The DOI matches its Crossref record.
Atomic layer deposition of noble metals: Exploration of the low limit of the deposition temperature
Abstract
The low limit of the deposition temperature for atomic layer deposition (ALD) of noble metals has been studied. Two approaches were taken; using pure oxygen instead of air and using a noble metal starting surface instead of Al 2 O 3. Platinum thin films were obtained by ALD from MeCpPtMe 3 and pure oxygen at deposition temperature as low as 200 °C, which is significantly lower than the low-temperature limit of300 °C previously reported for the platinum ALD process in which air was used as the oxygen source. The platinum films grown in this study had smooth surfaces, adhered well to the substrate, and had low impurity contents. ALD of ruthenium, on the other hand, took place at lower deposition temperatures on an iridium seed layer than on an Al 2 O 3 layer. On iridium surface, ruthenium films were obtained from RuCp 2 and oxygen at 225 °C and from Ru(thd)3 and oxygen at 250 °C, whereas no films were obtained on Al 2 O 3 at temperatures lower than 275 and 325 °C, respectively. The crystal orientation of the ruthenium films was found to depend on the precursor. ALD of palladium from a palladium β-ketoiminate precursor and oxygen at 250 and 275 °C was also studied. However, the film-growth rate did not saturate to a constant level when the precursor pulse times were increased.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
Surface chemistry of atomic layer deposition: A case study for the trimethylaluminum/water process
Puurunen, R. L. (2005) · Journal of Applied Physics · doi:10.1063/1.1940727 · Cited by 2,609
Crystallinity of inorganic films grown by atomic layer deposition: Overview and general trends
Miikkulainen, V., Leskelä, M., Ritala, M., & Puurunen, R. L. (2013) · Journal of Applied Physics · doi:10.1063/1.4757907 · Cited by 1,413
Self-citationCatalyst Design with Atomic Layer Deposition
O’Neill, B. J., Jackson, D. H. K., Lee, J., Canlas, C., Stair, P. C., Marshall, C. L., Elam, J. W., Kuech, T. F., Dumesic, J. A., & Huber, G. W. (2015) · ACS Catalysis · doi:10.1021/cs501862h · Cited by 782
Atomic Layer Deposition of Noble Metals and Their Oxides
Hämäläinen, J., Ritala, M., & Leskelä, M. (2014) · Chemistry of Materials · doi:10.1021/cm402221y · Cited by 361
Self-citationSingle-Atom Catalysts Designed and Prepared by the Atomic Layer Deposition Technique
Fonseca, J., & Lu, J. (2021) · ACS Catalysis · doi:10.1021/acscatal.1c01200 · Cited by 344
Metadata
- Authors
- Aaltonen, T., Ritala, M., Tung, Y.-L., Chi, Y., Arstila, K., Meinander, K., & Leskelä, M.
- Venue
- Journal of Materials Research
- Published
- 2004-11-01
- Volume
- 19
- Issue
- 11
- Pages
- 3353-3358
- ISSN
- 0884-1616 (ISSN-L)
- 0884-2914
- 2044-5326
- OpenAlex
- W2106733023
- Cited by
- 166
- References
- 0
- FWCI
- 6.54
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Atomic layer deposition of noble metals: Exploration of the low limit of the deposition temperature. https://app.cochat.ai/papers/10.1557/jmr.2004.0426
- The paper
- Aaltonen, T., Ritala, M., Tung, Y.-L., Chi, Y., Arstila, K., Meinander, K., & Leskelä, M. (2004). Atomic layer deposition of noble metals: Exploration of the low limit of the deposition temperature. Journal of Materials Research. https://doi.org/10.1557/jmr.2004.0426
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.