sciences › Energy › Renewable Energy, Sustainability and the Environment › Photovoltaic System Optimization Techniques
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Multilevel Inverters and Converters
- Keywords
- three-port converter, electric vehicles, differential power processing, partial shading, high step-up DC-DC converter, buck converter, multiport converter, isolated converter, power density, switch count reduction, high-voltage battery charging
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Integrated Three-Port Converter for Solar-Charged Electric Vehicle Applications. https://app.cochat.ai/papers/10.1109/tie.2023.3301520
- The paper
- Sadeghpour, D., & Bauman, J. (2024). Integrated Three-Port Converter for Solar-Charged Electric Vehicle Applications. IEEE Transactions on Industrial Electronics. https://doi.org/10.1109/tie.2023.3301520
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.