The DOI matches its Crossref record; 40 of the 40 references it cites were found in a registry or an index.
Low grade thermal energy sources and uses from the process industry in the UK
Open accessAbstract
Abstract Thermal energy loss in the process industry is a significant issue due to the high temperatures and multiple heat intensive processes involved. High-grade thermal energy is typically recovered within processes. However, lower grade heat is often rejected to the environment. The benefits of capturing and utilising low grade thermal energy are highly dependent on the qualities and properties of the heat in the waste streams. The temperature of the low grade heat stream is the most important parameter, as the effective use of the residual heat or the efficiency of energy recovery from the low grade heat sources will mainly depend on the temperature difference between the source and a suitable sink, e.g. another process or space heating/cooling. In general, the temperatures of these waste heat sources are too low to produce electricity and direct heat use will depend on whether potential user can be found. This paper presents past and current drivers for heat recovery studies. High and low grade heat sources are defined according to the viability of recovery within the processes. Firstly, high grade heat capture within the processes is reviewed. Then, the focus is on the potential for low grade heat capture outside of the original plant. The paper addresses the potential for low grade heat recovery with regard to new incentives and technological advances. Finally, different aspects which influence the decision making for low grade heat recovery in the process industry are discussed. It is concluded that organisational, financial and economic barriers might be overcome and benefits from a holistic vision could be gained with stronger governmental policy and regulation incentives.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Cooling, Heating, Generating Power, and Recovering Waste Heat with Thermoelectric Systems
Bell, L. E. (2008) · Science · doi:10.1126/science.1158899 · Cited by 6,082
Global hydrological cycles and world water resources
Oki, T., & Kanae, S. (2006) · Science · doi:10.1126/science.1128845 · Cited by 4,392
Progress in electrical energy storage system: a critical review
Chen, H., Cong, T. N., Yang, W., Tan, C., Li, Y., & Ding, Y. (2009) · Progress in Natural Science · doi:10.1016/j.pnsc.2008.07.014 · Cited by 3,746
Bejan, A. (1996) · Journal of Applied Physics · doi:10.1063/1.362674 · Cited by 1,951
Entropy Generation Through Heat and Fluid Flow
Bejan, A., & Kestin, J. (1983) · Journal of Applied Mechanics · doi:10.1115/1.3167072 · Cited by 1,874
Entropy generation through heat and fluid flow
Bejan, A. (1982) · CERN Document Server (European Organization for Nuclear Research) · Cited by 1,371
User guide on process integration for the efficient use of energy
Linnhoff, B. (1982) · Pergamon Press eBooks · Cited by 1,109
Working fluids for low-temperature organic Rankine cycles
SALEH, B., KOGLBAUER, G., WENDLAND, M., & FISCHER, J. (2007) · Energy · doi:10.1016/j.energy.2006.07.001 · Cited by 1,045
Working fluids for high-temperature organic Rankine cycles
Lai, N. A., Wendland, M., & Fischer, J. (2011) · Energy · doi:10.1016/j.energy.2010.10.051 · Cited by 1,032
Combined cooling, heating and power: A review
Wu, D. W., & Wang, R. Z. (2006) · Progress in Energy and Combustion Science · doi:10.1016/j.pecs.2006.02.001 · Cited by 810
Rozema, J., & Flowers, T. (2008) · Science · doi:10.1126/science.1168572 · Cited by 711
Availability analysis: A guide to efficient energy use
Moran, M. (1982) · Cited by 688
The European Union Emissions Trading Scheme: Origins, Allocation, and Early Results
Ellerman, A. D., & Buchner, B. K. (2007) · Review of Environmental Economics and Policy · doi:10.1093/reep/rem003 · Cited by 656
Bejan, A. (2002) · International Journal of Energy Research · doi:10.1002/er.804 · Cited by 603
Adsorption refrigeration—An efficient way to make good use of waste heat and solar energy☆
WANG, R., & OLIVEIRA, R. (2006) · Progress in Energy and Combustion Science · doi:10.1016/j.pecs.2006.01.002 · Cited by 476
Gou, X., Xiao, H., & Yang, S. (2010) · Applied Energy · doi:10.1016/j.apenergy.2010.02.013 · Cited by 462
Heat pipes in modern heat exchangers
Vasiliev, L. L. (2005) · Applied Thermal Engineering · doi:10.1016/j.applthermaleng.2003.12.004 · Cited by 460
CO2-heat pump water heater: characteristics, system design and experimental results
Nekså, P., Rekstad, H., Zakeri, G. R., & Schiefloe, P. A. (1998) · International Journal of Refrigeration · doi:10.1016/s0140-7007(98)00017-6 · Cited by 378
Working fluids for low-temperature heat source
Lakew, A. A., & Bolland, O. (2010) · Applied Thermal Engineering · doi:10.1016/j.applthermaleng.2010.02.009 · Cited by 336
Operational optimization in a district heating system
Benonysson, A., Bøhm, B., & Ravn, H. F. (1995) · Energy Conversion and Management · doi:10.1016/0196-8904(95)98895-t · Cited by 316
Parametric analysis of loop heat pipe operation: a literature review
Launay, S., Sartre, V., & Bonjour, J. (2007) · International Journal of Thermal Sciences · doi:10.1016/j.ijthermalsci.2006.11.007 · Cited by 292
Salicornia bigelovii Torr.: An Oilseed Halophyte for Seawater Irrigation
Glenn, E. P., O'Leary, J. W., Watson, M. C., Thompson, T. L., & Kuehl, R. O. (1991) · Science · doi:10.1126/science.251.4997.1065 · Cited by 262
From fluid milk to milk powder: Energy use and energy efficiency in the European dairy industry
RAMIREZ, C., PATEL, M., & BLOK, K. (2006) · Energy · doi:10.1016/j.energy.2005.10.014 · Cited by 217
A combined power cycle utilizing low-temperature waste heat and LNG cold energy
Shi, X., & Che, D. (2008) · Energy Conversion and Management · doi:10.1016/j.enconman.2008.10.015 · Cited by 199
Rucht, D., Jamison, A., Eyerman, R., Cramer, J., & Laessoe, J. (1994) · Contemporary Sociology · doi:10.2307/2076360 · Cited by 182
Perrot, P. (1999) · Choice Reviews Online · doi:10.5860/choice.37-0376 · Cited by 159
Handbook of water and energy management in food processing
Klemeš, J. J., Smith, R., & Kim, J. (2008) · Woodhead Publishing Limited eBooks · doi:10.1533/9781845694678 · Cited by 142
Spatial modelling of industrial heat loads and recovery potentials in the UK
McKenna, R., & Norman, J. (2010) · Energy Policy · doi:10.1016/j.enpol.2010.05.042 · Cited by 142
User Guide on Process Integration for the Efficient Use of Energy.
