The DOI matches its Crossref record.
Cut growth and fatigue of rubbers. II. Experiments on a noncrystallizing rubber
Abstract
Tensile fatigue failure of a gum vulcanizate of noncrystallizing SBR can be accounted for by the growth of small flaws initially present in the rubber. Fatigue of crystallizing natural rubber was shown in Part I to be attributable to the same cause. Cut growth results are interpreted in terms of the tearing energy theory of Rivlin and Thomas. SBR exhibits cut growth under both static and dynamic conditions; in each case the rate is approximately proportional to the fourth power of the tearing energy. Variation of the dynamic cut growth rate with frequency can be explained by the summation of a timedependent static component of growth and a cyclic component not dissimilar to that occurring in natural rubber. Fatigue failure, under both static and dynamic conditions, is predicted from the cut growth results. These predictions are found to account quantitatively for experimentally observed fatigue lives when a suitable value is assumed for the initial flaw size. Fatigue lives at different temperatures correlate well with cut growth results obtained by Greensmith and Thomas over the same temperature range. The results are compared to those obtained previously for natural rubber, and possible reasons for the differences in fatigue behavior of crystallizing and noncrystallizing rubbers are discussed.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
Fracture and adhesion of soft materials: a review
Creton, C., & Ciccotti, M. (2016) · Reports on Progress in Physics · doi:10.1088/0034-4885/79/4/046601 · Cited by 915
Anti-fatigue-fracture hydrogels
Lin, S., Liu, X., Liu, J., Yuk, H., Loh, H.-C., Parada, G. A., Settens, C., Song, J., Masic, A., McKinley, G. H., et al. (2019) · Science Advances · doi:10.1126/sciadv.aau8528 · Cited by 662
A literature survey on fatigue analysis approaches for rubber
MARS, W., & FATEMI, A. (2002) · International Journal of Fatigue · doi:10.1016/s0142-1123(02)00008-7 · Cited by 506
50th Anniversary Perspective: Networks and Gels: Soft but Dynamic and Tough
Creton, C. (2017) · Macromolecules · doi:10.1021/acs.macromol.7b01698 · Cited by 463
The mechanical fatigue limit for rubber
Lake, G. J., & Lindley, P. B. (1965) · Journal of Applied Polymer Science · doi:10.1002/app.1965.070090405 · Cited by 319
Self-citation
Metadata
- Authors
- Lake, G. J., & Lindley, P. B.
- Venue
- Journal of Applied Polymer Science
- Publisher
- Wiley
- Published
- 1964-03
- Volume
- 8
- Issue
- 2
- Pages
- 707-721
- ISSN
- 0021-8995 (ISSN-L)
- 1097-4628
- OpenAlex
- W2144406123
- Cited by
- 196
- References
- 0
- FWCI
- 5.54
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Cut growth and fatigue of rubbers. II. Experiments on a noncrystallizing rubber. https://app.cochat.ai/papers/10.1002/app.1964.070080212
- The paper
- Lake, G. J., & Lindley, P. B. (1964). Cut growth and fatigue of rubbers. II. Experiments on a noncrystallizing rubber. Journal of Applied Polymer Science. https://doi.org/10.1002/app.1964.070080212
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.