Adsorption Performance of Physically Activated Biochars for Postcombustion CO2 Capture from Dry and Humid Flue Gas
Open accessThe DOI matches its Crossref record; 32 of the 32 references it cites were found in a registry or an index.
Abstract
In the present study, the performance of four biomass-derived physically activated biochars for dynamic CO2 capture was assessed. Biochars were first produced from vine shoots and wheat straw pellets through slow pyrolysis (at pressures of 0.1 and 0.5 MPa) and then activated with CO2 (at 0.1 MPa and 800 °C) up to different degrees of burn-off. Cyclic adsorption-desorption measurements were conducted under both dry and humid conditions using a packed-bed of adsorbent at relatively short residence times of the gas phase (12–13 s). The adsorbent prepared from the vine shoots-derived biochar obtained by atmospheric pyrolysis, which showed the most hierarchical pore size distribution, exhibited a good and stable performance under dry conditions and at an adsorption temperature of 50 °C, due to the enhanced CO2 adsorption and desorption rates. However, the presence of relatively high concentrations of water vapor in the feeding gas clearly interfered with the CO2 adsorption mechanism, leading to significantly shorter breakthrough times. In this case, the highest percentages of a used bed were achieved by one of the other activated biochars tested, which was prepared from the wheat straw-derived biochar obtained by pressurized pyrolysis.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Figures







Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
The source backs part of the claim, not all of it — or backs it for a different population, condition or comparison.
In the citing paper
“whilst the high relative humidity exhibited a negative effect on CO2 capture ability and breakthrough time in both wheat straw and vine shoots derived biochars [31].”
From Direct air capture of CO2 by KOH-activated bamboo biochar (2022) · cites this paper as [31]
Experimental — accuracy not yet measuredThe cited source says what the claim attributes to it.
In the citing paper
“The studies report that moisture is unfavorable for CO2 capture using non-modified biochar [31,38].”
From Direct air capture of CO2 by KOH-activated bamboo biochar (2022) · cites this paper as [31]
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Carbon-Based Adsorbents for Postcombustion CO 2 Capture: A Critical Review
Creamer, A. E., & Gao, B. (2016) · Environmental Science & Technology · doi:10.1021/acs.est.6b00627 · Cited by 598
Enhanced CO2 Capture Capacity of Nitrogen-Doped Biomass-Derived Porous Carbons
Chen, J., Yang, J., Hu, G., Hu, X., Li, Z., Shen, S., Radosz, M., & Fan, M. (2016) · ACS Sustainable Chemistry & Engineering · doi:10.1021/acssuschemeng.5b01425 · Cited by 419
Water adsorption on carbon - A review
Liu, L., Tan, S. (., Horikawa, T., Do, D. D., Nicholson, D., & Liu, J. (2017) · Advances in Colloid and Interface Science · doi:10.1016/j.cis.2017.10.002 · Cited by 366
CO2 adsorption at nitrogen-doped carbons prepared by K2CO3 activation of urea-modified coconut shell
Yue, L., Xia, Q., Wang, L., Wang, L., DaCosta, H., Yang, J., & Hu, X. (2018) · Journal of Colloid and Interface Science · doi:10.1016/j.jcis.2017.09.040 · Cited by 364
A new MOF-505@GO composite with high selectivity for CO2/CH4 and CO2/N2 separation
Chen, Y., Lv, D., Wu, J., Xiao, J., Xi, H., Xia, Q., & Li, Z. (2017) · Chemical Engineering Journal · doi:10.1016/j.cej.2016.09.138 · Cited by 325
Coromina, H. M., Walsh, D. A., & Mokaya, R. (2016) · Journal of Materials Chemistry A · doi:10.1039/c5ta09202g · Cited by 321
Sustainable biomass-based carbon adsorbents for post-combustion CO2 capture
González, A. S., Plaza, M. G., Rubiera, F., & Pevida, C. (2013) · Chemical Engineering Journal · doi:10.1016/j.cej.2013.06.118 · Cited by 280 · cited 5×
“The IAST-based method requires as inputs the fitted adsorption isotherms for a given model (e.g., Toth [11], Sips [13], and dual site Langmuir–Freundlich [23]).”
