The DOI matches its Crossref record.
A Comparison of Ethanol and Butanol as Oxygenates Using a Direct-Injection, Spark-Ignition (DISI) Engine
Abstract
This study was designed to evaluate a ‘what-if’ scenario in terms of using butanol as an oxygenate, in place of ethanol in an engine calibrated for gasoline operation. No changes to the stock engine calibration were performed for this study. Combustion analysis, efficiency and emissions of pure gasoline, 10% ethanol and 10% butanol blends in a modern, direct-injection four-cylinder, spark ignition engine were analyzed. Data was taken at engine speeds of 1000 RPM up to 4000 RPM with load varying from 0 Nm (idle) to 150 Nm. Relatively minor differences existed between the three fuels for the combustion characteristics such as heat release rate, 50% mass fraction burned, and coefficient of variation of indicated mean effective pressure at low and medium engine loads. However at high engine loads the reduced knock resistance of the butanol blend forced the engine control unit to retard the ignition timing substantially, compared to the gasoline baseline and even more pronounced compared to the ethanol blend. Brake specific volumetric fuel consumption which represented a normalized volumetric fuel flow rate, was lowest for the gasoline baseline fuel, due to the higher energy density. The 10% butanol blend had a lower volumetric fuel consumption compared to the ethanol blend, as expected based on energy density differences. Results showed little difference in regulated emissions between 10% ethanol and 10% butanol. The ethanol blend produced the highest peak specific NOx due to the high octane rating of ethanol and effective anti-knock characteristics. Overall, the ability of butanol to perform equally as well as ethanol from an emissions and combustion standpoint, with a decrease in fuel consumption, initially appears promising. Further experiments are planned to explore the full operating range of the engine and the potential benefits of higher blend ratios of butanol.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
Sarathy, S. M., Oßwald, P., Hansen, N., & Kohse-Höinghaus, K. (2014) · Progress in Energy and Combustion Science · doi:10.1016/j.pecs.2014.04.003 · Cited by 911
Hong, K.-K., & Nielsen, J. (2012) · Cellular and Molecular Life Sciences · doi:10.1007/s00018-012-0945-1 · Cited by 451
Karthick, C., & Nanthagopal, K. (2021) · Energy Conversion and Management · doi:10.1016/j.enconman.2021.114219 · Cited by 78
Karavalakis, G., Short, D., Hajbabaei, M., Vu, D., Villela, M., Russell, R., Durbin, T., & Asa-Awuku, A. (2013) · SAE Technical Paper Series · doi:10.4271/2013-01-1147 · Cited by 21
Metadata
- Authors
- Wallner, T., Miers, S. A., & McConnell, S.
- Venue
- ASME 2008 Internal Combustion Engine Division Spring Technical Conference
- Publisher
- ASMEDC
- Published
- 2008-01-01
- Pages
- 129-139
- OpenAlex
- W2031627010
- Cited by
- 176
- References
- 0
- FWCI
- 18.17
- Type
- conference paper
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: A Comparison of Ethanol and Butanol as Oxygenates Using a Direct-Injection, Spark-Ignition (DISI) Engine. https://app.cochat.ai/papers/10.1115/ices2008-1690
- The paper
- Wallner, T., Miers, S. A., & McConnell, S. (2008). A Comparison of Ethanol and Butanol as Oxygenates Using a Direct-Injection, Spark-Ignition (DISI) Engine. ASME 2008 Internal Combustion Engine Division Spring Technical Conference. https://doi.org/10.1115/ices2008-1690
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.