Student or educator? Sign up with your school email and get 6 months of Pro free.
Cited by 185

The DOI matches its Crossref record.

Simultaneous determination of capillary pressure and relative permeability curves from core-flooding experiments with various fluid pairs

Pini, Ronny, Benson, Sally M. · 2013 · Water Resources Research

Abstract

[1] Capillary pressure and relative permeability drainage curves are simultaneously measured on a single Berea Sandstone core by using three different fluid pairs, namely gCO 2/water, gN2/water and scCO 2/brine. This novel technique possesses many of the characteristics of a conventional steady-state relative permeability experiment and consists of injecting the nonwetting fluid at increasingly higher flow rates in a core that is initially saturated with the wetting phase, while observing fluid saturations with a medical x-ray CT scanner. Injection flow rates (0.5–75 mL/min) are varied so as to generate a large range of capillary pressures (up to 18 kPa), whereas fluid-pairs and experimental conditions are selected in order to move across a range interfacial tension values ( γ12=40−65 mN/m), while maintaining a constant viscosity ratio ( μw/μnw ≈30). Moreover, these experiments, carried out at moderate pressures ( P=2.4 MPa and T=50°C), can be compared directly with results for gas/liquid pairs reported in the literature and they set the benchmark for the experiment at a higher pressure ( P=9 MPa and T=50°C), where CO 2 is in the supercritical state. Contrary to some prior investigations, from these experiments we find no evidence that the scCO 2/brine system behaves differently than any of these other fluid pairs. At the same time, capillary pressure data show a significant (but consistent) effect of the different values for the interfacial tension. The fact that the three different fluid pairs yield the same drainage relative permeability curve is consistent with observations in the petroleum literature. Additionally, the observed end-point values for the relative permeability to the nonwetting phase ( kr,nw ≈0.9) and the corresponding irreducible water saturations ( Sw,irr ≈0.35) suggest that water-wet conditions are maintained in each experiment. The reliability of the measured relative permeability curves is supported by the very good agreement with data from the literature obtained on Berea Sandstone cores and with various gas/liquid pairs. The Brooks-Corey model is used to describe the capillary pressure data and the parameters derived from these matches provide a fair prediction of the relative permeability curves. It is shown that the apparent low end-point relative permeabilities to the nonwetting phase reported in previous experimental studies are caused by the low viscosity of CO 2 relative to water, rather than by the rock heterogeneity. In fact, the former controls the level of capillary pressure that can be achieved experimentally, thus restricting the applicability of some of the conventional methods to measure relative permeability curves for gas/liquid systems.

Overview

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1002/wrcr.20274

Cites

Statistics

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cited by

See all 185

Metadata

Authors
Pini, R., & Benson, S. M.
Venue
Water Resources Research
Published
2013-06
Volume
49
Issue
6
Pages
3516-3530
ISSN
0043-1397 (ISSN-L)
OpenAlex
W1652711717
Cited by
185
References
0
FWCI
20.79
Type
journal article
Language
en
Open access
closed

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

How to cite

Cite CoChat for the checks on this page, and the paper for its own findings.

This page
CoChat. (2026). Citation check: Simultaneous determination of capillary pressure and relative permeability curves from core-flooding experiments with various fluid pairs. https://app.cochat.ai/papers/10.1002/wrcr.20274
The paper
Pini, R., & Benson, S. M. (2013). Simultaneous determination of capillary pressure and relative permeability curves from core-flooding experiments with various fluid pairs. Water Resources Research. https://doi.org/10.1002/wrcr.20274

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.