CoChat

Applicability of the time–temperature superposition principle in modeling dynamic response of a polyurea

Open access
Zhao, J., Knauss, W. G., Ravichandran, G. · 2007 · Mechanics of Time-Dependent Materials

The DOI matches its Crossref record; 7 of the 7 references it cites were found in a registry or an index.

Abstract

This paper addresses the applicability of the Time–Temperature Superposition Principle in the dynamic response of a polyurea polymer at high strain rates and different temperatures. Careful and extensive measurements in the time domain of the relaxation behavior and subsequent deduction of a master-relaxation curve establish the mechanical behavior for quasistatic deformations over a time range of 16 decades. To examine its validity in a highly dynamic environment, experiments with the aid of a split Hopkinson (Kolsky) pressure bar are carried out. The use of a two-material pulse shaper allows for stress equilibrium across the specimen during the compression process, to concentrate on the initial, small deformation part that characterizes linearly viscoelastic behavior. This behavior of polyurea at high strain rates and different temperatures is then investigated by comparing results from a physically fully three-dimensional (axisymmetric) numerical model, employing the quasistatically obtained properties, with corresponding Hopkinson bar measurements. The experimentally determined wave history entering the specimen is used as input to the model. Experimental and simulation results are compared with each other to demonstrate that the Time–Temperature Superposition Principle can indeed provide the requisite data for high strain rate loading of viscoelastic solids, at least to the extent that linear viscoelasticity applies with respect to the polyurea material.

Overview

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1007/s11043-008-9048-7

Cites

7 of 7 references verified0 citation errors · 0 not checkable

Statistics

Figures

Image 1
CC-BY-NC · From the PDF
Fig. 3 Shift factor as a function of temperature
Fig. 3 Shift factor as a function of temperatureCC-BY-NC · From the PDF
Fig. 4 Split Hopkinson bar arrangement
Fig. 4 Split Hopkinson bar arrangementCC-BY-NC · From the PDF
Fig. 5 Signals (in the absence of a specimen) from all gages in the Hopkinson bar generated with a composite pulse shaper consisting of polyurea (1.32 mm thick, and 8 . 11 × 8 . 17 laterally) and 16 layers of paper
Fig. 5 Signals (in the absence of a specimen) from all gages in the Hopkinson bar generated with a composite pulse shaper consisting of polyurea (1.32 mm thick, and 8 . 11 × 8 . 17 laterally) and 16 layers of paperCC-BY-NC · From the PDF
Fig. 6 Temperature control chamber
Fig. 6 Temperature control chamberCC-BY-NC · From the PDF
(b) Specimen inside the control chamber
(b) Specimen inside the control chamberCC-BY-NC · From the PDF
Fig. 7 Room temperature record of forces at the quartz gages for a pulse shaper of polyurea only
Fig. 7 Room temperature record of forces at the quartz gages for a pulse shaper of polyurea onlyCC-BY-NC · From the PDF
Fig. 9 Extended time history of quartz gage records on the incident bar ( upper ) and transmission bar ( lower ) for two specimens
Fig. 9 Extended time history of quartz gage records on the incident bar ( upper ) and transmission bar ( lower ) for two specimensCC-BY-NC · From the PDF
Fig. 11 Identification of a weak disturbance arising from the dispersion of the signal at the incident bar-specimen interface
Fig. 11 Identification of a weak disturbance arising from the dispersion of the signal at the incident bar-specimen interfaceCC-BY-NC · From the PDF
Image 10
CC-BY-NC · From the PDF
Fig. 12 Improvement of data reduction through elimination of the reflected strain in favor of the incident and transmitted strains. Specimen and pulse shaping are the same as those in Fig. 11
Fig. 12 Improvement of data reduction through elimination of the reflected strain in favor of the incident and transmitted strains. Specimen and pulse shaping are the same as those in Fig. 11CC-BY-NC · From the PDF
Fig. 14 Experimentally determined strain rate for conventional polyurea specimen (6 mm dia × 2.65 mm) under Hopkinson bar loading, as determined from ˙ εs = ( 2 C/ls )(ε i -εt ) where l s = specimen length ε i and εt are the incident and transmitted strain signals, respectively
Fig. 14 Experimentally determined strain rate for conventional polyurea specimen (6 mm dia × 2.65 mm) under Hopkinson bar loading, as determined from ˙ εs = ( 2 C/ls )(ε i -εt ) where l s = specimen length ε i and εt are the incident and transmitted strain signals, respectivelyCC-BY-NC · From the PDF
Image 13
CC-BY-NC · From the PDF
Fig. 16 Comparison between the experimental and simulated stress-strain relation under dynamic loading
Fig. 16 Comparison between the experimental and simulated stress-strain relation under dynamic loadingCC-BY-NC · From the PDF
Image 15
CC-BY-NC · From the PDF
Image 16
CC-BY-NC · From the PDF
Image 17
CC-BY-NC · From the PDF

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Claims other papers make about this one

Each is checked against this paper’s own text: does it say what the citing paper says it does?

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cites

Show all 7 references

Cited by

See all 88

Metadata

Authors
Zhao, J., Knauss, W. G., & Ravichandran, G.
Affiliations
California Institute of Technology (US)
Corresponding author
Knauss, W. G.
Venue
Mechanics of Time-Dependent Materials
Published
2007-12
Volume
11
Issue
3-4
Pages
289-308
ISSN
  • 1385-2000 (ISSN-L)
  • 1573-2738
OpenAlex
W2057304328
Cited by
86
References
7
Citations by year
2026: 3 · 2025: 4 · 2024: 2 · 2023: 2 · 2022: 4 · 2021: 4 · 2020: 8 · 2019: 4 · 2018: 3 · 2017: 4 · 2016: 7 · 2015: 10 · 2014: 3 · 2013: 5 · 2012: 4
FWCI
1.84
Type
journal article
Language
en
Open access
Licence
Locations
  • Mechanics of Time-Dependent Materials (publishedVersion, cc-by-nc)
  • CaltechAUTHORS (California Institute of Technology) (submittedVersion, cc-by-nc)
Funders
Office of Naval Research (N00014)
Topics
  • Physical Sciences › Engineering › Mechanics of Materials › High-Velocity Impact and Material Behavior
  • Physical Sciences › Chemical Engineering › Fluid Flow and Transfer Processes › Rheology and Fluid Dynamics Studies
  • Physical Sciences › Engineering › Biomedical Engineering › Elasticity and Material Modeling
Keywords
time-temperature superposition, polyurea, dynamic response, high strain rate loading, linear viscoelasticity, split Hopkinson pressure bar, pulse shaper, stress equilibrium, viscoelastic materials, temperature dependence

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

How to cite

Cite CoChat for the checks on this page, and the paper for its own findings.

This page
CoChat. (2026). Citation check: Applicability of the time–temperature superposition principle in modeling dynamic response of a polyurea. https://app.cochat.ai/papers/10.1007/s11043-008-9048-7
The paper
Zhao, J., Knauss, W. G., & Ravichandran, G. (2007). Applicability of the time–temperature superposition principle in modeling dynamic response of a polyurea. Mechanics of Time-Dependent Materials. https://doi.org/10.1007/s11043-008-9048-7

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.