The DOI matches its Crossref record; 23 of the 23 references it cites were found in a registry or an index.
CO2 capture from dry flue gas by vacuum swing adsorption: A pilot plant study
Abstract
The capture and concentration of CO 2 from a dry flue gas by vacuum swing adsorption (VSA) has been experimentally demonstrated in a pilot plant. The pilot plant has the provision for using two coupled columns that are each packed with approximately 41 kg of Zeochem zeolite 13X. Breakthrough experiments were first carried out by perturbing a N 2 saturated bed with 15% CO 2 and 85% N 2 feed, which is representative of a dry flue gas from coal‐fired power plants. The breakthrough results showed long plateaus in temperature profiles confirming a near adiabatic behavior. In the process study, a basic four‐step vacuum swing adsorption (VSA) cycle comprising the following steps: pressurization with feed, adsorption, forward blowdown, and reverse evacuation was investigated first. In the absence of any coupling among the steps, a single bed was used. With this cycle configuration, CO 2 was concentrated to 95.9 ± 1% with a recovery of 86.4 ± 5.6%. To improve the process performance, a four‐step cycle with light product pressurization (LPP) using two beds was investigated. This cycle was able to achieve 94.8 ± 1% purity and 89.7 ± 5.6% recovery. The Department of Energy requirements are 95% purity and 90% recovery. The proposed underlying physics of performance improvement of the four‐step cycle with LPP has also been experimentally validated. The pilot plant results were then used for detailed validation of a one‐dimensional, nonisothermal, and nonisobaric model. Both transient profiles of various measured variables and cyclic steady state performance results were compared with the model predictions, and they were in good agreement. The energy consumptions in the pilot plant experiments were 339–583 ± 36.7 kWh tonne−1 CO 2 captured and they were significantly different from the theoretical power consumptions obtained from isentropic compression calculations. The productivities were 0.87–1.4 ± 0.07 tonne CO 2 m−3 adsorbent day−1. The results from our pilot plant were also compared with available results from other pilot plant studies on CO 2 capture from flue gas. © 2014 American Institute of Chemical Engineers AIChE J, 60: 1830–1842, 2014
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Carbon capture and storage: how green can black be
Haszeldine, R. S. (2009) · Science · doi:10.1126/science.1172246 · Cited by 2,021
Separation of CO2 from Flue Gas: A Review
Aaron, D., & Tsouris, C. (2005) · Separation Science and Technology · doi:10.1081/ss-200042244 · Cited by 1,525
Glueckauf, E. (1955) · Trans. Faraday Soc. · doi:10.1039/tf9555101540 · Cited by 967
Purification of Hydrogen by Pressure Swing Adsorption
SIRCAR, S., & GOLDEN, T. C. (2000) · Separation Science and Technology · doi:10.1081/ss-100100183 · Cited by 570
Analysis and Status of Post-Combustion Carbon Dioxide Capture Technologies
Bhown, A. S., & Freeman, B. C. (2011) · Environmental Science & Technology · doi:10.1021/es104291d · Cited by 489
Steeneveldt, R., Berger, B., & Torp, T. A. (2006) · Chemical Engineering Research and Design · doi:10.1205/cherd05049 · Cited by 424
Ebner, A. D., & Ritter, J. A. (2009) · Separation Science and Technology · doi:10.1080/01496390902733314 · Cited by 301
Zhang, J., Webley, P. A., & Xiao, P. (2008) · Energy Conversion and Management · doi:10.1016/j.enconman.2007.06.007 · Cited by 298
Haghpanah, R., Majumder, A., Nilam, R., Rajendran, A., Farooq, S., Karimi, I. A., & Amanullah, M. (2013) · Industrial & Engineering Chemistry Research · doi:10.1021/ie302658y · Cited by 287
Self-citationCapture of CO2 from flue gas streams with zeolite 13X by vacuum-pressure swing adsorption
