The DOI matches its Crossref record.
Factors Important in the Calculation of Hydraulic Conductivity
Abstract
The calculation of hydraulic conductivity by a modified Millington‐Quirk method with a matching factor gave conductivity values closely approximating experimentally measured values. The technique requires knowledge of the moisture characteristic and the saturated conductivity. A number of factors that affect the calculated values and improve the computational results were investigated. Calculated conductivity values decreased with an increasing number of pressure classes at low moisture contents. For all soils tested the calculated conductivities were less than the experimental values at the terminal point of the moisture characteristic. This discrepancy was partially corrected by a small change in the Millington‐Quirk equation, by extending the moisture characteristics to higher suction values, and by reducing the number of pressure classes to approximately 10. A matching factor, the ratio of measured over calculated saturated conductivity, was found necessary for obtaining the best fit of calculated and measured data. Two conductivity functions calculated separately from each moisture characteristic forming a hysteresis loop, converged as the hysteresis loop was translated to higher tensions. All computations were done by computer.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
A new model for predicting the hydraulic conductivity of unsaturated porous media
Mualem, Y. (1976) · Water Resources Research · doi:10.1029/wr012i003p00513 · Cited by 8,300
Hydraulic conductivity estimation for soils with heterogeneous pore structure
Durner, W. (1994) · Water Resources Research · doi:10.1029/93wr02676 · Cited by 1,175
Spatial variability of field-measured soil-water properties
Nielsen, D. R., Biggar, J. W., & Erh, K. T. (1973) · Hilgardia · doi:10.3733/hilg.v42n07p215 · Cited by 1,080
Predicting the permeability function for unsaturated soils using the soil-water characteristic curve
Fredlund, D. G., Xing, A., & Huang, S. (1994) · Canadian Geotechnical Journal · doi:10.1139/t94-062 · Cited by 970
Predicting the saturated hydraulic conductivity of soils: a review
Chapuis, R. P. (2012) · Bulletin of Engineering Geology and the Environment · doi:10.1007/s10064-012-0418-7 · Cited by 381
Metadata
- Authors
- Kunze, R. J., Uehara, G., & Graham, K.
- Venue
- Soil Science Society of America Journal
- Publisher
- Wiley
- Published
- 1968-11
- Volume
- 32
- Issue
- 6
- Pages
- 760-765
- ISSN
- 0361-5995 (ISSN-L)
- 1435-0661
- OpenAlex
- W2068362040
- Cited by
- 246
- References
- 0
- FWCI
- 11.53
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Factors Important in the Calculation of Hydraulic Conductivity. https://app.cochat.ai/papers/10.2136/sssaj1968.03615995003200060020x
- The paper
- Kunze, R. J., Uehara, G., & Graham, K. (1968). Factors Important in the Calculation of Hydraulic Conductivity. Soil Science Society of America Journal. https://doi.org/10.2136/sssaj1968.03615995003200060020x
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.