The DOI matches its Crossref record; 14 of the 14 references it cites were found in a registry or an index.
Effect of Residual Lithium Compounds on Layer Ni-Rich Li[Ni0.7Mn0.3]O2
Open accessAbstract
In order to confirm reasons that deteriorate cathode performances, Ni-rich Li[Ni 0.7 Mn 0.3 ]O 2 is modified by lithium isopropoxide to artificially provide lithium excess environment by forming Li 2 O on the surface of active materials. X-ray diffraction patterns indicate that the lithium oxide coating does not affect structural change comparing to the bare material. Scanning electron microscopy and transmission electron microscopy data show the presence of coating layers on the surface of Li[Ni 0.7 Mn 0.3 ]O 2 . Electrochemical tests demonstrate that the Li 2 O-coated Li[Ni 0.7 Mn 0.3 ]O 2 exhibits a greater irreversible capacity with a small capacity because of the presence of insulating layers composed of lithium compounds on the active materials since these layers delay facile Li + diffusion. Also, the Li 2 O layer forms byproducts such as Li 2 CO 3 , LiOH, and LiF, as are proved by X-ray photoelectron spectroscopy and time-of-flight secondary ion mass spectrometry. The presence of residual lithium tends to bond with hydrocarbons induced from decomposition of electrolytic salt during electrochemical reactions. And the reaction, accelerated by the decomposition of electrolytic salt that produces the byproducts, causes the formation of passive layers on the surface of active material. As a result, the new layers consequently impede diffusion of lithium ions that deteriorate electrochemical properties.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Shannon, R. D. (1976) · Acta Crystallographica Section A · doi:10.1107/s0567739476001551 · Cited by 66,145
Electrochemistry and Structural Chemistry of LiNiO2 (R3m) for 4 Volt Secondary Lithium Cells
Ohzuku, T., Ueda, A., & Nagayama, M. (1993) · Journal of The Electrochemical Society · doi:10.1149/1.2220730 · Cited by 1,384
Nanostructured high-energy cathode materials for advanced lithium batteries
Sun, Y.-K., Chen, Z., Noh, H.-J., Lee, D.-J., Jung, H.-G., Ren, Y., Wang, S., Yoon, C. S., Myung, S.-T., & Amine, K. (2012) · Nature Materials · doi:10.1038/nmat3435 · Cited by 1,093
Self-citationIn situ x-ray diffraction and electrochemical studies of Li1−xNiO2
LI, W., Reimers, J. N., & Dahn, J. R. (1993) · Solid State Ionics · doi:10.1016/0167-2738(93)90317-v · Cited by 745
Rechargeable LiNiO2 / Carbon Cells
Dahn, J. R., von Sacken, U., Juzkow, M. W., & Al‐Janaby, H. (1991) · Journal of The Electrochemical Society · doi:10.1149/1.2085950 · Cited by 639
Dynamic Structural Changes at LiMn2O4/Electrolyte Interface during Lithium Battery Reaction
Hirayama, M., Ido, H., Kim, K., et al. (2010) · Journal of the American Chemical Society · doi:10.1021/ja105389t · Cited by 375
Characterization and cathode performance of Li1 − xNi1 + xO2 prepared with the excess lithium method
Arai, H. (1995) · Solid State Ionics · doi:10.1016/0167-2738(95)00144-u · Cited by 365
Why transition metal (di) oxides are the most attractive materials for batteries
Ohzuku, T., & Ueda, A. (1994) · Solid State Ionics · doi:10.1016/0167-2738(94)90410-3 · Cited by 345
Surface changes on LiNi0.8Co0.2O2 particles during testing of high-power lithium-ion cells
Abraham, D. P., Twesten, R. D., Balasubramanian, M., Petrov, I., McBreen, J., & Amine, K. (2002) · Electrochemistry Communications · doi:10.1016/s1388-2481(02)00388-0 · Cited by 312
Cobalt-Free Nickel Rich Layered Oxide Cathodes for Lithium-Ion Batteries
Sun, Y.-K., Lee, D.-J., Lee, Y. J., Chen, Z., & Myung, S.-T. (2013) · ACS Applied Materials & Interfaces · doi:10.1021/am403684z · Cited by 296
Self-citationMoshkovich, M., Cojocaru, M., Gottlieb, H. E., & Aurbach, D. (2001) · Journal of Electroanalytical Chemistry · doi:10.1016/s0022-0728(00)00457-5 · Cited by 271
Pouillerie, C., Croguennec, L., Biensan, P., Willmann, P., & Delmas, C. (2000) · Journal of The Electrochemical Society · doi:10.1149/1.1393486 · Cited by 238
Kostecki, R. M., & McLARNON, F. R. (2004) · Electrochemical and Solid-State Letters · doi:10.1149/1.1793771 · Cited by 130
Myung, S., Ogata, A., Lee, K.-S., Komaba, S., Sun, Y., & Yashiro, H. (2008) · Journal of The Electrochemical Society · doi:10.1149/1.2883733 · Cited by 33
Self-citation
Cited by
Nickel‐Rich Layered Lithium Transition‐Metal Oxide for High‐Energy Lithium‐Ion Batteries
Liu, W., Oh, P., Liu, X., Lee, M., Cho, W., Chae, S., Kim, Y., & Cho, J. (2015) · Angewandte Chemie International Edition · doi:10.1002/anie.201409262 · Cited by 1,960
Self-citationHigh-voltage positive electrode materials for lithium-ion batteries
Li, W., Song, B., & Manthiram, A. (2017) · Chemical Society Reviews · doi:10.1039/c6cs00875e · Cited by 1,339
Schipper, F., Erickson, E. M., Erk, C., Shin, J.-Y., Chesneau, F. F., & Aurbach, D. (2017) · Journal of The Electrochemical Society · doi:10.1149/2.0351701jes · Cited by 762
Problems and their origins of Ni-rich layered oxide cathode materials
Zhang, S. S. (2020) · Energy Storage Materials · doi:10.1016/j.ensm.2019.08.013 · Cited by 746
Jiang, M., Danilov, D. L., Eichel, R., & Notten, P. H. L. (2021) · Advanced Energy Materials · doi:10.1002/aenm.202103005 · Cited by 720
Metadata
- Authors
- Cho, D.-H., Jo, C.-H., Cho, W., Kim, Y.-J., Yashiro, H., Sun, Y.-K., & Myung, S.-T.
- Venue
- Journal of The Electrochemical Society
- Publisher
- The Electrochemical Society
- Published
- 2014
- Volume
- 161
- Issue
- 6
- Pages
- A920-A926
- ISSN
- 0013-4651 (ISSN-L)
- 1945-7111
- OpenAlex
- W1973932973
- Cited by
- 340
- References
- 14
- FWCI
- 6.72
- Type
- journal article
- Language
- en
- Open access
- bronze
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.