Optimal Selection of the Average Capacitor Voltage for Variable-Speed Drives With Modular Multilevel Converters
Open accessThe DOI matches its Crossref record; 2 of the 2 references it cites were found in a registry or an index.
Abstract
Variable-speed drives have reduced voltage requirements when operating below the base speed. In a modular-multilevel-converter-based (M2C-based) motor drive, it is then possible to operate with reduced voltage in the submodule capacitors, than at the base speed. In this sense, a greater capacitor-voltage ripple can be accommodated, without exceeding the maximum peak-capacitor voltage. This paper presents an analytical investigation for the optimal selection of the average capacitor voltage for M2Cs, when the motor is operating with rated torque, below the base speed. This method does not require any power exchange between the converter arms, so it keeps the conduction losses at the minimum level. Additionally, the method decreases the switching losses, due to the decreased capacitor-voltage level. The overall ratings of the converter remain the same as in the base-speed operation. It is shown that this method can be applied at a speed range between the base speed and down to approximately one third of it, i.e., an operating range that covers the requirements for typical pump- and fan-type applications. The results obtained from the analytical investigation are experimentally verified on a down-scaled laboratory prototype M2C.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
A New AC/AC Multilevel Converter Family
Glinka, M., & Marquardt, R. (2005) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2005.843973 · Cited by 772 · cited 1×
“1, was first presented by Marquardt and Lesnicar [1], [2], and has recently attracted a lot of interest in various applications [3]–[8].”
BackgroundIlves, K., Antonopoulos, A., Harnefors, L., Norrga, S., Angquist, L., & Nee, H.-P. (2011) · IECON 2011 - 37th Annual Conference of the IEEE Industrial Electronics Society · doi:10.1109/iecon.2011.6120033 · Cited by 112
Self-citation
Cited by
Li, B., Zhou, S., Xu, D., Yang, R., Xu, D., Buccella, C., & Cecati, C. (2016) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2016.2547899 · Cited by 208
“The Authors of [22] presented another interesting control method for variable speed drives by decreasing the average voltage of the SM capacitors at low output frequencies.”
MethodDu, S., Wu, B., & Zargari, N. R. (2018) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2017.2740782 · Cited by 56
Tai, B., Gao, C., Liu, X., & Chen, Z. (2017) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2016.2535463 · Cited by 46
Zhou, S., Li, B., Guan, M., Zhang, X., Xu, Z., & Xu, D. (2019) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2018.2833503 · Cited by 38
Fehr, H., & Gensior, A. (2018) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2018.2805103 · Cited by 17
Metadata
- Authors
- Antonopoulos, A., Angquist, L., Harnefors, L., & Nee, H.-P.
- Venue
- IEEE Transactions on Power Electronics
- Published
- 2015-01
- Volume
- 30
- Issue
- 1
- Pages
- 227-234
- ISSN
- 0885-8993 (ISSN-L)
- 1941-0107
- OpenAlex
- W2021770508
- Cited by
- 112
- References
- 2
- FWCI
- 7.25
- Type
- journal article
- Language
- en
- Open access
- green
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.