Feasibility of Cryptography In a Blockchain-Enhanced ICS Security
Open accessThe DOI matches its Crossref record; 18 of the 18 references it cites were found in a registry or an index.
Abstract
Blockchain-homomorphic encryption (BC+HE) hybrids are increasingly promoted for Industrial Control System (ICS) security, yet their deployment at network edges violates fundamental real-time constraints. This paper demonstrates that BC+HE architectures introduce latencies of 51–440 ms in small networks (5–50 nodes), exceeding safety-critical loop requirements of ≤10 ms [21][22] by factors of 5–44×. Through a Latency Collision Matrix analysis spanning Purdue Model Levels 0–5, the paper shows that probabilistic blockchain consensus (non-deterministic jitter) and homomorphic encryption overhead (>100 ms compute-bound) create an architectural incompatibility: edge devices require >100k readings/sec with zero jitter, while BC+HE delivers significanlty less (< 1,000 TPS) with high variance. Offloading cryptography to SCADA gateways (Level 2) fails to resolve the problem, instead creating a ''dead zone'' bottleneck and exposing Level 2–3 inter-layer vulnerabilities. This paper proposes a Resource-Constrained Security Framework that decouples security layers: lattice-based lightweight cryptography (LBC) for Level 0-1 sensor-to-controller authentication (TLatticeAuth << Tsafety ), where the authentication time TLatticeAuth is significantly less than the safety margin Tsafety while reserving BC+HE for non-real-time enterprise layers (Levels 4–5). Lattice primitives (LWE, Ring-LWE) offer linear complexity, parallelizable operations, and deterministic execution suitable for FPGA/ASIC acceleration. The proposed architecture aligns cryptographic mechanisms with physical constraints rather than imposing IT security models on operational technology. This work delivers a falsifiable critique grounded in quantitative performance modeling: measured latencies, throughput limits, and architectural boundaries establish that current BC+HE integrations are operationally unsafe at ICS edges. The framework provides actionable guidance for operators (audit edge deployments, enforce layer separation), researchers (develop layer-specific metrics, hardware acceleration), and standards bodies (update IEC 62443 with latency budgets and cryptographic safety interfaces).
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Cited works that were retracted
Works this paper cites that were later retracted, from the retraction notices publishers deposit. Major when the notice came out before this paper was published.
Rated major: it would touch a result — a value a result rests on, reported and recomputed p-values on opposite sides of the significance level, two passages that conflict with no sign which is right, or a cited work retracted before this paper was published.
In the paper
“10.6028/NIST.FIPS.203.ipd”
Cited work 10.6028/nist.fips.203.ipd · retracted 2024-08-13 · notice 10.6028/nist.fips.203.ipd · this paper published 2026-05-28
Citations
Cites
1 retracted
Module-Lattice-Based Key-Encapsulation Mechanism Standard
(2023) · doi:10.6028/nist.fips.203.ipd · Cited by 109
RetractedBlockchain challenges and opportunities: a survey
Zheng, Z., Xie, S., Dai, H. N., Chen, X., & Wang, H. (2018) · International Journal of Web and Grid Services · doi:10.1504/ijwgs.2018.095647 · Cited by 3,651
On the Security and Performance of Proof of Work Blockchains
Gervais, A., Karame, G. O., Wüst, K., Glykantzis, V., Ritzdorf, H., & Capkun, S. (2016) · Proceedings of the 2016 ACM SIGSAC Conference on Computer and Communications Security · doi:10.1145/2976749.2978341 · Cited by 1,646
A Survey on Homomorphic Encryption Schemes: Theory and Implementation
Acar, A., Aksu, H., Uluagac, A. S., & Conti, M. (2019) · ACM Computing Surveys · doi:10.1145/3214303 · Cited by 1,397 · cited 2×
“Furthermore, Fully Homomorphic Encryption (FHE) adds computational overhead 4 – 6 orders of magnitude higher than plaintext operations, rendering it infeasible for real-time edge processing [1][8].”
Blockchain Meets IoT: An Architecture for Scalable Access Management in IoT
Novo, O. (2018) · IEEE Internet of Things Journal · doi:10.1109/jiot.2018.2812239 · Cited by 1,318 · cited 1×
“The reliance on blockchain consensus — even optimized “credit - based” Proof -of-Work — introduces probabilistic latency that fundamentally violates the deterministic requirements of the OT environment [3][5][11][17].”
Towards secure industrial IoT: blockchain system with credit-based consensus mechanism
Huang, J., Kong, L., Chen, G., Wu, M.-Y., Liu, X., & Zeng, P. (2019) · IEEE Transactions on Industrial Informatics · doi:10.1109/tii.2019.2903342 · Cited by 563 · cited 1×
“The reliance on blockchain consensus — even optimized “credit - based” Proof -of-Work — introduces probabilistic latency that fundamentally violates the deterministic requirements of the OT environment [3][5][11][17].”
