The DOI matches its Crossref record.
Experimental study of grain-size sensitive flow of synthetic, hot-pressed calcite rocks
Abstract
Synthetic calcite rocks of controlled grain-size were prepared by crushing large, clear calcite crystals, centrifuged to separate restricted grain-size fractions, cold-pressed and then hot-pressed to produce low-porosity polycrystals of mean grain-size covering the range 2–40 µm. These were deformed dry over the range 400–700°C, mainly at 200 MPa confining pressure, to investigate the onset with decreasing grain-size of grain-size sensitive flow. The deformation of the fine-grained material can be described by a flow law of the form ė = A exp (− H/RT ) σ n d m in which at low stresses (<25 MPa differential stress) A = 10 4.9 , H = 190 kJ mol −1 , n = 1.7 and m = −1.9, when strain-rate, ė , is in s −1 , stress, σ, is in MPa and grain-size, d is in µm. At higher stresses (25–250 MPa) A = 100, H = 190 kJ mol −1 , n = 3.3 and m = −1.3. In the low stress regime, grains remain equidimensional during flow, a pre-existing preferred crystallographic orientation produced during cold-pressing tends to weaken and grain-boundary sliding is important. At higher stresses, a grain flattening fabric develops, the pre-existing preferred crystallographic orientation pattern is preserved, and recovery-accommodated intracrystalline plastic flow is inferred to be the dominant deformation mechanism. Grain-size sensitivity of the flow stress persists even into the intracrystalline plastic flow regime. Grain-size insensitive flow only develops at grain-sizes greater than 40 µm, as demonstrated by reference to mechanical data for the flow of Carrara and Taiwan marbles. The flow laws which describe most of the experimental data do not extrapolate well through the lowest strain-rate data at the coarser grain-sizes. This indicates that a complete description of the flow, which can be used reliably to extrapolate to geological conditions, requires one or more of the material parameters A, n and m to be a function of one or more of stress, strain-rate and grain-size. This implies variable contributions from different deformation mechanisms as the deformation conditions change.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
Strength of the lithosphere: Constraints imposed by laboratory experiments
Kohlstedt, D. L., Evans, B., & Mackwell, S. J. (1995) · Journal of Geophysical Research: Solid Earth · doi:10.1029/95jb01460 · Cited by 1,603
Dislocation and diffusion creep of synthetic anorthite aggregates
Rybacki, E., & Dresen, G. (2000) · Journal of Geophysical Research: Solid Earth · doi:10.1029/2000jb900223 · Cited by 309
Crystallographic fabrics: a selective review of their applications to research in structural geology
Law, R. D. (1990) · Geological Society, London, Special Publications · doi:10.1144/gsl.sp.1990.054.01.30 · Cited by 277
Metadata
- Authors
- Walker, A. N., Rutter, E. H., & Brodie, K. H.
- Venue
- Geological Society, London, Special Publications
- Publisher
- Geological Society of London
- Published
- 1990-01
- Volume
- 54
- Issue
- 1
- Pages
- 259-284
- ISSN
- 0305-8719 (ISSN-L)
- 2041-4927
- OpenAlex
- W2037169091
- Cited by
- 169
- References
- 0
- FWCI
- 1.50
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Experimental study of grain-size sensitive flow of synthetic, hot-pressed calcite rocks. https://app.cochat.ai/papers/10.1144/gsl.sp.1990.054.01.24
- The paper
- Walker, A. N., Rutter, E. H., & Brodie, K. H. (1990). Experimental study of grain-size sensitive flow of synthetic, hot-pressed calcite rocks. Geological Society, London, Special Publications. https://doi.org/10.1144/gsl.sp.1990.054.01.24
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.