The DOI matches its Crossref record; 16 of the 16 references it cites were found in a registry or an index.
Characterizing the shale gas resource potential of Devonian–Mississippian strata in the Western Canada sedimentary basin: Application of an integrated formation evaluation
Abstract
Abstract Devonian–Mississippian strata in the northwestern region of the Western Canada sedimentary basin (WCSB) were investigated for shale gas potential. In the subsurface, thermally mature strata of the Besa River, Horn River, Muskwa, and Fort Simpson formations attain thicknesses of more than 1 km (0.6 mi), encompassing an area of approximately 125,000 km2 (48,300 mi2) and represent an enormous potential gas resource. Total gas capacity estimates range between 60 and 600 bcf/section. Of particular exploration interest are shales and mudrocks of the Horn River Formation (including the laterally equivalent lower Besa River mudrocks), Muskwa Formation, and upper Besa River Formation, which yield total organic carbon (TOC) contents of up to 5.7 wt.%. Fort Simpson shales seldom have TOC contents above 1 wt.%. Horn River and Muskwa formations have excellent shale gas potential in a region between longitudes 122°W and 123°W and latitudes 59°N and 60°N (National Topographic System [NTS] 94O08 to 94O15). In this area, which covers an areal extent of 6250 km2 (2404 mi2), average TOC contents are higher (>3 wt.% as determined by wire-line-log calibrations), and have a stratal thickness of more than 200 m (656 ft). Gas capacities are estimated to be between 100 and 240 bcf/section and possibly greater than 400 tcf gas in place. A substantial percentage of the gas capacity is free gas caused by high reservoir temperatures and pressures. Muskwa shales have adsorbed gas capacities ranging between 0.3 and 0.5 cm3/g (9.6–16 scf/t) at reservoir temperatures of 60–80°C (140–176°F), whereas Besa River mudrocks and shales have low adsorbed gas capacities of less than 0.01 cm3/g (0.32 scf/t; Liard Basin region) because reservoir temperatures exceed 130°C (266°F). Potential free gas capacities range from 1.2 to 9.5 cm3/g (38.4 to 304 scf/t) when total pore volumes (0.4–6.9%) are saturated with gas. The mineralogy has a major influence on total gas capacity. Carbonate-rich samples, indicative of adjacent carbonate platform and embayment successions, commonly have lower organic carbon content and porosity and corresponding lower gas capacity (<1% TOC and <1% porosity). Seaward of the carbonate Slave Point edge, Muskwa and lower Besa River mudrocks can be both silica and TOC rich (up to 92% quartz and 5 wt.% TOC) and most favorable for shale gas reservoir exploration because of possible fracture enhancement of the brittle organic- and siliceous-rich facies. However, an inverse relation between silica and porosity in some regions implies that zones with the best propensity for fracture completion may not provide optimal gas capacity, and a balance between favorable reservoir characteristics needs to be sought.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
The adsorption of gases on plane surfaces of glass, mica and platinum
Langmuir, I. (1918) · Journal of the American Chemical Society · doi:10.1021/ja02242a004 · Cited by 23,242
Recommendations for the characterization of porous solids (Technical Report)
Rouquerol, J., Avnir, D., Fairbridge, C. W., Everett, D. H., Haynes, J. M., Pernicone, N., Ramsay, J. D. F., Sing, K. S. W., & Unger, K. K. (1994) · Pure and Applied Chemistry · doi:10.1351/pac199466081739 · Cited by 3,984
Guidelines for Evaluating Petroleum Source Rock Using Programmed Pyrolysis
(2), K. E. P. (1986) · AAPG Bulletin · doi:10.1306/94885688-1704-11d7-8645000102c1865d · Cited by 2,512
Espitalié, J., Laporte, J. L., Madec, M., Marquis, F., Leplat, P., Paulet, J., & Boutefeu, A. (1977) · Revue de l'Institut Français du Pétrole · doi:10.2516/ogst:1977002 · Cited by 1,453
How permeable are clays and shales?
Neuzil, C. E. (1994) · Water Resources Research · doi:10.1029/93wr02930 · Cited by 601
Shale gas potential of the Lower Jurassic Gordondale Member, northeastern British Columbia, Canada
Ross, D. J. K., & Bustin, R. M. (2007) · Bulletin of Canadian Petroleum Geology · doi:10.2113/gscpgbull.55.1.51 · Cited by 481
Self-citationPorosity and Permeability of Eastern Devonian Gas Shale
Soeder, D. J. (1988) · SPE Formation Evaluation · doi:10.2118/15213-pa · Cited by 279
Determination of Organic-Matter Content of Appalachian Devonian Shales from Gamma-Ray Logs
Schmoker, J. W. (1981) · AAPG Bulletin · doi:10.1306/03b5949a-16d1-11d7-8645000102c1865d · Cited by 264
Experimental characterisation of the hydrocarbon sealing efficiency of cap rocks
Schlömer, S., & Krooss, B. M. (1997) · Marine and Petroleum Geology · doi:10.1016/s0264-8172(97)00022-6 · Cited by 254
Early Paleozoic (Cambrian to Early Devonian) Tectonic Framework, Canadian Cordillera
Cecile, M. P., Morrow, D. W., & Williams, G. K. (1997) · Bulletin of Canadian Petroleum Geology · doi:10.35767/gscpgbull.45.1.054 · Cited by 106
Cited by
Evolution of nanoporosity in organic-rich shales during thermal maturation
Chen, J., & Xiao, X. (2014) · Fuel · doi:10.1016/j.fuel.2014.03.058 · Cited by 401
Metadata
- Authors
- Ross, D. J. K., & Bustin, R. M.
- Venue
- AAPG Bulletin
- Published
- 2008-01
- Volume
- 92
- Issue
- 1
- Pages
- 87-125
- ISSN
- 0149-1423 (ISSN-L)
- OpenAlex
- W2143255740
- Cited by
- 757
- References
- 16
- FWCI
- 7.36
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Characterizing the shale gas resource potential of Devonian–Mississippian strata in the Western Canada sedimentary basin: Application of an integrated formation evaluation. https://app.cochat.ai/papers/10.1306/09040707048
- The paper
- Ross, D. J. K., & Bustin, R. M. (2008). Characterizing the shale gas resource potential of Devonian–Mississippian strata in the Western Canada sedimentary basin: Application of an integrated formation evaluation. AAPG Bulletin. https://doi.org/10.1306/09040707048
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.