The DOI matches its Crossref record.
Vibration Monitoring of Rotating Machines Using MEMS Accelerometer
Open accessAbstract
Heavy industries face major problems since different types of mechanical failures can originate in rotating machines. Analytical approaches have demonstrated that vibration monitoring has tremendous potential in detecting and localizing defects in the machines. There are different technologies available for vibration sensing. Though MEMS accelerometer is slowly becoming an alternate method for vibration monitoring of rotating machines, yet it has not been fully explored for a much wider application base. This paper proposes the basic design for the development of a low cost MEMS accelerometer based vibration sensor by integrating the basic sensor and intelligence of vibration analysis, together. This module can easily be deployed for different rotating machines for vibration monitoring. Sensitivity of the sensor, effectiveness of the proposed intelligence in signal processing and their performance are tested for a 7.5KW, 3φ, 440V, 4 pole squirrel-cage induction motor. The experiments are carried out to check the ability to detect the fault frequency peaks under different fault combinations.The results presented here are found to be highly promising.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
The source backs part of the claim, not all of it — or backs it for a different population, condition or comparison.
In the citing paper
“It requires low processing power and provides superior sensitivity [41].”
From Vibration Analysis for Machine Monitoring and Diagnosis: A Systematic Review (2021) · cites this paper as [41]
Experimental — accuracy not yet measured
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Still being checked.
Research works printed but not linked: 17
- M. E. Elnady, J. K Sinha and S. O. Oyadiji, "Condition monitoring of rotating machines using on-shaft vibration measurement. In: Proceedings of the IMechE, 10th in- ternational conference on vibrations in rotating machin- ery, London, UK, 11-13 September 2012.
- A. Muszynska, "Vibrational Diagnostics of Rotating Machinery Malfunctions", International Journal of Ro- tating Machinery, vol1 Issue 3-4, pp 237-266, 1995
- J. K Sinha and K. Elbhbah "A future possibility of vibra- tion based condition monitoring of rotating machines", Mechanical Systems and Signal Processing, vol 34: pp 231-240, 2013.
- F. Jiang, W. Li, Z. Wang, and Z. Zhu, "Fault Severity Estima- tion of Rotating Machinery Based on Residual Signals," Advances in Mechanical Engineering, pp. 1-8, 2012.
- N. Tandon and A. Choudhury, "A review of vibration and acoustic measurement methods for the detection of defects in rolling element bearings," Tribology Interna- tional, vol. 32, pp. 469-480, 1999.
- W. R. Finley, M. M. Hodowanec, and W. G. Holter, "An analytical approach to solving motor vibration prob- lems," in IEEE-Ind. Appl. Society, 46th Annual Petrole- um and Chemical Industry Conf., Knoxville, TN, 13-15, pp. 217-232, Sept. 1999.
- G. Perrone and A. Vallan, "A low-cost optical sensor for noncontact vibration measurements," IEEE Transactions on Instrumentation and Measurement, vol. 58, no. 5, pp. 1650-1656, 2009.
- T. K. Gangopadhyay, "Prospects for Fiber Bragg grat- ings and Fabry-Perot interferometers in fiber-optic vibra- tion sensing," Sensors and Actuators A, vol. 113, no. 1, pp. 20-38, 2004.
- J.P Sebastia, J.A. Lluch, J.R. Vizcaino and J.S. Bellon, "Vibration Detector Based on GMR Sensors", IEEE Transactions on Instrumentation and Measurement, vol. 58, no.3, 2009, pp 707-712.
- A. Albarbar, S. Mekid, A. Starr, and R. Pietruszkiewicz, "Suitability of MEMS accelerometers for condition monitor- ing: An experimental study," Sensors (Basel), PMCID: PMC3672998, vol. 8, no. 2, pp. 784-799, 2008.
- H.Xie, G. Fedder, "CMOS z-axis capacitive accelerome- ter with comb-finger sensing". In Proc. IEEE Micro Elec- tro Mechanical Systems (MEMS), 2000; pp. 496-501.
- V. Biefeld, A. Buhrdorf and J. Binder, "Laterally driven ac- celerometer fabricated in single crystalline silicon", Sensor Actuators, vol. 82(1), 149-154, 2000.
