CoChat

Production of Biochar from Plantain Rachis and Cassava Peel Towards Sustainable Management of Caribbean Agricultural Waste

Open access

The DOI matches its Crossref record; 53 of the 54 references it cites were found in a registry or an index; 16 of the 68 sources its claims cite were checked for support.

Abstract

The Caribbean faces many environmental issues, and the mitigation and adaptation strategies to address the challenges of global warming are not sufficient in this geographical region. Considering that agriculture is a relevant activity in most countries around this region, our study proposes to enhance Caribbean waste management by transitioning to a sustainable and resilient process in the framework of a green, circular economy. The research has been focused on the thermochemical transformation of the typical residues of Caribbean farm products (plantain rachis, and cassava peel). Biochar samples were synthesized from these biomasses by the slow pyrolysis method at different temperatures (300 °C, 400 °C, and 500 °C). Biochar samples with a smooth surface were synthesized from plantain rachis biomass, while biochar samples with a porous surface were obtained from cassava peel biomass. At the same pyrolysis temperature, all biochar samples derived from plantain rachis exhibited higher production biochar yields than those biochar samples derived from cassava peel. The yield percentages were determined to be 65.7% and 62.0% at a pyrolysis temperature of 300 °C; 45.6% and 37.5% at 400 °C; and 33.7% and 25.4% at 500 °C, respectively. XRD measurements revealed that both biomass-derived biochar samples were found to be enriched with several compounds, such as kalicinite, arcanite, sylvite, CaO3Si, and MgO3Si, which vary according to the pyrolysis temperature. FTIR analysis revealed the presence of carbonyl and carboxyl functional groups on the surface of all biochar samples. However, only the aliphatic functional groups were observed on the surface of the biochar samples derived from cassava peel. These characteristics are of particular relevance due to their potential application in soil amendment or water remediation.

Overview

CoChat Summary

TL;DR

This study produced biochar from plantain rachis (PR) and cassava peel (CP) by slow pyrolysis at 300, 400, and 500 °C and characterized yield, morphology, elemental composition, crystalline phases, and surface functional groups. PR biochar had higher yields and smoother surfaces, while CP biochar was porous and CP-500 showed the most favorable properties for potential soil amendment or water remediation.

Key findings

  • Biochar yield decreased with increasing pyrolysis temperature for both feedstocks: PR yields were 65.7%, 45.6%, and 33.7% at 300, 400, and 500 °C; CP yields were 62.0%, 37.5%, and 25.4% at the same temperatures. At each temperature, PR biochar had higher yield than CP biochar.
  • PR biochar had a smooth surface with almost imperceptible porosity at 300 and 400 °C and holes >20 µm at 500 °C. CP biochar was porous, with pore diameters of 2.0–6.7 µm for CP-300, 1.3–5.7 µm for CP-400, and 1.2–3.0 µm for CP-500.
  • EDX showed carbon, oxygen, and potassium as the highest-concentration elements, with calcium, silicon, phosphorus, and magnesium also detected. Carbon and potassium proportions tended to increase with pyrolysis temperature in CP biochar, and potassium also increased with temperature in PR biochar.
  • XRD detected compounds including kalicinite, arcanite, sylvite, CaO3Si, and MgO3Si, varying by pyrolysis temperature. FTIR showed carbonyl and carboxyl groups on all biochar surfaces, while aliphatic functional groups were observed only on CP biochar.

Methods

  • Plantain rachis and cassava peel were collected from two small-scale farms in Palmar de Varela, Atlántico, Colombia; biomass was washed three times with deionized water and dried at 90 °C for 12 h.
  • Biochar was produced by slow pyrolysis in a muffle furnace under nitrogen flow (0.5 L/min) for 30 min at 300, 400, and 500 °C, with a heating rate of 15 °C/min; each experiment was repeated five times. Yield and moisture content were determined using ASTM D3173 and D3175.
  • Characterization included TGA from room temperature to 850 °C at 15 °C/min, SEM/EDX, XRD, and ATR-FTIR over 400–4000 cm⁻¹ with 16 scans per sample.

Limitations

  • The paper states that adsorption measurements are necessary to estimate an accurate average pore diameter in the biochar samples. It also notes that literature lacks consensus on the effect of pyrolysis temperature on biochar pore size, because feedstock strongly influences physical properties.
  • Evident from the text: no BET surface area, adsorption, or direct soil/water remediation experiments were performed; application claims are based on characterization and prior literature rather than tested performance.
  • Evident from the text: the study is limited to two local farms in one Colombian Caribbean locality and three pyrolysis temperatures, so broader feedstock and geographic variability are not assessed.

Model-written summary. Check it against the paper before relying on it.

Integrity signals

Registry

Crossref · 10.3390/pr13072059

Cites

53 of 53 references verified0 citation errors · 0 not checkable

Statistics

Nothing to recompute.

Verification

Claims the paper makes

12 Valid · 3 Not valid · 26 Not checked · 55 Own results and interpretations

41 more claims

Create a free account to see all 96 claims and every source verdict.

See all claims — free account
  • It may state two separate claims as one. 28
  • Probably not a substantial claim. 27
  • Borderline: one of the tests for a substantial claim is unclear. 1
  • The quote only partly states this claim. 1

Create a free account to see these claims.

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

Each contradiction between two passages listed here was confirmed by an independent check.

5 of 6 · the rest aren’t loaded

1 more finding

Create a free account to see every finding of this check.

See all findings — free account

Citations

Cites

Show all 53 references

Cited by

Metadata

Authors
Herazo, A. P., Zambrano, A., Marín, L., Mass, J., & Montenegro, D. N.
Affiliations
  • Universidad del Atlántico (CO)
  • Universidad del Valle (CO)
  • Universidad del Norte (CO)
Corresponding author
Montenegro, Diana Nathalie
Venue
Processes
Publisher
MDPI AG
Published
2025-06-29
Volume
13
Issue
7
Pages
2059
ISSN
2227-9717 (ISSN-L)
OpenAlex
W4411825723
Cited by
4
References
54
Citations by year
2026: 4
FWCI
0.98
Type
journal article
Language
en
Open access
Locations
Processes (publishedVersion, cc-by)
Topics
  • Physical Sciences › Energy › Fuel Technology › Thermochemical Biomass Conversion Processes
  • Physical Sciences › Environmental Science › Water Science and Technology › Adsorption and biosorption for pollutant removal
  • Life Sciences › Agricultural and Biological Sciences › Soil Science › Soil Carbon and Nitrogen Dynamics
Keywords
biochar, cassava peel, agricultural waste management, slow pyrolysis, pyrolysis temperature, biochar yield, surface functional groups, mineral composition, circular economy, soil amendment, water remediation, Caribbean agriculture

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

The claim verdicts this report counts are experimental: their accuracy is not yet measured.

A language model drew the claims from the paper on 2026-10-05, under version 3 of the claim definition (model deepseek-v4.1-flash, prompt extract-v3).

A second model labelled each claim on 2026-10-05 (model jev-1.13-20260917, definition revision gold-guideline-v0.2).

Cited sources are checked with a language model’s help (gpt-6-sol).

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.