The DOI matches its Crossref record; 21 of the 21 references it cites were found in a registry or an index.
Earthquake Fault Scaling: Self-Consistent Relating of Rupture Length, Width, Average Displacement, and Moment Release
Abstract
In this paper, I propose the scaling relation W = C 1 L β (where β ≈2/3) to describe the scaling of rupture width with rupture length. I also propose a new displacement relation ![Graphic][1] , where A is the area ( LW ). By substituting these equations into the definition of seismic moment (![Graphic][2] ), I have developed a series of self-consistent equations that describe the scaling between seismic moment, rupture area, length, width, and average displacement. In addition to β , the equations have only two variables, C 1 and C 2, which have been estimated empirically for different tectonic settings. The relations predict linear log–log relationships, the slope of which depends only on β . These new scaling relations, unlike previous relations, are self-consistent, in that they enable moment, rupture length, width, area, and displacement to be estimated from each other and with these estimates all being consistent with the definition of seismic moment. I interpret C 1 as depending on the size at which a rupture transitions from having a constant aspect ratio to following a power law and C 2 as depending on the displacement per unit area of fault rupture and so static stress drop. It is likely that these variables differ between tectonic environments; this might explain much of the scatter in the empirical data. I suggest that these relations apply to all faults. For small earthquakes ( M ∼5) earthquakes β =2/3, so L 2.5 applies. For dip-slip earthquakes this scaling applies up to the largest events. For very large ( M >∼7.2) strike-slip earthquakes, which are fault width-limited, β =0 and assuming ![Graphic][3] , then L 1.5 scaling applies. In all cases, M ∝ A 1.5 fault scaling applies. [1]: /embed/inline-graphic-1.gif [2]: /embed/inline-graphic-2.gif [3]: /embed/inline-graphic-3.gif
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
A new look at the statistical model identification
Akaike, H. (1974) · IEEE Transactions on Automatic Control · doi:10.1109/tac.1974.1100705 · Cited by 51,879
Wells, D. L., & Coppersmith, K. J. (1994) · Bulletin of the Seismological Society of America · doi:10.1785/bssa0840040974 · Cited by 7,753
New, improved version of generic mapping tools released
Wessel, P., & Smith, W. H. F. (1998) · Eos, Transactions American Geophysical Union · doi:10.1029/98eo00426 · Cited by 7,309
Tectonic stress and the spectra of seismic shear waves from earthquakes
Brune, J. N. (1970) · Journal of Geophysical Research · doi:10.1029/jb075i026p04997 · Cited by 5,242
Hanks, T. C., & Kanamori, H. (1979) · Journal of Geophysical Research: Solid Earth · doi:10.1029/jb084ib05p02348 · Cited by 4,024
The mechanics of earthquakes and faulting
(1990) · Choice Reviews Online · doi:10.5860/choice.28-1579 · Cited by 3,569
Theoretical basis of some empirical relations in seismology
Kanamori, H., & Anderson, D. L. (1975) · CaltechAUTHORS (California Institute of Technology) · doi:10.1785/bssa0650051073 · Cited by 2,878
The energy release in great earthquakes
Kanamori, H. (1977) · Journal of Geophysical Research · doi:10.1029/jb082i020p02981 · Cited by 2,477
Peitgen, H.-O., Jürgens, H., & Saupe, D. (2004) · doi:10.1007/b97624 · Cited by 1,534
Mammalian basal metabolic rate is proportional to body mass 2/3
White, C. R., & Seymour, R. S. (2003) · Proceedings of the National Academy of Sciences · doi:10.1073/pnas.0436428100 · Cited by 720
Leonard, M. (2010) · Bulletin of the Seismological Society of America · doi:10.1785/0120090189 · Cited by 714
Self-citationScaling relations for earthquake source parameters and magnitudes
Geller, R. J. (1976) · CaltechAUTHORS (California Institute of Technology) · doi:10.1785/bssa0660051501 · Cited by 562
Source parameters of southern California earthquakes
Thatcher, W. R., & Hanks, T. C. (1973) · Journal of Geophysical Research Atmospheres · doi:10.1029/jb078i035p08547 · Cited by 503
Does apparent stress vary with earthquake size?
Ide, S., & Beroza, G. C. (2001) · Geophysical Research Letters · doi:10.1029/2001gl013106 · Cited by 491
Source Scaling Properties from Finite-Fault-Rupture Models
Mai, P. M. (2000) · Bulletin of the Seismological Society of America · doi:10.1785/0119990126 · Cited by 376
Earthquake stress drops, ambient tectonic stresses and stresses that drive plate motions
Hanks, T. C. (1977) · pure and applied geophysics · doi:10.1007/bf01637120 · Cited by 371
Earthquake scaling, fault segmentation, and structural maturity
Manighetti, I., Campillo, M., Bouley, S., & Cotton, F. (2007) · Earth and Planetary Science Letters · doi:10.1016/j.epsl.2006.11.004 · Cited by 341
Tsunami Source of the 2004 Sumatra–Andaman Earthquake Inferred from Tide Gauge and Satellite Data
Fujii, Y., & Satake, K. (2007) · Bulletin of the Seismological Society of America · doi:10.1785/0120050613 · Cited by 282
A model for the wind-blown flame from a line fire☆
Albini, F. A. (1981) · Combustion and Flame · doi:10.1016/0010-2180(81)90014-6 · Cited by 150
Reliable estimation of the seismic moment of large earthquakes.
Abe, K. (1975) · Journal of Physics of the Earth · doi:10.4294/jpe1952.23.381 · Cited by 104
The 2/3 Power Law Dependence of Capillary Force on Normal Load in Nanoscopic Friction
Riedo, E., Palaci, I., Boragno, C., & Brune, H. (2004) · The Journal of Physical Chemistry B · doi:10.1021/jp0360624 · Cited by 50
Cited by
A geodetic plate motion and Global Strain Rate Model
Kreemer, C., Blewitt, G., & Klein, E. C. (2014) · Geochemistry, Geophysics, Geosystems · doi:10.1002/2014gc005407 · Cited by 1,013
The 2013 European Seismic Hazard Model: key components and results
The SHARE Consortium, Woessner, J., Laurentiu, D., Giardini, D., Crowley, H., Cotton, F., Grünthal, G., Valensise, G., Arvidsson, R., Basili, R., et al. (2015) · Bulletin of Earthquake Engineering · doi:10.1007/s10518-015-9795-1 · Cited by 603
Flash vaporization during earthquakes evidenced by gold deposits
Weatherley, D. K., & Henley, R. W. (2013) · Nature Geoscience · doi:10.1038/ngeo1759 · Cited by 347
Analysis of induced seismicity in geothermal reservoirs – An overview
Zang, A., Oye, V., Jousset, P., Deichmann, N., Gritto, R., McGarr, A., Majer, E., & Bruhn, D. (2014) · Geothermics · doi:10.1016/j.geothermics.2014.06.005 · Cited by 328
Metadata
- Authors
- Leonard, M.
- Venue
- Bulletin of the Seismological Society of America
- Published
- 2012-12-01
- Volume
- 102
- Issue
- 6
- Pages
- 2797-2797
- ISSN
- 0037-1106 (ISSN-L)
- OpenAlex
- W2106946428
- Cited by
- 282
- References
- 21
- FWCI
- 43.65
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.