Estimation of river depth from remotely sensed hydraulic relationships: Remotely Sensed Estimation of River Depth
Open accessThe DOI matches its Crossref record; 3 of the 3 references it cites were found in a registry or an index.
Abstract
[1] The Surface Water and Ocean Topography (SWOT) radar interferometer satellite mission will provide unprecedented global measurements of water surface elevation (h) for inland water bodies. However, like most remote sensing technologies SWOT will not observe river channel bathymetry below the lowest observed water surface, thus limiting its value for estimating river depth and/or discharge. This study explores if remotely sensed observations of river inundation width and h alone, when accumulated over time, may be used to estimate this unmeasurable flow depth. To test this possibility, synthetic values of h and either cross-sectional flow width (w) or effective width (We, inundation area divided by reach length) are extracted from 1495 previously surveyed channel cross-sections for the Upper Mississippi, Illinois, Rio Grande, and Ganges-Brahmaputra river systems, and from 62 km of continuously acquired sonar data for the Upper Mississippi. Two proposed methods (called “Linear” and “Slope-Break”) are tested that seek to identify a small subset of geomorphically “optimal” locations where w or We covary strongly with h, such that they may be usefully extrapolated to estimate mean cross-sectional flow depth (d). While the simplest Linear Method is found to have considerable uncertainty, the Slope-Break Method, identifying locations where two distinct hydraulic relationships are identified (one for moderate to high flows and one for low flows), holds promise. Useful slope breaks were discovered in all four river systems, ranging from 6 (0.04%) to 242 (16%) of the 1495 studied cross-sections, assuming channel bathymetric exposures ranging from 20% to 95% of bankfull conditions, respectively. For all four rivers, the derived depth estimates from the Slope-Break Method have root mean squared errors (RMSEs) of <20% (relative to bankfull mean depth) assuming at least one channel bathymetry exposure of ∼25% or greater. Based on historic discharge records and HEC-RAS hydraulic modeling, the Upper Mississippi and Rio Grande rivers experience adequate channel exposures at least ∼60% and ∼42% of the time, respectively. For the Upper Mississippi, so-called “reach-averaging” (spatial averaging along some predetermined river length) of native-resolution h and We values reduces both RMSE and longitudinal variability in the derived depth estimates, especially at reach-averaging lengths of ∼1000–2000 m. These findings have positive implications for SWOT and other sensors attempting to estimate river flow depth and/or discharge solely from incomplete, remotely sensed hydraulic variables, and suggest that useful depth retrievals can be obtained within the spatial and temporal constraints of satellite observations.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Global threats to human water security and river biodiversity
Vörösmarty, C. J., McIntyre, P. B., Gessner, M. O., Dudgeon, D., Prusevich, A., Green, P., Glidden, S., Bunn, S. E., Sullivan, C. A., Liermann, C. R., et al. (2010) · Nature · doi:10.1038/nature09440 · Cited by 7,582
The hydraulic geometry of stream channels and some physiographic implications
Leopold, L. B., & Maddock, T. (1953) · Professional Paper · doi:10.3133/pp252 · Cited by 2,966
Park, C. C. (1977) · Journal of Hydrology · doi:10.1016/0022-1694(77)90103-2 · Cited by 331
Cited by
Improving the representation of hydrologic processes in Earth System Models
Clark, M. P., Fan, Y., Lawrence, D. M., Adam, J. C., Bolster, D., Gochis, D. J., Hooper, R. P., Kumar, M., Leung, L. R., Mackay, D. S., et al. (2015) · Water Resources Research · doi:10.1002/2015wr017096 · Cited by 636
Water Resources Research in 2013
Montanari, A. (2014) · Water Resources Research · doi:10.1002/2014wr015648 · Cited by 534
Wood, M., Hostache, R., Neal, J., Wagener, T., Giustarini, L., Chini, M., Corato, G., Matgen, P., & Bates, P. (2016) · doi:10.5194/hess-2015-511 · Cited by 123
Zambrano Mera, Y. E., Rivadeneira Vera, J. F., & Pérez-Martín, M. Á. (2018) · Science of The Total Environment · doi:10.1016/j.scitotenv.2018.06.160 · Cited by 57
Metadata
- Authors
- Mersel, M. K., Smith, L. C., Andreadis, K. M., & Durand, M. T.
- Venue
- Water Resources Research
- Publisher
- American Geophysical Union (AGU)
- Published
- 2013-06
- Volume
- 49
- Issue
- 6
- Pages
- 3165-3179
- ISSN
- 0043-1397 (ISSN-L)
- OpenAlex
- W2112152298
- Cited by
- 87
- References
- 3
- FWCI
- 5.48
- Type
- journal article
- Language
- en
- Open access
- bronze
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Estimation of river depth from remotely sensed hydraulic relationships: Remotely Sensed Estimation of River Depth. https://app.cochat.ai/papers/10.1002/wrcr.20176
- The paper
- Mersel, M. K., Smith, L. C., Andreadis, K. M., & Durand, M. T. (2013). Estimation of river depth from remotely sensed hydraulic relationships: Remotely Sensed Estimation of River Depth. Water Resources Research. https://doi.org/10.1002/wrcr.20176
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.