The DOI matches its Crossref record; 1 of the 1 references it cites were found in a registry or an index.
PCR in a Rayleigh-Bénard Convection Cell
Abstract
Rayleigh-Benard convection is caused by buoyancy-driven instability in a confined fluid layer heated from below ([1][1]). The dimensionless Rayleigh number Ra = g α( T 2 − T 1) h 3/νκ expresses the interplay between buoyant forces driving the instability and diffusive restoring forces acting in opposition. Here, α is the coefficient of thermal expansion of the fluid, g is the acceleration due to gravity, T 1 and T 2 are the temperatures of the top and bottom surfaces of the cavity, respectively, h is the height of the cavity, ν is the kinematic viscosity, and κ is the thermal diffusivity. The inherent structure of Rayleigh-Benard convection—steady circulatory flow between surfaces maintained at two fixed temperatures—is ideally suited for performing thermally activated chemical reactions that require temperature cycling. We have developed a device that uses Rayleigh-Benard convection to perform polymerase chain reaction (PCR) amplification of DNA inside a 35-μl cylindrical cavity. Instead of the external temperature control of conventional thermocyclers, temperature cycling is achieved as the flow field continually shuttles fluid packets vertically through the temperature zones associated with denaturation (≈95°C) and annealing/extension (60° to 70°C). The steady circulatory flow field must engage the entire reaction volume yet be slow enough to allow the reaction within each temperature zone to reach completion. The parameters available to control the fluid motion are the Rayleigh number and the aspect ratio h / d , where d is the diameter of the cavity. In the case of PCR, the required reaction efficiency constrains the reaction solution and the temperature difference; thus, Ra can only be changed by varying the height of the cavity, leaving geometry as the primary flow control parameter. We constructed a series of Rayleigh-Benard convection cells by drilling holes in Plexiglas cubes ([Fig. 1][2]A) and imaged the resulting flow patterns by recording the motion of an aqueous suspension of fluorescent latex microspheres ([Fig. 1][2]B). At values of Ra on the order of 105, the convective motion is characterized by steady flow within a single well-defined axisymmetric cellular pattern. Increasing Ra to the vicinity of 106 while holding h / d constant causes the flow velocity to increase, ultimately inducing a transition to an unsteady flow regime. Holding Ra constant in the vicinity of 106 while increasing h / d reverses the unsteady flow transition and restores uniform convective motion. These observations are in qualitative agreement with the results of Muller and co-workers ([2][3]) and suggest a considerable amount of tunability to accommodate a variety of reaction conditions and reagent volumes. ![Figure 1][4] Figure 1 ( A ) RB-PCR cell schematic. ( B ) Influence of geometry on Rayleigh-Benard convection ( 5 ). (i) h / d = 3.3, Ra = 4.6 x 105; steady circulatory convective flow between the top and bottom of the cavity. (ii) h / d = 3.3, Ra = 3.7 × 106; unsteady “figure-8” convective flow pattern. (iii) h / d = 6.3, Ra = 3.7 × 106; steady convective flow is reestablished at the same value of Ra as in (ii). ( C ) DNA amplification in RB-PCR cell. (i) Amplification with 0.1 U/μl Ampli-Taq Polymerase. Lane 1, 100-bp ladder; lane 2, RB-PCR product; lane 3, PCR product generated in a thermocycler using two-temperature cycling (denature: 95°C; anneal: 61°C, 40 cycles). (ii) Negative control with no template. Lane 1, RB-PCR product; lane 2, thermocycler product. (iii) Negative control with no enzyme. Lane 1, RB-PCR product; lane 2, thermocycler product. (iv) Amplification with 0.15 U/μL AmpliTaq Polymerase. Lane 1, 50-bp ladder; lane 2, RB-PCR product; lane 3, thermocycler product. The additional high-migrating band appears in all template-containing reactions and controls ( 6 ). On the basis of flow visualization studies in a number of geometries, we selected cavities 1.5 cm in height with h / d ≈ 10 for PCR experiments. Convective flow was generated with top and bottom surfaces of the cavity maintained at 61°C and 97°C, respectively ([3][5]). About 9 ng/μl of human DNA template was used, and the target was a 295–base pair (bp) fragment of the single-copy β-Actin gene. As shown in [Fig. 1][2]C, the Rayleigh-Benard PCR (RB-PCR) cell produces an amplification product of the correct size and compares well with the PCR product generated in a thermocycler under similar temperature conditions. In addition to enzyme concentration, the reaction is sensitive to incubation time and the temperature at the top surface of the cell. The RB-PCR system is exceedingly simple and may be easily assembled in any laboratory. The potential versatility of this system may be further enhanced through improved characterization of convective flow fields in high aspect ratio cavities and studies to optimize PCR in flowing systems. 1. [↵][6]S. Chandrasekhar, Hydrodynamic and Hydromagnetic Stability (Clarendon, Oxford, 1961). 2
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Rate of depurination of native deoxyribonucleic acid
Lindahl, T., & Nyberg, B. (1972) · Biochemistry · doi:10.1021/bi00769a018 · Cited by 1,556
Cited by
Microfluidics: Fluid physics at the nanoliter scale
Squires, T. M., & Quake, S. R. (2005) · Reviews of Modern Physics · doi:10.1103/revmodphys.77.977 · Cited by 4,379
Control and detection of chemical reactions in microfluidic systems
deMello, A. J. (2006) · Nature · doi:10.1038/nature05062 · Cited by 1,495
Lab-on-a-chip devices for global health: Past studies and future opportunities
Chin, C. D., Linder, V., & Sia, S. K. (2007) · Lab Chip · doi:10.1039/b611455e · Cited by 811
PCR microfluidic devices for DNA amplification
Zhang, C., Xu, J., Ma, W., & Zheng, W. (2006) · Biotechnology Advances · doi:10.1016/j.biotechadv.2005.10.002 · Cited by 634
Microfluidic Devices for Bioapplications
Yeo, L. Y., Chang, H., Chan, P. P. Y., & Friend, J. R. (2011) · Small · doi:10.1002/smll.201000946 · Cited by 622
Metadata
- Authors
- Krishnan, M., Ugaz, V. M., & Burns, M. A.
- Venue
- Science
- Published
- 2002-10-25
- Volume
- 298
- Issue
- 5594
- Pages
- 793-793
- ISSN
- 0036-8075 (ISSN-L)
- 1095-9203
- OpenAlex
- W2059038261
- Cited by
- 280
- References
- 1
- FWCI
- 8.05
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: PCR in a Rayleigh-Bénard Convection Cell. https://app.cochat.ai/papers/10.1126/science.298.5594.793
- The paper
- Krishnan, M., Ugaz, V. M., & Burns, M. A. (2002). PCR in a Rayleigh-Bénard Convection Cell. Science. https://doi.org/10.1126/science.298.5594.793
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.