Xiao, P., Zhang, J., Webley, P., Li, G., Singh, R., & Todd, R. (2008) · Adsorption · doi:10.1007/s10450-008-9128-7 · Cited by 248
Technology for removing carbon dioxide from power plant flue gas by the physical adsorption method
Ishibashi, M., Ota, H., Akutsu, N., Umeda, S., Tajika, M., Izumi, J., Yasutake, A., Kabata, T., & Kageyama, Y. (1996) · Energy Conversion and Management · doi:10.1016/0196-8904(95)00279-0 · Cited by 200
Maring, B. J., & Webley, P. A. (2013) · International Journal of Greenhouse Gas Control · doi:10.1016/j.ijggc.2013.01.009 · Cited by 183
A superstructure‐based optimal synthesis of PSA cycles for post‐combustion CO2 capture
Agarwal, A., Biegler, L. T., & Zitney, S. E. (2010) · AIChE Journal · doi:10.1002/aic.12107 · Cited by 182
Cycle synthesis and optimization of a VSA process for postcombustion CO2 capture
Haghpanah, R., Nilam, R., Rajendran, A., Farooq, S., & Karimi, I. A. (2013) · AIChE Journal · doi:10.1002/aic.14192 · Cited by 174
Self-citationPropane/Propylene Separation by Pressure Swing Adsorption Using Zeolite 4A
Grande, C. A., & Rodrigues, A. E. (2005) · Industrial & Engineering Chemistry Research · doi:10.1021/ie050671b · Cited by 141
Onsite CO 2 Capture from Flue Gas by an Adsorption Process in a Coal-Fired Power Plant
Liu, Z., Wang, L., Kong, X., Li, P., Yu, J., & Rodrigues, A. E. (2012) · Industrial & Engineering Chemistry Research · doi:10.1021/ie3005308 · Cited by 126
Hydrogen purification from refinery fuel gas by pressure swing adsorption
Małek, A., & Farooq, S. (1998) · AIChE Journal · doi:10.1002/aic.690440906 · Cited by 115
Self-citationRitter, J. A., Bhadra, S. J., & Ebner, A. D. (2011) · Langmuir · doi:10.1021/la104965w · Cited by 114
Diffusion mechanism of CO2 in 13X zeolite beads
Hu, X. E., Mangano, E., Friedrich, D., Ahn, H., & Brandani, S. (2013) · Adsorption · doi:10.1007/s10450-013-9554-z · Cited by 106
Farooq, S., & Ruthven, D. M. (1991) · Chemical Engineering Science · doi:10.1016/0009-2509(91)85121-d · Cited by 86
Self-citationPressure swing adsorption: experimental and theoretical study on air purification and vapor recovery
Ritter, J. A., & Yang, R. T. (1991) · Industrial & Engineering Chemistry Research · doi:10.1021/ie00053a026 · Cited by 79
A 2-stage PSA process for the recovery of CO2 from flue gas and its power consumption
Cho, S., Park, J., Beum, H.-T., Han, S., & Kim, J. (2004) · Studies in surface science and catalysis · doi:10.1016/s0167-2991(04)80287-8 · Cited by 56
Wilson, S. J., Beh, C. C. K., Webley, P. A., et al. (2001) · Industrial & Engineering Chemistry Research · doi:10.1021/ie000801a · Cited by 25
Cited by
Carbon capture and storage (CCS): the way forward
Bui, M., Adjiman, C. S., Bardow, A., Anthony, E. J., Boston, A., Brown, S., Fennell, P. S., Fuss, S., Galindo, A., Hackett, L. A., et al. (2018) · Energy & Environmental Science · doi:10.1039/c7ee02342a · Cited by 4,374
Cuéllar-Franca, R. M., & Azapagic, A. (2015) · Journal of CO2 Utilization · doi:10.1016/j.jcou.2014.12.001 · Cited by 1,571
Gür, T. M. (2022) · Progress in Energy and Combustion Science · doi:10.1016/j.pecs.2021.100965 · Cited by 821
Rahman, F. A., Aziz, M. M. A., Saidur, R., Bakar, W. A. W. A., Hainin, M. R., Putrajaya, R., & Hassan, N. A. (2017) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2017.01.011 · Cited by 685
Adsorption of Carbon Dioxide for post-combustion capture: a review
Raganati, F., Miccio, F., & Ammendola, P. (2021) · Energy & Fuels · doi:10.1021/acs.energyfuels.1c01618 · Cited by 661
Metadata
- Authors
- Krishnamurthy, S., Rao, V. R., Guntuka, S., Sharratt, P., Haghpanah, R., Rajendran, A., Amanullah, M., Karimi, I. A., & Farooq, S.
- Venue
- AIChE Journal
- Publisher
- Wiley
- Published
- 2014-03-20
- Volume
- 60
- Issue
- 5
- Pages
- 1830-1842
- ISSN
- 0001-1541 (ISSN-L)
- 1547-5905
- OpenAlex
- W2155684877
- Cited by
- 282
- References
- 23
- FWCI
- 22.99
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.