Student or educator? Sign up with your school email and get 6 months of Pro free.
Cited by 407

The DOI matches its Crossref record.

Epigenetic Dolomitization and the Origin of Xenotopic Dolomite Texture

Jay M. Gregg (2), Duncan F. Sibley·1984·SEPM Journal of Sedimentary Research

Abstract

Abstract Xenotopic texture, which is commonly observed in pre-Cenozoic rocks, is defined here as a mosaic of anhedral crystals with irregular or curved intercrystalline boundaries and, usually, undulatory extinction. Xenotopic dolomite texture is similar in appearance to neomorphic limestone textures. Idiotopic dolomite texture (euhedral to subhedral crystals with straight, intercrystalline boundaries) contrasts with xenotopic texture and is commonly observed in both Cenozoic and more ancient dolomites. Texture may be controlled by the temperature at which crystals grow. Crystal growth theory predicts that at low temperature a smooth crystal surface is energetically favored, and atoms are added to crystal faces layer by layer with dislocations acting as nucleation sites. This results in faceted crystals and euhedral to subhedral crystal mosaics. Above a "critical roughening temperature" (CRT), a rough surface is energetically favored, surface nucleation does not require dislocations, and atoms are randomly added to the crystal surface, resulting in nonfaceted growth and an anhedral crystal mosaic. It is hypothesized that a "critical roughening temperature" exists for dolomite above 50 degrees C. Xenotopic dolomites are produced by dolomitization of limestone and/or neomorphic recrystallization of dolomite at elevated temperature (above the CRT) after burial. Idiotopic dolomites are produced below the CRT by near-surface processes and are occasionally produced above CRT if growth-inhibiting effects of the solution or impurities stabilize crystal faces. Calcite has a CRT below 25 degrees C and, therefore, develops anhedral crystal mosaics (characteristic of neomorphic texture) both at near-surface and at elevated temperatures. Synthetic xenotopic dolomite was produced in the laboratory at 250 degrees C and 300 degrees C by dolomitization of aragonite and calcite skeletal fragments and by recrystallization (neomorphism) of nonstoichiometric Cenozoic dolomites. Xenotopic dolomite resulted from the metamorphic recrystallization of the idiotopic Hueco dolomite (Permian, Texas) near the Marble Canyon intrusion, at temperatures between 350 degrees C and 600 degrees C. Hydrothermal dolomitization of periclase-calcite marble near the intrusion also resulted in a xenotopic texture. Xenotopic dolomite in the Galena Group (Ordovician, Wisconsin) was produced by neomorphism of a preexisting dolomite during the emplacement of lead-zinc sulfides at temperatures between 80 degrees C and 227 degrees C. In the Trenton Limestone (Ordovician, Michigan), xenotopic dolomite replaced limestone during the migration of hot (> 50 degrees C) fluids along fracture systems. Xenotopic dolomite was not observed in Cenozoic dolomites that were subjected to temperatures near surface values only.

Overview

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1306/212f8535-2b24-11d7-8648000102c1865d

Cites

Statistics

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cited by

See all 407

Metadata

Authors
Jay M. Gregg (2), D. F. S.
Venue
SEPM Journal of Sedimentary Research
Published
1984
Volume
Vol. 54
Issue
3
Pages
908-931
ISSN
  • 0022-4472 (ISSN-L)
  • 1527-1404
OpenAlex
W2168257464
Cited by
407
References
0
FWCI
2.73
Type
journal article
Language
en
Open access
closed

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

How to cite

Cite CoChat for the checks on this page, and the paper for its own findings.

This page
CoChat. (2026). Citation check: Epigenetic Dolomitization and the Origin of Xenotopic Dolomite Texture. https://app.cochat.ai/papers/10.1306/212f8535-2b24-11d7-8648000102c1865d
The paper
Jay M. Gregg (2), D. F. S. (1984). Epigenetic Dolomitization and the Origin of Xenotopic Dolomite Texture. SEPM Journal of Sedimentary Research. https://doi.org/10.1306/212f8535-2b24-11d7-8648000102c1865d

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.