Student or educator? Sign up with your school email and get 6 months of Pro free.
Cited by 197

The DOI matches its Crossref record.

Chapter 12: Mechanism of Seismic Faulting

OROWAN, E.·1960·Geological Society of America Memoirs

Abstract

According to the classical theory, earthquakes would be caused by fracture, or the release of static friction, followed by sliding between the fault walls and a consequent drop of stress around the fault. At a depth of 600–700 km, where the pressure is about 200,000 bars, the lowest possible estimate of the coefficient of friction (about 1) would demand principal stress differences of the order of 400,000 bars for overcoming the friction of the fault wall and producing a drop in seismic stress. Such high stresses cannot be assumed to exist, if only because the yield stress of the asthenospheric rocks can hardly have an order of magnitude exceeding a few tens or at most hundreds of bars. This estimate is obtained by extrapolation of the observed creep behavior of hard materials with the assumption that the effect of a hydrostatic pressure is similar to that of a correspondingly increased molecular cohesive pressure; its order of magnitude agrees with that of the stress drop estimated from the energies released in earthquakes. A detailed discussion of this difficulty shows that earthquakes, except at focal depths less than about 5–10 km, cannot arise in the manner implied in the classical theory. The only plausible alternative available at present is that they are due to an instability of plastic deformation (creep) such as gives rise to slip bands, Lüders bands, the Hanson-Wheeler creep-deformation bands, and many other similar phenomena. If creep produces structural changes that accelerate further creep, the deformation concentrates gradually into thin layers in which high flow rates can develop, and finally even shear melting may occur by the heat development due to plastic deformation. Such a mechanism would explain the sequence structure of earthquakes (fore- and aftershocks). If fracture and frictional sliding are impossible and faulting can occur only by the gradual concentration of creep deformation into thin zones, the stress concentration around the edges of a fault cannot propagate this fault immediately over the entire stressed volume, as would be the case with faulting due to fracture. The fault can extend only after the occurrence of a certain amount of creep leading to progressive strain concentration in the region put under increased stress by the preceding faulting. The first faults in a sequence are likely to be small; after several preparatory faults have thrown a high stress upon a larger volume, however, extensive faulting with larger shocks may develop. Toward the end of the sequence the intensity of the shocks is likely to decrease again by depletion of stress. Since creep instability seems at present the only feasible mechanism of deep and intermediate-depth earthquakes, the fact that it is a characteristic of crystalline materials indicates that the seismogenic parts of the Earth’s mantle are substantially crystalline.

Overview

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1130/mem79-p323

Cites

Statistics

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cited by

See all 197

Metadata

Authors
OROWAN, E.
Venue
Geological Society of America Memoirs
Published
1960-03
Pages
323-346
ISSN
0072-1069
OpenAlex
W2469593020
Cited by
197
References
0
FWCI
2.06
Type
conference paper
Language
en
Open access
closed

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

How to cite

Cite CoChat for the checks on this page, and the paper for its own findings.

This page
CoChat. (2026). Citation check: Chapter 12: Mechanism of Seismic Faulting. https://app.cochat.ai/papers/10.1130/mem79-p323
The paper
OROWAN, E. (1960). Chapter 12: Mechanism of Seismic Faulting. Geological Society of America Memoirs. https://doi.org/10.1130/mem79-p323

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.