The DOI matches its Crossref record; 4 of the 4 references it cites were found in a registry or an index.
K content of the K-feldspars being measured in optical dating or in thermoluminescence dating
Open accessAbstract
Mejdahl (1983, 1985) suggested the use of separated potassium feldspars for dating, and showed the feasibility of this. We address here the question of what is the correct potassium content to use to evaluate the β dose rate from the potassium within the grains. Pure K-feldspar, KAlSi3O8, has 14.0 wt. % K. The grains in a sediment generally consist of a highly inhomogeneous collection and one can expect grains to be present with a range of K contents between 0 and 14%. The laboratory procedures designed to separate Kfeldspars are not perfect and usually result in the presence of other minerals such as quartz and plagioclase feldspars. The situation is further complicated by the fact that different mineral grains have different luminescence sensitivities and it is not unusual to find that most of the light that is being measured arises from a small fraction of the grains of an aliquot. The one observation that appears to make the problem tractable is that it is generally observed that there is a positive correlation between luminescence sensitivity and potassium content. Our approach to the problem has been to note that 14% is the maximum possible value of the K content, and that a minimum value can be determined from the average K content of the separated grains. The grains are separated using standard procedures. These are an HCl treatment to dissolve carbonates, sieving to select a grain size, a 6 minute HF etch to clean, but not dissolve the grains, an HCl treatment to dissolve precipitated fluorides, sieving to remove small fragments, selection of the < 2.58 g cm fraction using an aqueous solution of sodium polytungstate, and magnetic separation. After optical dating measurements the grains are recovered and about 0.3 g sent for commercial atomic-absorption analysis; the K contents so obtained for a variety of samples are given in the table.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
THERMOLUMINESCENCE DATING: BETA‐DOSE ATTENUATION IN QUARTZ GRAINS
MEJDAHL, V. (1979) · Archaeometry · doi:10.1111/j.1475-4754.1979.tb00241.x · Cited by 919
Optical dating: Preliminary results on the anomalous fading of luminescence from feldspars
Spooner, N. A. (1992) · Quaternary Science Reviews · doi:10.1016/0277-3791(92)90055-d · Cited by 136
Optical Dating of Tsunami-Laid Sands
Huntley, D. J., & Clague, J. J. (1996) · Quaternary Research · doi:10.1006/qres.1996.0053 · Cited by 125
Self-citationThree-dimensional thermoluminescence spectra of feldspars
Prescott, J. R., & Fox, P. J. (1993) · Journal of Physics D Applied Physics · doi:10.1088/0022-3727/26/12/024 · Cited by 77
Cited by
Laboratory fading rates of various luminescence signals from feldspar-rich sediment extracts
Thomsen, K. J., Murray, A. S., Jain, M., & Bøtter-Jensen, L. (2008) · Radiation Measurements · doi:10.1016/j.radmeas.2008.06.002 · Cited by 855
DRAC: Dose Rate and Age Calculator for trapped charge dating
Durcan, J. A., King, G. E., & Duller, G. A. T. (2015) · Quaternary Geochronology · doi:10.1016/j.quageo.2015.03.012 · Cited by 798
A robust feldspar luminescence dating method for Middle and LatePleistocene sediments
Buylaert, J., Jain, M., Murray, A. S., Thomsen, K. J., Thiel, C., & Sohbati, R. (2012) · Boreas · doi:10.1111/j.1502-3885.2012.00248.x · Cited by 770
Testing the potential of an elevated temperature IRSL signal from K-feldspar
Buylaert, J. P., Murray, A. S., Thomsen, K. J., & Jain, M. (2009) · Radiation Measurements · doi:10.1016/j.radmeas.2009.02.007 · Cited by 679
Neandertal roots: Cranial and chronological evidence from Sima de los Huesos
Arsuaga, J. L., Martínez, I., Arnold, L. J., Aranburu, A., Gracia-Téllez, A., Sharp, W. D., Quam, R. M., Falguères, C., Pantoja-Pérez, A., Bischoff, J., et al. (2014) · Science · doi:10.1126/science.1253958 · Cited by 534
Metadata
- Authors
- Huntley, D. J., & Baril, M. R.
- Venue
- Ancient TL
- Published
- 1997-06-15
- Volume
- 15
- Issue
- 1
- Pages
- 11-13
- ISSN
- 2693-0935 (ISSN-L)
- OpenAlex
- W2339614114
- Cited by
- 668
- References
- 4
- FWCI
- 0.97
- Type
- journal article
- Language
- en
- Open access
- hybrid
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.