Swirling flow implementation in a photobioreactor for batch and continuous cultures of porphyridium cruentum
Open accessThe DOI matches its Crossref record; 4 of the 4 references it cites were found in a registry or an index.
Abstract
Light is the main limiting factor in photoautotrophic‐intensive production of microorganisms, and improvement of its use is an important concern for photobioreactor design and operation. Swirling flows, which are known to improve mass and photon transfers, were applied to annular light chambers of a photobioreactor and studied by simulation and microalgal culture. Two hydrodynamic conditions were compared: axial flow generating poor radial mixing, and tangential flow generating three‐dimensional swirling motion. Batch and continuous cultures of the Rhodophyte Porphyridium cruentum were performed in a 100‐L, 1.5‐m 2, fully controlled photobioreactor with eight light chambers. The inlet design of these chambers was modified to create the hydrodynamic conditions for comparison. Various intensities of swirling motion were used, characterized by the velocity factor (VF), defined as the ratio between annular chamber flow and inlet aperture sections. Experiments were performed within the range of photon flux densities (PFD) optimizing the yield of light energy transformation into living substance for the species and the temperature used. Culture kinetics with swirling flows generated by apertures of VF = 2, 4, and 9 were compared with pseudoaxial VF = 2 chosen as reference. Batch cultures with VF = 4 swirling flow showed no significant difference, whereas continuous cultures proved more discriminating. Although no significant difference was obtained for VF = 2, a 7% increase of steady‐state productivity and a 26% decrease in time required to reach this steady state were obtained with VF = 4 swirling flow. This beneficial effect of swirling flow could have accounted for increased mixing. Conversely, VF = 9 swirling flow resulted in a 9% decrease of steady‐state productivity and a 9% increase in the time required to reach this steady state, a negative effect that could have accounted for increased shear stress. CO 2 bioconversion yield at steady state showed a 34% increase for VF = 4. These results suggest that swirling motion makes microalgal cultures more efficient, provided that the resulting adverse effects remain acceptable. Experimental investigation was completed by a theoretical approach in which simulation of continuous cultures of P. cruentum was based on the hydrodynamic conditions achieved in the photobioreactor. Although the results obtained with pseudoaxial flow were correctly predicted, simulations with swirling flow showed a marked enhancement of productivity not observed experimentally. The influence of side effects induced by increased mixing (particularly hydrodynamic shear stress) was considered with respect to modeling assumptions. Comparison of experimental results with theoretical simulation provided a better understanding of the mixing effect, a key factor in improving the efficiency of such bioprocesses. © 2004 Wiley Periodicals, Inc. Biotechnol Bioeng 84: 544–551, 2003.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Photobioreactors: Production systems for phototrophic microorganisms
O., P. (2001) · Applied Microbiology and Biotechnology · doi:10.1007/s002530100702 · Cited by 987 · cited 1×
“This probably accounts for the limited industrial development of photobioreactors, despite the considerable attention that has been paid to their design and modeling (Cornet et al., 1998; Molina et al., 2001; Pulz, 2001; Richmond et al., 1993).”
BackgroundTubular photobioreactor design for algal cultures
Molina, E., Fernández, J., Acién, F. G., & Chisti, Y. (2001) · Journal of Biotechnology · doi:10.1016/s0168-1656(01)00353-4 · Cited by 620 · cited 1×
“This probably accounts for the limited industrial development of photobioreactors, despite the considerable attention that has been paid to their design and modeling (Cornet et al., 1998; Molina et al., 2001; Pulz, 2001; Richmond et al., 1993).”
BackgroundCell fragility — The key problem of microalgae mass production in closed photobioreactors
Gudin, C., & Chaumont, D. (1991) · Bioresource Technology · doi:10.1016/0960-8524(91)90146-b · Cited by 175 · cited 2×
“cruentum is generally regarded as a resistant species, excessive mechanical stress may result in lower productivity (Gudin and Chaumont, 1990).”
BackgroundKinetics and energetics of photosynthetic micro-organisms in photobioreactors
Cornet, J.-F., Dussap, C. G., & Gros, J.-B. (2007) · Advances in Biochemical Engineering Biotechnology · doi:10.1007/bfb0102299 · Cited by 83 · cited 1×
“This probably accounts for the limited industrial development of photobioreactors, despite the considerable attention that has been paid to their design and modeling (Cornet et al., 1998; Molina et al., 2001; Pulz, 2001; Richmond et al., 1993).”
Background
Cited by
Valuable Products from Biotechnology of Microalgae
Pulz, O., & Gross, W. (2004) · Applied Microbiology and Biotechnology · doi:10.1007/s00253-004-1647-x · Cited by 2,132
Bioprocess engineering of microalgae to produce a variety of consumer products
Harun, R., Singh, M., Forde, G. M., & Danquah, M. K. (2010) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2009.11.004 · Cited by 1,009
Design principles of photo-bioreactors for cultivation of microalgae
Posten, C. (2009) · Engineering in Life Sciences · doi:10.1002/elsc.200900003 · Cited by 815
“The employment of tangential flow to generate a threedimensional swirling motion is given by [33].”
BackgroundThe technology of microalgal culturing
Eriksen, N. T. (2008) · Biotechnology Letters · doi:10.1007/s10529-008-9740-3 · Cited by 337
Exploitation of marine algae: biogenic compounds for potential antifouling applications
Bhadury, P., & Wright, P. (2004) · Planta · doi:10.1007/s00425-004-1307-5 · Cited by 327
“Muller-Feuga et al. (2003) have implemented swirling flow in a photobioreactor for batch cultures of the red alga Porphyridium cruentum.”
MethodOlivieri, G., Salatino, P., & Marzocchella, A. (2014) · Journal of Chemical Technology & Biotechnology · doi:10.1002/jctb.4218 · Cited by 156
Numerical investigation of hydrodynamic and mixing conditions in a torus photobioreactor
Pruvost, J., Pottier, L., & Legrand, J. (2006) · Chemical Engineering Science · doi:10.1016/j.ces.2006.02.027 · Cited by 154
Self-citationPruvost, J., Cornet, J.-F., & Legrand, J. (2008) · Chemical Engineering Science · doi:10.1016/j.ces.2008.04.026 · Cited by 131
“This was the case for example in previous authors' studies, which conclude with the interest of applying a swirling flow in an annular PBR to improve the light use in the cultivation of Porphyridium purpureum (Muller-Feuga et al., 2003a,b; Pruvost et al., 2002a).”
ResultSelf-citationIndustrial Photobioreactors and Scale-Up Concepts
Pruvost, J., Le Borgne, F., Artu, A., Cornet, J.-F., & Legrand, J. (2016) · Advances in Chemical Engineering · doi:10.1016/bs.ache.2015.11.002 · Cited by 75
Self-citationBi, Z., & He, B. (2020) · Handbook of Microalgae-Based Processes and Products · doi:10.1016/b978-0-12-818536-0.00013-0 · Cited by 11
Metadata
- Authors
- Muller‐Feuga, A., Pruvost, J., Le Guédes, R., Le Déan, L., Legentilhomme, P., & Legrand, J.
- Venue
- Biotechnology and Bioengineering
- Publisher
- Wiley
- Published
- 2003-09-24
- Volume
- 84
- Issue
- 5
- Pages
- 544-551
- ISSN
- 0006-3592 (ISSN-L)
- 1097-0290
- OpenAlex
- W1987311555
- Cited by
- 43
- References
- 4
- FWCI
- 1.69
- Type
- journal article
- Language
- en
- Open access
- bronze
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.