The DOI matches its Crossref record; 11 of the 11 references it cites were found in a registry or an index.
Plasma and Thermal ALD of Al[sub 2]O[sub 3] in a Commercial 200 mm ALD Reactor
Open accessAbstract
The deposition of by remote plasma atomic layer deposition (ALD) in the Oxford Instruments FlexAL reactor was studied and compared with results from thermal ALD in the same reactor. Trimethylaluminum was used as the metal precursor and plasma and were used as oxidizing agents for the plasma and thermal processes, respectively. For remote plasma ALD with a total cycle time of , the growth per cycle decreased monotonically with substrate temperature, from at 25°C to at 300°C. This growth per cycle was consistently higher than that obtained for thermal ALD. For the latter a maximum growth per cycle of was found at 200°C. The film properties investigated were nearly independent of oxidant source for temperatures between 100 and 300°C, with a slightly higher mass density for the remote plasma ALD films. Films deposited at 200 and 300°C were stoichiometric with a mass density of and low C and H contents. At lower substrate temperatures, oxygen-rich films were obtained with a lower mass density and higher H-content. Remote plasma ALD produced uniform films with nonuniformities of less than over diam substrates. Excellent conformality was obtained for films deposited in macropores with an aspect ratio of . Preliminary results on electrical properties of remote plasma deposited films showed high dielectric constants of 7.8 and 8.9 for as-deposited and forming gas annealed , respectively.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Surface chemistry of atomic layer deposition: A case study for the trimethylaluminum/water process
Puurunen, R. L. (2005) · Journal of Applied Physics · doi:10.1063/1.1940727 · Cited by 2,609
Low-Temperature Al2O3 Atomic Layer Deposition
Groner, M. D., Fabreguette, F. H., Elam, J. W., & George, S. M. (2004) · Chemistry of Materials · doi:10.1021/cm0304546 · Cited by 1,403
Groner, M. D., Elam, J. W., Fabreguette, F. H., & George, S. M. (2002) · Thin Solid Films · doi:10.1016/s0040-6090(02)00438-8 · Cited by 758
Al3O3 thin film growth on Si(100) using binary reaction sequence chemistry
Ott, A. W., Klaus, J. W., Johnson, J. M., & George, S. M. (1997) · Thin Solid Films · doi:10.1016/s0040-6090(96)08934-1 · Cited by 517
Surface chemistry of Al2O3 deposition using Al(CH3)3 and H2O in a binary reaction sequence
Dillon, A. C., Ott, A. W., Way, J. D., & George, S. M. (1995) · Surface Science · doi:10.1016/0039-6028(95)90033-0 · Cited by 462
Ca test of Al2O3 gas diffusion barriers grown by atomic layer deposition on polymers
Carcia, P. F., McLean, R. S., Reilly, M. H., Groner, M. D., & George, S. M. (2006) · Applied Physics Letters · doi:10.1063/1.2221912 · Cited by 436
Plasma-assisted atomic layer deposition of Al2O3 moisture permeation barriers on polymers
Langereis, E., Creatore, M., Heil, S. B. S., van de Sanden, M. C. M., & Kessels, W. M. M. (2006) · Applied Physics Letters · doi:10.1063/1.2338776 · Cited by 269
Self-citationOzone-Based Atomic Layer Deposition of Alumina from TMA: Growth, Morphology, and Reaction Mechanism
Elliott, S. D., Scarel, G., Wiemer, C., Fanciulli, M., & Pavia, G. (2006) · Chemistry of Materials · doi:10.1021/cm0608903 · Cited by 191
Experimental studies of O2/Ar plasma in a planar inductive discharge
Guðmundsson, J. T., Kimura, T., & Lieberman, M. A. (1999) · Plasma Sources Science and Technology · doi:10.1088/0963-0252/8/1/003 · Cited by 132
Electrical Properties of Alumina Films by Plasma-Enhanced Atomic Layer Deposition
Lim, J. W., & Yun, S. J. (2004) · Electrochemical and Solid-State Letters · doi:10.1149/1.1756541 · Cited by 111
Surface chemistry of Al2O3 deposition using Al(CH3)3 and H2O in a binary reaction sequence
George, S. M. (1995) · Surface Science · doi:10.1016/0039-6028(94)00578-8 · Cited by 27
Cited by
Crystallinity of inorganic films grown by atomic layer deposition: Overview and general trends
Miikkulainen, V., Leskelä, M., Ritala, M., & Puurunen, R. L. (2013) · Journal of Applied Physics · doi:10.1063/1.4757907 · Cited by 1,413
Plasma-Assisted Atomic Layer Deposition: Basics, Opportunities, and Challenges
Profijt, H. B., Potts, S. E., van de Sanden, M. C. M., & Kessels, W. M. M. (2011) · Journal of Vacuum Science & Technology A: Vacuum, Surfaces, and Films · doi:10.1116/1.3609974 · Cited by 907
Self-citationStatus and prospects of Al2O3-based surface passivation schemes for silicon solar cells
Dingemans, G., & Kessels, W. M. M. (2012) · Journal of Vacuum Science & Technology A: Vacuum, Surfaces, and Films · doi:10.1116/1.4728205 · Cited by 818
Self-citationConformality in atomic layer deposition: Current status overview of analysis and modelling
Cremers, V., Puurunen, R. L., & Dendooven, J. (2019) · Applied Physics Reviews · doi:10.1063/1.5060967 · Cited by 508
Silicon surface passivation by atomic layer deposited Al2O3
Hoex, B., Schmidt, J., Pohl, P., van de Sanden, M. C. M., & Kessels, W. M. M. (2008) · Journal of Applied Physics · doi:10.1063/1.2963707 · Cited by 479
Self-citation
Metadata
- Authors
- van Hemmen, J. L., Heil, S. B. S., Klootwijk, J. H., Roozeboom, F., Hodson, C. J., van de Sanden, M. C. M., & Kessels, W. M. M.
- Venue
- Journal of The Electrochemical Society
- Publisher
- The Electrochemical Society
- Published
- 2007
- Volume
- 154
- Issue
- 7
- Pages
- G165
- ISSN
- 0013-4651 (ISSN-L)
- OpenAlex
- W1668040035
- Cited by
- 279
- References
- 11
- FWCI
- 12.91
- Type
- journal article
- Language
- en
- Open access
- bronze
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.