BackgroundInfluentialActivated carbons prepared from hydrothermally carbonized waste biomass used as adsorbents for CO2
Hao, W., Björkman, E., Lilliestråle, M., & Hedin, N. (2013) · Applied Energy · doi:10.1016/j.apenergy.2013.02.028 · Cited by 277 · cited 1×
“This finding is consistent with the highest ultra-micropore volume (Vultra) reported in Table 3 for this activated biochar (which also exhibited the lowest burn-off degree), since many studies have reported that the CO2 uptake at absolute pressures of 5–15 kPa is mainly dependent on the availability of ultra-micropore…”
ResultDeng, S., Wei, H., Chen, T., Wang, B., Huang, J., & Yu, G. (2014) · Chemical Engineering Journal · doi:10.1016/j.cej.2014.04.115 · Cited by 273
High-performance CO2 sorbents from algae
Sevilla, M., Falco, C., Titirici, M.-M., & Fuertes, A. B. (2012) · RSC Advances · doi:10.1039/c2ra22552b · Cited by 269
Cited by
Advancements in CO2 capture by absorption and adsorption: A comprehensive review
Soo, X. Y. D., Lee, J. J. C., Wu, W.-Y., Tao, L., Wang, C., Zhu, Q., & Bu, J. (2024) · Journal of CO2 Utilization · doi:10.1016/j.jcou.2024.102727 · Cited by 509
Amalina, F., Razak, A. S. A., Krishnan, S., Sulaiman, H., Zularisam, A. W., & Nasrullah, M. (2022) · Journal of Hazardous Materials Advances · doi:10.1016/j.hazadv.2022.100134 · Cited by 349
Amalina, F., Razak, A. S. A., Krishnan, S., Zularisam, A. W., & Nasrullah, M. (2022) · Cleaner Materials · doi:10.1016/j.clema.2022.100045 · Cited by 222
Ravindiran, G., Rajamanickam, S., Janardhan, G., Hayder, G., Alagumalai, A., Mahian, O., Lam, S. S., & Sonne, C. (2024) · Biochar · doi:10.1007/s42773-024-00350-1 · Cited by 192
Carbon Capture Technologies: A Review on Technology Readiness Level
Hekmatmehr, H., Esmaeili, A., Pourmahdi, M., Atashrouz, S., Abedi, A., Ali Abuswer, M., Nedeljkovic, D., Latifi, M., Farag, S., & Mohaddespour, A. (2024) · Fuel · doi:10.1016/j.fuel.2024.130898 · Cited by 189
Metadata
- Authors
- Manyà, J. J., García-Morcate, D., & González, B.
- Affiliations
- Universidad de Zaragoza (ES)
- Corresponding author
- Manyà, Joan J.
- Venue
- Applied Sciences
- Publisher
- MDPI AG
- Published
- 2020-01-03
- Volume
- 10
- Issue
- 1
- Pages
- 376
- ISSN
- 2076-3417 (ISSN-L)
- OpenAlex
- W2997774688
- Cited by
- 66
- References
- 32
- Citations by year
- 2026: 19 · 2025: 13 · 2024: 12 · 2023: 7 · 2022: 11 · 2021: 3 · 2020: 1
- FWCI
- 2.71
- Type
- journal article
- Language
- en
- Open access
- gold
- dx.doi.org
- Licence
- Locations
- Applied Sciences (publishedVersion, cc-by)
- DOAJ (DOAJ: Directory of Open Access Journals) (submittedVersion)
- Zaguan (University of Zaragoza Repository) (submittedVersion, cc-by)
- Zenodo (CERN European Organization for Nuclear Research) (submittedVersion, cc-by)
- Funders
- Ministerio de Ciencia, Innovación y Universidades (PCIN-2017-048)
- Topics
- Physical Sciences › Chemical Engineering › Filtration and Separation › Carbon Dioxide Capture Technologies
- Physical Sciences › Energy › Fuel Technology › Thermochemical Biomass Conversion Processes
- Physical Sciences › Environmental Science › Environmental Engineering › Industrial Gas Emission Control
- Keywords
- CO2 adsorption, post-combustion CO2 capture, biomass-derived biochar, wheat straw biochar, pressurized pyrolysis, CO2 activation, water vapor interference, breakthrough time, fixed-bed adsorption, hierarchical porous structure, biomass pellets
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Adsorption Performance of Physically Activated Biochars for Postcombustion CO2 Capture from Dry and Humid Flue Gas. https://app.cochat.ai/papers/10.3390/app10010376
- The paper
- Manyà, J. J., García-Morcate, D., & González, B. (2020). Adsorption Performance of Physically Activated Biochars for Postcombustion CO2 Capture from Dry and Humid Flue Gas. Applied Sciences. https://doi.org/10.3390/app10010376
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.