- J. Sinha, "On Standardisation of Accelerometers". Journal of Sound and Vibration 2005, 286, 417-427.
- S. E. Lyshevski, "MEMS and NEMS: systems, devices and structures" CRC Press LLC, USA, 2002.
- H. Luo, G. Fedder, and L. Carley, "A 1 mg lateral CMOS- MEMS accelerometer," Proceedings IEEE Thirteenth Annu- al International Conference on Micro Electro Mechanical Systems, 2000.
- Yazdi, N.; Ayazi, F.; Najafi, K. "Micromachined inertial sensors", Proc. IEEE, Vol.86, no. 8, pp. 1640-1659, 1998.
- F. Mohn-Yasin, C. E. Korman, and D. J. Nagel, "Meas- urement of noise characteristics of MEMS accelerome- ters," Solid-State Electronics, vol. 47, pp. 357-360, 2003.
Cited by
Sorted by citations
Vibration Analysis for Machine Monitoring and Diagnosis: A Systematic Review
Mohd Ghazali, M. H., & Rahiman, W. (2021) · Shock and Vibration · doi:10.1155/2021/9469318 · Cited by 249
“MEMS accelerometer usually consists of movable proof mass with plates, supported by a mechanical suspension system to the frame [41].”
BackgroundMethodInfluentialScuro, C., Lamonaca, F., Porzio, S., Milani, G., & Olivito, R. S. (2021) · Construction and Building Materials · doi:10.1016/j.conbuildmat.2021.123092 · Cited by 136
Bedon, C., Bergamo, E., Izzi, M., & Noè, S. (2018) · Journal of Sensor and Actuator Networks · doi:10.3390/jsan7030030 · Cited by 120
Strauss, P., Schmitz, M., Wöstmann, R., & Deuse, J. (2018) · IEEE International Conference on Big Data (BigData) · doi:10.1109/bigdata.2018.8622076 · Cited by 89
RED: RFID-Based Eccentricity Detection for High-Speed Rotating Machinery
He, Y., Zheng, Y., Jin, M., Yang, S., Zheng, X., & Liu, Y. (2019) · IEEE Transactions on Mobile Computing · doi:10.1109/tmc.2019.2962770 · Cited by 40
Metadata
- Authors
- Bikash Chaudhury, S., Sengupta, M., & Mukherjee, K.
- Affiliations
- Indian Institute of Engineering Science and Technology, Shibpur (IN)
- ORCID
- Mukherjee, Kaushik
- Venue
- International Journal of Scientific Engineering and Research
- Published
- 2014-09-27
- Volume
- 2
- Issue
- 9
- Pages
- 5-11
- ISSN
- 2347-3878 (ISSN-L)
- OpenAlex
- W4405139749
- Cited by
- 38
- References
- 0
- Citations by year
- 2026: 3 · 2024: 3 · 2023: 5 · 2022: 2 · 2021: 7 · 2020: 4 · 2019: 4 · 2018: 3 · 2017: 3 · 2016: 4
- FWCI
- 2.60
- Type
- journal article
- Language
- en
- Open access
- hybrid
- doi.org
- Licence
- cc-by
- Locations
- International Journal of Scientific Engineering and Research (publishedVersion, cc-by)
- Topics
- Physical Sciences › Engineering › Control and Systems Engineering › Machine Fault Diagnosis Techniques
- Physical Sciences › Engineering › Control and Systems Engineering › Fault Detection and Control Systems
- Physical Sciences › Engineering › Civil and Structural Engineering › Structural Health Monitoring Techniques
- Keywords
- vibration monitoring, MEMS accelerometer, rotating machinery, fault detection, squirrel cage induction motor, signal processing, mechanical fault diagnosis
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Vibration Monitoring of Rotating Machines Using MEMS Accelerometer. https://app.cochat.ai/papers/10.70729/j2013358
- The paper
- Bikash Chaudhury, S., Sengupta, M., & Mukherjee, K. (2014). Vibration Monitoring of Rotating Machines Using MEMS Accelerometer. International Journal of Scientific Engineering and Research. https://doi.org/10.70729/j2013358
