A Cautionary Note on the Use of the Vale and Maurelli Method to Generate Multivariate, Nonnormal Data for Simulation Purposes
Open accessThe DOI matches its Crossref record; 2 of the 2 references it cites were found in a registry or an index.
Abstract
To further understand the properties of data-generation algorithms for multivariate, nonnormal data, two Monte Carlo simulation studies comparing the Vale and Maurelli method and the Headrick fifth-order polynomial method were implemented. Combinations of skewness and kurtosis found in four published articles were run and attention was specifically paid to the quality of the sample estimates of univariate skewness and kurtosis. In the first study, it was found that the Vale and Maurelli algorithm yielded downward-biased estimates of skewness and kurtosis (particularly at small samples) that were also highly variable. This method was also prone to generate extreme sample kurtosis values if the population kurtosis was high. The estimates obtained from Headrick’s algorithm were also biased downward, but much less so than the estimates obtained through Vale and Maurelli and much less variable. The second study reproduced the first simulation in the Curran, West, and Finch article using both the Vale and Maurelli method and the Heardick method. It was found that the chi-square values and empirical rejection rates changed depending on which data-generation method was used, sometimes sufficiently so that some of the original conclusions of the authors would no longer hold. In closing, recommendations are presented regarding the relative merits of each algorithm.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
How to Use a Monte Carlo Study to Decide on Sample Size and Determine Power
Muthén, L. K., & Muthén, B. O. (2002) · Structural Equation Modeling: A Multidisciplinary Journal · doi:10.1207/s15328007sem0904_8 · Cited by 2,362
Doing Bayesian Data Analysis: A Tutorial with R and BUGS
Barry, J. (2011) · Europe’s Journal of Psychology · doi:10.5964/ejop.v7i4.163 · Cited by 563 · cited 1×
“These findings are in line with the ones of Luo (2011) and Kraatz (2011), so it is reasonable to assume that regardless of the dimensionality of the data, the third-order polynomial method can result in suboptimal estimates, unless the sample sizes are moderately large (likely larger than 200, although even at 1,000 o…”
Result
Cited by
Lai, K. (2018) · Structural Equation Modeling: A Multidisciplinary Journal · doi:10.1080/10705511.2017.1392248 · Cited by 190
“This is because for higher order moments, especially kurtosis, when the multivariate (nonnormal) distribution has high dimensions (p = 20 in our simulations), sample moments are usually lower than the population moments (for demonstrations, see Astivia & Zumbo, 2014).”
BackgroundMethodFalk, C. F. (2018) · Structural Equation Modeling: A Multidisciplinary Journal · doi:10.1080/10705511.2017.1367254 · Cited by 75
Metadata
- Authors
- Olvera Astivia, O. L., & Zumbo, B. D.
- Venue
- Educational and Psychological Measurement
- Publisher
- SAGE Publications
- Published
- 2014-09-12
- Volume
- 75
- Issue
- 4
- Pages
- 541-567
- ISSN
- 0013-1644 (ISSN-L)
- 1552-3888
- OpenAlex
- W2140588557
- Cited by
- 36
- References
- 2
- FWCI
- 3.70
- Type
- journal article
- Language
- en
- Open access
- green
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.