Introduction to Industrial Control Networks
Galloway, B., & Hancke, G. P. (2013) · IEEE Communications Surveys & Tutorials · doi:10.1109/surv.2012.071812.00124 · Cited by 548 · cited 3×
“Empirically, this enables cryptographic verification on standard edge controllers (e.g., ARM Cortex-M4) to execute in 0.5 ms , providing a safety margin of 20 × against the strict ≤ 10 ms WCET requirement by safety stadards in IEC 61508 [13].”
InfluentialTange, K., De Donno, M., Fafoutis, X., & Dragoni, N. (2020) · IEEE Communications Surveys & Tutorials · doi:10.1109/comst.2020.3011208 · Cited by 410 · cited 3×
“Unlike IT servers which prioritize high throughput, these components execute cyclical control loops where timing is safety critical [11].”
InfluentialMininet-WiFi: Emulating software-defined wireless networks
Fontes, R. R., Afzal, S., Brito, S. H. B., Santos, M. A. S., & Rothenberg, C. E. (2015) · 2015 11th International Conference on Network and Service Management (CNSM) · doi:10.1109/cnsm.2015.7367387 · Cited by 409 · cited 2×
“This algorithmic optimization accelerates processing by mapping polynomial operations into a frequency domain for rapid pointwise multiplication [26].”
Blockchain-enabled supply chain: An experimental study
Longo, F., Nicoletti, L., Padovano, A., d'Atri, G., & Forte, M. (2019) · Computers & Industrial Engineering · doi:10.1016/j.cie.2019.07.026 · Cited by 383
Research works printed but not linked: 8
- 10.1109/ACCESS.2019.2904988 · doi:10.1109/access.2019.2904988
- 10.1109/JIOT.2017.2737747 · doi:10.1109/jiot.2017.2737747
- 10.6028/NIST.SP.800--82r3 · doi:10.6028/nist.sp.800--82r3
- Williams, T.J. and Rathwell, G.A. 1993. The Purdue Enterprise Reference Architecture. Technical Report 154. Purdue University Computer Integrated Manufacturing Laboratory, West Lafayette, IN.
- IEC. 2010. IEC 61508--1:2010 Functional safety of electrical/electronic/programmable electronic safety-related systems - Part 1: General requirements. International Electrotechnical Commission, Geneva, Switzerland
- 10.1007/978--3--319--39028--4_9 · doi:10.1007/978--3--319--39028--4_9
- 10.1007/978--3--662--53357--4_8 · doi:10.1007/978--3--662--53357--4_8
- ISA/IEC. 2013. Security for industrial automation and control systems - Part 3--3: System security requirements and security levels. ISA-62443--3-3 (IEC 62443--3-3). International Society of Automation / International Electrotechnical Commission, Research Triangle Park, NC, USA.
Metadata
- Authors
- Kamal, K., Islam, R., & Rahman, A.
- Affiliations
- Charles Sturt University (AU)
- Venue
- Companion Proceedings of the ACM Web Conference 2026
- Publisher
- ACM
- Published
- 2026-05-28
- Pages
- 1326-1331
- OpenAlex
- W7162660287
- Semantic Scholar
- 72d00c53c3c5557329104fa2f050ec369b72a1b8
- Cited by
- 0
- References
- 17
- FWCI
- 0.00
- Type
- conference paper
- Language
- en
- Open access
- hybrid
- doi.org
- Licence
- cc-by-nc-nd
- Locations
- International World Wide Web Conference (WWW) (publishedVersion, cc-by-nc-nd)
- Charles Sturt University Research Output (CRO) (publishedVersion, cc-by-nc-nd)
- Topics
- Physical Sciences › Computer Science › Computer Networks and Communications › Cryptography and Data Security
- Physical Sciences › Computer Science › Information Systems › Blockchain Technology Applications and Security
- Physical Sciences › Engineering › Control and Systems Engineering › Smart Grid Security and Resilience
- Keywords
- industrial control systems, ICS security, latency analysis, real-time constraints, lattice-based cryptography, ring learning with errors, lightweight cryptography, Purdue model, blockchain consensus, IEC 62443
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Feasibility of Cryptography In a Blockchain-Enhanced ICS Security. https://app.cochat.ai/papers/10.1145/3774905.3794685
- The paper
- Kamal, K., Islam, R., & Rahman, A. (2026). Feasibility of Cryptography In a Blockchain-Enhanced ICS Security. Companion Proceedings of the ACM Web Conference 2026. https://doi.org/10.1145/3774905.3794685
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.