Westerberg, A. W. (1984) · Chemical Engineering Science · doi:10.1016/0009-2509(84)80063-9 · Cited by 130
Smith, A. (2005) · Cited by 116
Heat pumps and energy storage – The challenges of implementation
Hewitt, N. (2011) · Applied Energy · doi:10.1016/j.apenergy.2010.12.028 · Cited by 112
Hisazumi, Y., Yamasaki, Y., & Sugiyama, S. (1998) · Applied Energy · doi:10.1016/s0306-2619(98)00034-8 · Cited by 100
Grohnheit, P. E., & Mortensen, B. O. G. (2003) · Energy Policy · doi:10.1016/s0301-4215(02)00066-6 · Cited by 97
Fundamentals and applications of cryogen as a thermal energy carrier: A critical assessment
Li, Y., Chen, H., & Ding, Y. (2010) · International Journal of Thermal Sciences · doi:10.1016/j.ijthermalsci.2009.12.012 · Cited by 92
The role of process intensification in cutting greenhouse gas emissions
Reay, D. (2008) · Applied Thermal Engineering · doi:10.1016/j.applthermaleng.2008.01.004 · Cited by 87
Operation window and part-load performance study of a syngas fired gas turbine
He, F., Li, Z., Liu, P., Ma, L., & Pistikopoulos, E. N. (2011) · Applied Energy · doi:10.1016/j.apenergy.2010.11.044 · Cited by 58
van Beers, D., & Biswas, W. K. (2008) · Energy Conversion and Management · doi:10.1016/j.enconman.2008.06.008 · Cited by 43
Modelling of energy flows in potato crisp frying processes
Wu, H., Jouhara, H., Tassou, S. A., & Karayiannis, T. G. (2011) · Applied Energy · doi:10.1016/j.apenergy.2011.01.008 · Cited by 24
Profiting from low-grade heat : thermodynamic cycles for low-temperature heat sources
Crook, A. (1994) · Medical Entomology and Zoology · Cited by 18
Energy efficiency, no: It's exergy efficiency!
Winter, C. (2007) · International Journal of Hydrogen Energy · doi:10.1016/j.ijhydene.2007.08.008 · Cited by 10
Cited by
Thermal energy storage: Recent developments and practical aspects
Zhang, H., Baeyens, J., Cáceres, G., Degrève, J., & Lv, Y. (2016) · Progress in Energy and Combustion Science · doi:10.1016/j.pecs.2015.10.003 · Cited by 910
Handbook of Clean Energy Systems
(2015) · Wiley eBooks · doi:10.1002/9781118991978 · Cited by 535
Yuan, K., Shi, J., Aftab, W., Qin, M., Usman, A., Zhou, F., Lv, Y., Gao, S., & Zou, R. (2020) · Advanced Functional Materials · doi:10.1002/adfm.201904228 · Cited by 459
Energy storage for desalination processes powered by renewable energy and waste heat sources
Gude, V. G. (2015) · Applied Energy · doi:10.1016/j.apenergy.2014.06.061 · Cited by 373
The Role of Direct Air Capture in Mitigation of Anthropogenic Greenhouse Gas Emissions
Beuttler, C., Charles, L., & Wurzbacher, J. (2019) · Frontiers in Climate · doi:10.3389/fclim.2019.00010 · Cited by 281
Metadata
- Authors
- Ammar, Y., Joyce, S., Norman, R., Wang, Y., & Roskilly, A. P.
- Venue
- Applied Energy
- Publisher
- Elsevier BV
- Published
- 2012-01
- Volume
- 89
- Issue
- 1
- Pages
- 3-20
- ISSN
- 0306-2619 (ISSN-L)
- OpenAlex
- W2054664100
- Cited by
- 323
- References
- 40
- FWCI
- 9.19
- Type
- journal article
- Language
- en
- Open access
- green
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.