The DOI matches its Crossref record; 6 of the 6 references it cites were found in a registry or an index.
Efflorescence of Alkali-Activated Cements (Geopolymers) and the Impacts on Material Structures: A Critical Analysis
Open accessAbstract
Even with the rapid development of the alkali-activated cement (AAC) technology in the past few years, it still needs to be better understood some phenomena that may alter the durability of the material. In many industrial uses and laboratory researches was observed the formation of the salts on the surfacealkali-activated type cements, which was identified as efflorescence. This occurs due to the presence of an alkali transported in contact with the humidity and CO2 environment. It may present externally from the formation of salts on the surface and internally with the carbonation of the alkalis in capillary pores. The effects of efflorescence on the material in use, as well as all factors that can influence its formation are not yet fully understood. This paper presents a critical review about this issue from previous reports (which are very limited in fact, compared with the increasing number of papers and reports on AACs published in the recent years) and scientific knowledge of this physicochemical phenomena.To understand the nature of efflorescence, upon which proper methods of minimising of this issue can be based, the following aspects are discussed and re-examined: (1) the development of efflorescences in PC concrete, (2) the role of alkalis in AACs (3) efflorescence in AACs and (4) effect from physical and microstructural point of view of efflorescences on the ACCs. This paper highlights that the nature of the pore structure and the design parameters (such as alkali concentration, presence of soluble silicates and water content in the activator) are the two most important factors that control efflorescence rate and changes in mechanical behaviour.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Costs and carbon emissions for geopolymer pastes in comparison to ordinary portland cement
McLellan, B. C., Williams, R. P., Lay, J., van Riessen, A., & Corder, G. D. (2011) · Journal of Cleaner Production · doi:10.1016/j.jclepro.2011.02.010 · Cited by 1,949
Technical and commercial progress in the adoption of geopolymer cement
Van Deventer, J. S. J., Provis, J. L., & Duxson, P. (2012) · Minerals Engineering · doi:10.1016/j.mineng.2011.09.009 · Cited by 820
Review on carbonation curing of cement-based materials
Zhang, D., Ghouleh, Z., & Shao, Y. (2017) · Journal of CO2 Utilization · doi:10.1016/j.jcou.2017.07.003 · Cited by 809
Effect of Curing Temperature and Silicate Concentration on Fly-Ash-Based Geopolymerization
Sindhunata, van Deventer, J. S. J., Lukey, G. C., & Xu, H. (2006) · Industrial & Engineering Chemistry Research · doi:10.1021/ie051251p · Cited by 390
Real-time investigation of reaction rate and mineral phase modifications of lime carbonation
Cizer, Ö., Van Balen, K., Elsen, J., & Van Gemert, D. (2012) · Construction and Building Materials · doi:10.1016/j.conbuildmat.2012.04.036 · Cited by 187
29Si, 27Al, 1H and 23Na MAS NMR study of the bonding character in aluminosilicate inorganic polymers
Rowles, M. R., Hanna, J. V., Pike, K. J., Smith, M. E., & O'Connor, B. H. (2007) · Applied Magnetic Resonance · doi:10.1007/s00723-007-0043-y · Cited by 173
Cited by
Advances in alkali-activation of clay minerals
Khalifa, A. Z., Cizer, Ö., Pontikes, Y., Heath, A., Patureau, P., Bernal, S. A., & Marsh, A. T. M. (2020) · Cement and Concrete Research · doi:10.1016/j.cemconres.2020.106050 · Cited by 436
Recent progress in understanding setting and hardening of alkali-activated slag (AAS) materials
Jiang, D., Shi, C., & Zhang, Z. (2022) · Cement and Concrete Composites · doi:10.1016/j.cemconcomp.2022.104795 · Cited by 165
Self-citation
Metadata
- Authors
- Longhi, M. A., Zhang, Z., Rodríguez, E. D., Kirchheim, A. P., & Wang, H.
- Venue
- Frontiers in Materials
- Publisher
- Frontiers Media SA
- Published
- 2019-04-30
- Volume
- 6
- ISSN
- 2296-8016 (ISSN-L)
- OpenAlex
- W2943435212
- Cited by
- 177
- References
- 6
- FWCI
- 11.40
- Type
- journal article
- Language
- en
- Open access
- gold
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.