The DOI matches its Crossref record; 1 of the 1 references it cites were found in a registry or an index.
Effect of rubber particle size on deformation mechanisms in glassy epoxy
Abstract
When tested in tension, a cross‐linked epoxy resin can be made to exhibit shear yielding. A modified von Mises criterion, τ = τ 0 − μ P describes the yielding behavior of the same resin under a biaxial stress system, indicating that the flow of the material is pressure sensitive. Butadien‐acrylonitrile elastomer particles suspended in the cross‐linked epoxy matrix induce large local deformations when the composite material is stressed. Particles a few hundred Angstroms in diameter cause the glassy matrix to exhibit shear banding, and the macroscopic failure envelope of such a system follows a modified von Mises criterion similar to that of the matrix resin. It was found that the coefficient of internal friction, τ, and the activation energy for yielding are approximately the same for the two cases. With larger particles (5‐15,000 Å diam) the failure mode changes as shown by the macroscopic yield envelope and the associated activation energy. Electron micrographs of the fracture surfaces show microcavitation, similar to crazing around each particle; the deformed glassy polymer around each particle retracts upon heating the matrix above its Tg. The fracture surface work value of the unmodified matrix is 1.75 × 10 5 ergs/cm 2. With 10 pph small particles, the value increases to 3.32 × 10 5 and with 10 pph of large particles, to 15.48 × 10 5 ergs/cm 2.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Plastic Deformation Bands in Glassy Polystyrene
Argon, A. S., Andrews, R. D., Godrick, J. A., & Whitney, W. (1968) · Journal of Applied Physics · doi:10.1063/1.1656448 · Cited by 144
Cited by
Phase structure and adhesion in polymer blends: A criterion for rubber toughening
Wu, S. (1985) · Polymer · doi:10.1016/0032-3861(85)90015-1 · Cited by 1,426
Toughening mechanisms of nanoparticle-modified epoxy polymers
Johnsen, B. B., Kinloch, A. J., Mohammed, R. D., Taylor, A. C., & Sprenger, S. (2007) · Polymer · doi:10.1016/j.polymer.2006.11.038 · Cited by 942
Domun, N., Hadavinia, H., Zhang, T., Sainsbury, T., Liaghat, G. H., & Vahid, S. (2015) · Nanoscale · doi:10.1039/c5nr01354b · Cited by 808
Kinloch, A. J., Shaw, S. J., Tod, D. A., & Hunston, D. L. (1983) · Polymer · doi:10.1016/0032-3861(83)90070-8 · Cited by 787
Toughening mechanisms in elastomer-modified epoxies: Part 3 The effect of cross-link density
Pearson, R. A., & Yee, A. F. (1989) · Journal of Materials Science · doi:10.1007/bf01174528 · Cited by 724
A review of crazing and fracture in thermoplastics
Kambour, R. P. (1973) · Journal of Polymer Science: Macromolecular Reviews · doi:10.1002/pol.1973.230070101 · Cited by 695
A generalized criterion for rubber toughening: The critical matrix ligament thickness
Wu, S. (1988) · Journal of Applied Polymer Science · doi:10.1002/app.1988.070350220 · Cited by 693
Toughening of polypropylene with calcium carbonate particles
Zuiderduin, W. C. J., Westzaan, C., Huétink, J., & Gaymans, R. J. (2003) · Polymer · doi:10.1016/s0032-3861(02)00769-3 · Cited by 681
Pearson, R. A., & Yee, A. F. (1991) · Journal of Materials Science · doi:10.1007/bf01184979 · Cited by 537
Rubber-Toughened Epoxies: A Critical Review
Bagheri, R., Marouf, B. T., & Pearson, R. A. (2009) · Polymer Reviews · doi:10.1080/15583720903048227 · Cited by 455
Toughening of photo-curable polymer networks: a review
Ligon-Auer, S. C., Schwentenwein, M., Gorsche, C., Stampfl, J., & Liska, R. (2016) · Polymer Chemistry · doi:10.1039/c5py01631b · Cited by 447
Hsieh, T. H., Kinloch, A. J., Masania, K., Sohn Lee, J., Taylor, A. C., & Sprenger, S. (2010) · Journal of Materials Science · doi:10.1007/s10853-009-4064-9 · Cited by 391
Reaction-induced phase separation in modified thermosetting polymers
Williams, R. J. J., Rozenberg, B. A., & Pascault, J.-P. (1997) · Advances in Polymer Science · doi:10.1007/3-540-61218-1_7 · Cited by 383
Toughening mechanisms in thermoplastic-modified epoxies: 1. Modification using poly(phenylene oxide)
Pearson, R. A., & Yee, A. F. (1993) · Polymer · doi:10.1016/0032-3861(93)90051-b · Cited by 380
Argon, A. S., & Cohen, R. E. (2003) · Polymer · doi:10.1016/s0032-3861(03)00546-9 · Cited by 304
Singh, R. P., Zhang, M., & Chan, D. (2002) · Journal of Materials Science · doi:10.1023/a:1013844015493 · Cited by 302
The science of adhesion: Part 2 Mechanics and mechanisms of failure
Kinloch, A. J. (1982) · Journal of Materials Science · doi:10.1007/bf00540361 · Cited by 265
A Review on Rubber-Enhanced Polymeric Materials
Caldona, E. B., De Leon, A. C. C., Pajarito, B. B., & Advincula, R. C. (2017) · Polymer Reviews · doi:10.1080/15583724.2016.1247102 · Cited by 74
Han, Y., Lach, R., & Grellmann, W. (2000) · Journal of Applied Polymer Science · doi:10.1002/1097-4628(20010103)79:1<9::aid-app20>3.0.co;2-m · Cited by 36
Metadata
- Authors
- Sultan, J. N., & McGarry, F. J.
- Venue
- Polymer Engineering & Science
- Publisher
- Wiley
- Published
- 1973-01
- Volume
- 13
- Issue
- 1
- Pages
- 29-34
- ISSN
- 0032-3888 (ISSN-L)
- 1548-2634
- OpenAlex
- W2043089748
- Cited by
- 644
- References
- 1
- FWCI
- 16.46
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.