The DOI matches its Crossref record.
The Sensitivity of Clays
Abstract
Synopsis The sensitivity of clays is defined as the ratio of their undisturbed and remoulded strengths, and varies from about 1·O for heavily over-consolidated clays to values of over 100 for the so-called extrasensitive or “quick” clays. As a result of experimental work it is shown that thixotropy can account for low or medium sensitivity but not for high sensitivity. Both laboratory and field evidence, however, show that a reduction in the salt concentration in the pore water, caused by leaching clays of marine or estuarine origin, can result in high sensitivities. Moreover, of the small number of clays so far investigated, those which have not been leached are found to exhibit only low or medium sensitivities of the order of magnitude explicable in terms of thixotropy. But it is, nevertheless, not suggested that leaching is the sole cause of high sensitivity and other possibilities are briefly discussed. Reasons are given, supported by experimental work, for the insensitivity of heavily overconsolidated clays with water contents approximating to the plastic limit. A result of particular interest from the scientific point of view is that the water content and undisturbed strength of a clay remain unaltered by learhing, although the liquid limit and remoulded strength are appreciably reduced. It is suggested that this implies effectively “solid” contact between the particles of an undisturbed clay' Finally some evidence is given which indicates that the fissured structure present in many clays may be due to syneresis. La sensitivité des argiles est définie comme étant le rapport entre leur résistance à l'état brut et leur résistance après remoulage, et varie de 1,0, environ, pour les argiles trop fortement tassées, jusqu'à des valeurs de plus de 100 pour des argiles dites extrasensitives ou “sables mouvants”. A la suite de travaux d'expérience, on montre que la thixotropie peut entre en ligne de compte pour les basses ou moyennes de sensitivités, mais non pas pour les fortes sensitivités. Cependant, les travaux de laboratoire et sur les lieux montrent qu'une réduction de la concentration en se1 dans l'eau de porosité, causée par le lavage des argiles d'origine maritime ou alluvionaire, peut provoquer de fortes sensitivités. Qui plus est, du petit nombre d'argiles qui ont fait l'objet de recherches jusqu'à maintenant, celles qui n'ont pas été lavées n'ont présenté seulement que des sensitivités faibles ou moyennes de l'ordre de grandeur explicable en fonction de la thixotropie. Cependant, il n'est pas suggéré que le lavage soit la seule cause de haute sensitivité et d'autres possibilités font l'objet d'une discution rapide. On donne des raisons, s'appuyant sur des travaux expénmentaux, pour le manque de sensitivité des argiles trop fortement tassées dont la teneur en eau approche la limite plastique. Un résultat d'un intérêt tout particulier du point de vue scientifique est que la teneur en eau et la résistance à l'état brut restent inchangées par le lavage, alors que la limite liquide et la résistance après remoulage soient sensiblement réduites. II est suggéré que ceci signifie qu'il y ait un contact “solide” effectif entre les particules d'une argile à l'état brut et s'oppose à la théorie communément acceptée que les particules sont séparées par des couches relativement épaisses d'eau adsorbée. Finalement il est donné des preuves qui indiquent que la structure fissurée qui se rencontre dans beaucoup d'argiles puisse être due à une synérèse.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
The Twentieth Terzaghi Lecture
Mitchell, J. K. (1986) · Journal of Geotechnical Engineering · doi:10.1061/(asce)0733-9410(1986)112:3(255 · Cited by 274
Weller, J. M. (1959) · AAPG Bulletin · doi:10.1306/0bda5c9f-16bd-11d7-8645000102c1865d · Cited by 204
Halloysite behaving badly: geomechanics and slope behaviour of halloysite-rich soils
Moon, V. (2016) · Clay Minerals · doi:10.1180/claymin.2016.051.3.09 · Cited by 37
Metadata
- Authors
- Skemption, A. W., & Northey, R. D.
- Venue
- Géotechnique
- Publisher
- Emerald
- Published
- 1952-03
- Volume
- 3
- Issue
- 1
- Pages
- 30-53
- ISSN
- 0016-8505 (ISSN-L)
- 1751-7656
- OpenAlex
- W2000633023
- Cited by
- 516
- References
- 0
- FWCI
- 17.78
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: The Sensitivity of Clays. https://app.cochat.ai/papers/10.1680/geot.1952.3.1.30
- The paper
- Skemption, A. W., & Northey, R. D. (1952). The Sensitivity of Clays. Géotechnique. https://doi.org/10.1680/geot.1952.3.1.30
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.