Adsorption of lithium ions on lithium‐aluminum hydroxides: Equilibrium and kinetics
The DOI matches its Crossref record; 9 of the 9 references it cites were found in a registry or an index.
Abstract
The rapid development of rechargeable lithium batteries has promoted the demand of primary lithium products obtained from lithium‐bearing resources, especially salt lakes. Layered lithium‐aluminum hydroxides connecting with ion exchange resin were used for the adsorption of lithium ions from aqueous resources. Batch experiments were conducted to determine the effects of pH, initial lithium concentration, and contact time on lithium adsorption. The optimal conditions for lithium adsorption were found to be pH = 7, and the equilibrium time is approximately 600 minutes. The selectivity experiment indicated that the adsorbent showed selectivity toward lithium ion, so the adsorbent could be used in the separation of lithium ion with other metal ions, especially the divalent magnesium ions. The experiment showed that the existence of the magnesium chloride enhanced the lithium adsorption onto the adsorbent greatly. The kinetic data were analyzed by several kinetic models, and the best result was achieved with a pseudo‐second‐order model. The commonly used adsorption isotherms were used to fit the experimental data by nonlinear regression. Both Langmuir and Temkin isotherm models could describe the isotherm well. The thermodynamic parameters (ΔG, ΔS, and ΔH) were also calculated subsequently and the results showed the lithium adsorption process is exothermic with the decrease of randomness. Breakthrough curves demonstrated the cyclic stability of the adsorbent and the influence of the feed flow rate. Lithium ions were effectively adsorbed from the aqueous solution by the adsorbent, demonstrating its feasibility for lithium recovery and providing the fundamental data for further column design.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Insights into the modeling of adsorption isotherm systems
Foo, K. Y., & Hameed, B. H. (2010) · Chemical Engineering Journal · doi:10.1016/j.cej.2009.09.013 · Cited by 8,479
Lithium market research – global supply, future demand and price development
Martin, G., Rentsch, L., Höck, M., & Bertau, M. (2017) · Energy Storage Materials · doi:10.1016/j.ensm.2016.11.004 · Cited by 740
Extraction of lithium with functionalized lithium ion-sieves
Xu, X., Chen, Y., Wan, P., Gasem, K., Wang, K., He, T., Adidharma, H., & Fan, M. (2016) · Progress in Materials Science · doi:10.1016/j.pmatsci.2016.09.004 · Cited by 536
Choubey, P. K., Kim, M.-S., Srivastava, R. R., Lee, J.-C., & Lee, J.-Y. (2016) · Minerals Engineering · doi:10.1016/j.mineng.2016.01.010 · Cited by 529
Lithium recovery from salt lake brine by H 2 TiO 3
Chitrakar, R., Makita, Y., Ooi, K., & Sonoda, A. (2014) · Dalton Trans. · doi:10.1039/c4dt00467a · Cited by 345
Paranthaman, M. P., Li, L., Luo, J., Hoke, T., Ucar, H., Moyer, B. A., & Harrison, S. (2017) · Environmental Science & Technology · doi:10.1021/acs.est.7b03464 · Cited by 293
Material flow analysis of lithium in China
Hao, H., Liu, Z., Zhao, F., Geng, Y., & Sarkis, J. (2017) · Resources Policy · doi:10.1016/j.resourpol.2016.12.005 · Cited by 227
Separating Lithium and Magnesium in Brine by Aluminum-Based Materials
Liu, X., Zhong, M., Chen, X., & Zhao, Z. (2018) · Hydrometallurgy · doi:10.1016/j.hydromet.2018.01.005 · Cited by 153
Selective adsorption of lithium ions from Urmia Lake onto aluminum hydroxide
Heidari, N., & Momeni, P. (2017) · Environmental Earth Sciences · doi:10.1007/s12665-017-6885-1 · Cited by 65
Cited by
Sun, Y., Wang, Q., Wang, Y., Yun, R., & Xiang, X. (2021) · Separation and Purification Technology · doi:10.1016/j.seppur.2020.117807 · Cited by 685
Materials for lithium recovery from salt-lake brine
Xu, P., Hong, J., Qian, X., Xu, Z., Xia, H., Tao, X., Xu, Z., & Ni, Q.-Q. (2021) · Journal of Materials Science · doi:10.1007/s10853-020-05019-1 · Cited by 296
Technology for the Recovery of Lithium from Geothermal Brines
Stringfellow, W. T., & Dobson, P. F. (2021) · Energies · doi:10.3390/en14206805 · Cited by 293
“AlOH has been proposed for use as a lithium sorbent by a number of researchers; however, sorption capacities for AlOH sorbents are reported to be less than 8 mg/g [110,117,118,120].”
BackgroundInfluentialThe recovery and separation of lithium by using solvent extraction methods
Kanagasundaram, T., Murphy, O., Haji, M. N., & Wilson, J. J. (2024) · Coordination Chemistry Reviews · doi:10.1016/j.ccr.2024.215727 · Cited by 263
Direct lithium extraction: A new paradigm for lithium production and resource utilization
Farahbakhsh, J., Arshadi, F., Mofidi, Z., Mohseni-Dargah, M., Kök, C., Assefi, M., Soozanipour, A., Zargar, M., Asadnia, M., Boroumand, Y., et al. (2024) · Desalination · doi:10.1016/j.desal.2023.117249 · Cited by 260
Metadata
- Authors
- Jiang, H., Yang, Y., Sun, S., & Yu, J.
- Venue
- The Canadian Journal of Chemical Engineering
- Publisher
- Wiley
- Published
- 2019-10-24
- Volume
- 98
- Issue
- 2
- Pages
- 544-555
- ISSN
- 0008-4034 (ISSN-L)
- 1939-019X
- OpenAlex
- W2972907346
- Cited by
- 107
- References
- 9
- FWCI
- 4.33
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.