The DOI matches its Crossref record; 3 of the 3 references it cites were found in a registry or an index.
Structural Origins of Silk Piezoelectricity
Open accessAbstract
Uniaxially oriented, piezoelectric silk films are prepared by a two‐step method that involves first air drying aqueous, regenerated silk fibroin solutions into films, and then drawing the silk films to a desired draw ratio. The utility of two different drawing techniques—zone drawing and water‐immersion drawing—is investigated for processing the silk for piezoelectric studies. Silk films zone drawn to a ratio of λ 5 2.7 display relatively high dynamic shear piezoelectric coefficients of d14 5 –1.5 pC N 21, corresponding to an increase in d14 of over two orders of magnitude due to film drawing. A strong correlation is observed between the increase in silk II, β‐sheet content with increasing draw ratio as measured by FTIR spectroscopy (Cb $ \propto $ e 2.5 λ), the concomitant increasing degree of orientation of β‐sheet crystals detected via wide‐angle X‐ray diffraction (full width half maximum (FWHM) = 0.22° for λ = 2.7), and the improvement in silk piezoelectricity (d14 $ \propto $ e 2.4 λ). Water‐immersion drawing leads to a predominantly silk I structure with a low degree of orientation (FWHM 5 75°) and a much weaker piezoelectric response compared to zone drawing. Similarly, increasing the β‐sheet crystallinity without inducing crystal alignment, e.g., by methanol treatment, does not result in a significant enhancement of silk piezoelectricity. Overall, a combination of a high degree of silk II, β‐sheet crystallinity and crystalline orientation are prerequisites for a strong piezoelectric effect in silk. Further understanding of the structural origins of silk piezoelectricity provides important options for future biotechnological and biomedical applications of this protein.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Altman, G. H., Diaz, F., Jakuba, C., Calabro, T., Horan, R. L., Chen, J., Lu, H., Richmond, J., & Kaplan, D. L. (2003) · Biomaterials · doi:10.1016/s0142-9612(02)00353-8 · Cited by 3,458
Self-citationInoue, S., Tanaka, K., Arisaka, F., Kimura, S., Ohtomo, K., & Mizuno, S. (2000) · Journal of Biological Chemistry · doi:10.1074/jbc.m006897200 · Cited by 784
Dynamic protein–water relationships during β-sheet formation
Hu, X., Kaplan, D., & Cebe, P. (2008) · Macromolecules · doi:10.1021/ma071551d · Cited by 315
Self-citation
Cited by
Liu, H., Zhong, J., Lee, C., Lee, S.-W., & Lin, L. (2018) · Applied Physics Reviews · doi:10.1063/1.5074184 · Cited by 905
Piezoelectric Biomaterials for Sensors and Actuators
Chorsi, M. T., Curry, E. J., Chorsi, H. T., Das, R., Baroody, J., Purohit, P. K., Ilies, H., & Nguyen, T. D. (2019) · Advanced Materials · doi:10.1002/adma.201802084 · Cited by 865
Piezoelectric materials for flexible and wearable electronics: A review
Wu, Y., Ma, Y., Zheng, H., & Ramakrishna, S. (2021) · Materials & Design · doi:10.1016/j.matdes.2021.110164 · Cited by 521
Piezoelectric materials as stimulatory biomedical materials and scaffolds for bone repair
Tandon, B., Blaker, J. J., & Cartmell, S. H. (2018) · Acta Biomaterialia · doi:10.1016/j.actbio.2018.04.026 · Cited by 420
Wafer-scale heterostructured piezoelectric bio-organic thin films
Yang, F., Li, J., Long, Y., Zhang, Z., Wang, L., Sui, J., Dong, Y., Wang, Y., Taylor, R., Ni, D., et al. (2021) · Science · doi:10.1126/science.abf2155 · Cited by 370
Metadata
- Authors
- Yucel, T., Cebe, P., & Kaplan, D. L.
- Venue
- Advanced Functional Materials
- Publisher
- Wiley
- Published
- 2011-01-13
- Volume
- 21
- Issue
- 4
- Pages
- 779-785
- ISSN
- 1616-301X (ISSN-L)
- 1616-3028
- OpenAlex
- W1975454520
- Cited by
- 212
- References
- 3
- FWCI
- 0.74
- Type
- journal article
- Language
- en
- Open access
- green
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Structural Origins of Silk Piezoelectricity. https://app.cochat.ai/papers/10.1002/adfm.201002077
- The paper
- Yucel, T., Cebe, P., & Kaplan, D. L. (2011). Structural Origins of Silk Piezoelectricity. Advanced Functional Materials. https://doi.org/10.1002/adfm.201002077
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.