The DOI matches its Crossref record.
Electron Metallography of Chemical Attack Upon Some Alloys Susceptible to Stress Corrosion Cracking
Abstract
The microstructures of deformed copper-gold, copper-aluminum, copper-zinc and magnesium-aluminum alloys were examined by transmission electron microscopy. These specimens were further examined after exposure to solutions which do and do not cause stress corrosion cracking. Exposure to "cracking" solutions resulted in a localized pitting or tubular form of attack, whereas the solutions which did not produce cracking caused a uniform surface roughening. When thin-foil specimens were deformed within the corrosive environments, the tubular attack and the surface roughening were observed to be enhanced in the regions of heavy deformation. Observations also indicated that for all the alloys investigated, static dislocations did not initiate chemical attack. In general, the pitting or tubular type of attack may be initiated at grain boundaries, antiphase boundary junctions in ordered copper-gold alloys, at precipitates and the substructure of twins in magnesium-aluminum alloys and at other sites which could not be identified. It was concluded that compositional rather than physical disturbances initiate preferential chemical attack on the surface of the alloys studied. For copper-gold alloys the superficial chemical disturbance can be as small as a six-atom cluster. Rates of pitting greater than 0.4 cm/hr can be attained for copper-gold alloys, which compares well with stress corrosion crack velocities. In the discussion of these results a new mechanism for transgranular stress corrosion is presented. It is proposed that when susceptible alloys are exposed to stress corrosion cracking environments a mechanically weak, pitted structure is produced along active slip planes, and that ductile fracture occurs through this corroded material. The chemical activity of the slip planes, which are believed to initiate the pitting attack, is discussed in relation to (a) the type of surface slip structure found in alloys where cross slip is difficult, (b) increase in solute atom concentration at the crack tip through the mass transfer of solute atoms to the surface by planar groups of moving dislocations, and (c) segregation and precipitation on slip planes. It was found that very fine precipitates, which are either an intermediate magnesium-aluminum phase or Mg17Al12, formed on the basal planes of quenched magnesium-1 or 7 atomic percent aluminum (<0.001 percent Fe, Cu or Ni) alloys when aged at room temperature. The presence of these precipitates was associated with the transgranular stress corrosion susceptibility of these alloys.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
Understanding Magnesium Corrosion—A Framework for Improved Alloy Performance
Song, G., & Atrens, A. (2003) · Advanced Engineering Materials · doi:10.1002/adem.200310405 · Cited by 2,056
Magnesium and Magnesium Alloys
Ghali, E. (2011) · Uhlig's Corrosion Handbook · doi:10.1002/9780470872864.ch58 · Cited by 460
A Critical Review of the Stress Corrosion Cracking (SCC) of Magnesium Alloys
Winzer, N., Atrens, A., Song, G., Ghali, E., Dietzel, W., Kainer, K. U., Hort, N., & Blawert, C. (2005) · Advanced Engineering Materials · doi:10.1002/adem.200500071 · Cited by 451
Nanoporous Metals for Catalytic and Optical Applications
Ding, Y., & Chen, M. (2009) · MRS Bulletin · doi:10.1557/mrs2009.156 · Cited by 415
Nanoporous gold: a new material for catalytic and sensor applications
Wittstock, A., Biener, J., & Bäumer, M. (2010) · Physical Chemistry Chemical Physics · doi:10.1039/c0cp00757a · Cited by 337
Metadata
- Authors
- Pickering, H. W., & Swann, P. R.
- Venue
- Corrosion
- Published
- 1963-11-01
- Volume
- 19
- Issue
- 11
- Pages
- 373t-389t
- ISSN
- 0010-9312 (ISSN-L)
- 1938-159X
- OpenAlex
- W2007357867
- Cited by
- 185
- References
- 0
- FWCI
- 12.70
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Electron Metallography of Chemical Attack Upon Some Alloys Susceptible to Stress Corrosion Cracking. https://app.cochat.ai/papers/10.5006/0010-9312-19.11.373
- The paper
- Pickering, H. W., & Swann, P. R. (1963). Electron Metallography of Chemical Attack Upon Some Alloys Susceptible to Stress Corrosion Cracking. Corrosion. https://doi.org/10.5006/0010-9312-19.11.373
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.