Student or educator? Sign up with your school email and get 6 months of Pro free.
Cited by 163

The DOI matches its Crossref record.

The Influence of Rock Fabric and Mineralogy on Thermochemical Sulfate Reduction: Khuff Formation, Abu Dhabi

Worden, R.H., Smalley, P.C., Cross, M.M. · 2000 · Journal of Sedimentary Research

Abstract

Abstract Thermochemical sulfate reduction (TSR) is the reaction between anhydrite and petroleum fluids at elevated temperatures to produce H2S and calcite. In this study of the dolomite-hosted hydrocarbon gas reservoirs in the Permo-Triassic Khuff Formation, Abu Dhabi, a geochemically well constrained rock-gas system, we demonstrate for the first time a clear influence of rock texture and mineralogy on the rate and extent of TSR reactions and thus on H2S concentration in the gas phase. The controls on the rate on H2S accumulation were: (1) TSR reaction kinetics. TSR became significant as temperature exceeded ∼ 140°C, a critical threshold temperature for chemical reaction between aqueous sulfate and aqueous methane. (2) Anhydrite dissolution rate. Once initiated, the subsequent reaction rate was controlled by the rate of supply of aqueous sulfate to the reaction site. Sulfate limitation is indicated by the lack of fractionation of sulfur isotopes between sulfate and sulfide (i.e., suggesting total reaction for each unit of sulfate that dissolves). Also, finely crystalline anhydrite began reacting at a lower temperature than coarse crystalline anhydrite (likely a result of relative surface area), suggesting that anhydrite dissolution was the rate-limiting step. Transport rates are unlikely to have been rate-limiting at the earliest stage of reaction because anhydrite was replaced in situ by calcite on the very edges of anhydrite nodules and crystals. (3) Transport rate. Later, as TSR proceeded, it became transport controlled, as calcite, growing on the surface of anhydrite crystals, began to isolate them from dissolved methane. TSR ceased once calcite had effectively armor-plated (totally isolated) the remaining anhydrite. Finely crystalline anhydrite underwent more extensive and more rapid TSR than coarser anhydrite crystals because these had a greater ratio of surface area to volume, allowing more and faster dissolution and requiring more calcite to isolate them from methane. Localized loss of H2S occurred in the reservoir by reaction with indigenous Fe-bearing clays. Consequently, reservoirs with a relatively high siliciclastic content have less H2S than would be expected from the advanced state of anhydrite replacement by calcite. In order to predict TSR-related H2S concentration in hydrocarbon gases it is thus important to understand the diagenetic and textural characteristics of the reservoir as well as the thermal and petroleum-emplacement history.

Overview

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1306/110499701210

Cites

Statistics

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Metadata

Authors
Worden, R. H., Smalley, P. C., & Cross, M. M.
Venue
Journal of Sedimentary Research
Published
2000-09-01
Volume
70
Issue
5
Pages
1210-1221
ISSN
  • 0022-4472 (ISSN-L)
  • 1527-1404
OpenAlex
W2119766553
Cited by
163
References
0
FWCI
3.96
Type
journal article
Language
en
Open access
closed

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

How to cite

Cite CoChat for the checks on this page, and the paper for its own findings.

This page
CoChat. (2026). Citation check: The Influence of Rock Fabric and Mineralogy on Thermochemical Sulfate Reduction: Khuff Formation, Abu Dhabi. https://app.cochat.ai/papers/10.1306/110499701210
The paper
Worden, R. H., Smalley, P. C., & Cross, M. M. (2000). The Influence of Rock Fabric and Mineralogy on Thermochemical Sulfate Reduction: Khuff Formation, Abu Dhabi. Journal of Sedimentary Research. https://doi.org/10.1306/110499701210

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.