Student or educator? Sign up with your school email and get 6 months of Pro free.
Cited by 206

The DOI matches its Crossref record.

Bacteriogenic Mineral Plugging

Ferris, F.G., Stehmeier, L.G., Kantzas, A., Mourits, F.M.·1996·Journal of Canadian Petroleum Technology

Abstract

A novel permeability reduction process has been developed to control fluid flow in porous media. The procedure generally involves use of bacteria to actively precipitate calcium carbonate as a mineral plugging and cementing agent. This process may be suitably employed to enhance the recovery of oil from oil reservoirs, cement unconsolidated sand underground, or to control the flow of contaminants in an aquifer. Introduction: In heavy oil fields, water responds to pumping more readily than viscous oil, so wells on primary production commonly waterout after low recoveries of the oil-in-place. This is a serious problem that can occur gradually over several years, or be a catastrophic event when water directly underlies the oil bearing zone. For both of these situations, control of excess water production may be accomplished by selectively plugging zones of water encroachment(1,2). A number of selective plugging systems for reservoir conformance correction have been developed. Chemically cross-linked polymers are available for use, but are expensive in pure form and perform unpredictably under reservoir conditions(3). Similarly, insoluble biopolymers and biomass generated by injected bacteria or by indigenous micro-organisms can be used to selectively plug off zones of high water permeability(1,4,5). The concept has been demonstrated in laboratory experiments; however, poor results have been obtained in field applications of microbial plugging systems(6). More recently, work has focussed on inorganically precipitated mineral plugs using polysulfides(7) or colloidal silica(8). This is expected to improve plug stability and extend use of the technology to more sophisticated production modes. The same advantages may be afforded by a novel bacteriogenic mineral plugging system developed to control fluid flow in porous media. Bacteriogenic mineral plugging involves using injected or indigenous rnicro-organisms to precipitate authigenic minerals in high permeability water channels. This can be accomplished by (i) using bacteria as passive nucleation sites while injecting an appropriate solution to oversaturate formation water with respect to a certain mineral phase, (ii) stimulating specific bacteria whose metabolic activity will bring about a mineral oversaturation, or (iii) a combination of the two processes. Precipitation of the mineral would be expected to selectively plug off the water bearing zones allowing oil production to continue (until further water breakthrough occurred). Of the various minerals that bacteria can precipitate, calcium carbonate is a particularly good candidate for bacteriogenic mineral plugging. Bacteria have been implicated as the causative agents for carbonate precipitation in a number of laboratory and field investigations(9–11). In addition, most heavy oil reservoir formation waters in Western Canada are near saturation with calcite(12). Consequently, stimulation of bacteria that generate alkaline conditions would promote an increase in carbonate concentrations and induce calcite precipitation(13). In this paper, experiments are described using bacteria to increase pH and precipitate calcium carbonate as a mineral plugging and cementing agent. Experimental: Materials: The bacterial strain used was Bacillus pasteurii NRS 673. Sand used for this work was number 16 silica. Whisling, Illinois. Analysis provided by the company indicated packed cores would have a 0.37 porosity with a permeability of 2.5 Darcies.

Overview

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.2118/96-08-06

Cites

Statistics

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cited by

See all 206

Metadata

Authors
Ferris, F. G., Stehmeier, L. G., Kantzas, A., & Mourits, F. M.
Venue
Journal of Canadian Petroleum Technology
Published
1996-08-01
Volume
35
Issue
08
ISSN
0021-9487 (ISSN-L)
OpenAlex
W4246731121
Cited by
206
References
0
FWCI
0.00
Type
journal article
Language
en
Open access
closed

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

How to cite

Cite CoChat for the checks on this page, and the paper for its own findings.

This page
CoChat. (2026). Citation check: Bacteriogenic Mineral Plugging. https://app.cochat.ai/papers/10.2118/96-08-06
The paper
Ferris, F. G., Stehmeier, L. G., Kantzas, A., & Mourits, F. M. (1996). Bacteriogenic Mineral Plugging. Journal of Canadian Petroleum Technology. https://doi.org/10.2118/96-08-06

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.