Performance of polyethyleneimine–silica adsorbent for post-combustion CO2 capture in a bubbling fluidized bed
Open accessThe DOI matches its Crossref record; 1 of the 1 references it cites were found in a registry or an index.
Abstract
The high performance of polyethyleneimine (PEI)-based solid adsorbent for CO2 capture has been well recognized in thermogravimetric analysis (TGA) and small-scale fixed bed reactors through the measurements of their equilibrium capacities but has not been really demonstrated on larger scales towards practical utilization. In the present study, a laboratory-scale bubbling fluidized bed reactor loaded with a few kg adsorbent is used to evaluate the adsorption performance of PEI–silica adsorbent under different working conditions including with/without the presence of moisture, different gas–solid contact times, initial bed temperatures, and CO2 partial pressures. The adsorption capacities have shown a clear degradation tendency under dry condition. However, they can be stabilized at a high level of 10.6–11.1% w/w over 60 cycles if moisture (ca. 8.8 vol%) is present in the gas flow during adsorption and desorption. Breakthrough capacities can be stabilized at the level of 7.6–8.2% w/w with the gas–solid contact time of 13 s. The adsorption capacities for the simulated flue gases containing 5% CO2 are only slightly lower than those for the simulated flue gases containing 15% CO2, indicating that the PEI–silica adsorbent is suitable for CO2 capture from flue gases of both coal-fired and natural gas-fired combined cycle power plants. The exothermal heat of adsorption is estimated by the energy balance in the fluidized bed reactor and found to be close (within 10%) to the measured value by TG-DSC. The regeneration heat for the as-prepared PEI–silica adsorbent is found to be 2360 kJ/kgCO2 assuming 75% recovery of sensible heat which is well below the values of 3900–4500 kJ/kgCO2 for a typical MEA scrubbing process with 90% recovery of sensible heat.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Advances in principal factors influencing carbon dioxide adsorption on zeolites
Bonenfant, D., Kharoune, M., Niquette, P., Mimeault, M., & Hausler, R. (2008) · Science and Technology of Advanced Materials · doi:10.1088/1468-6996/9/1/013007 · Cited by 351
Cited by
Carbon capture and storage (CCS): the way forward
Bui, M., Adjiman, C. S., Bardow, A., Anthony, E. J., Boston, A., Brown, S., Fennell, P. S., Fuss, S., Galindo, A., Hackett, L. A., et al. (2018) · Energy & Environmental Science · doi:10.1039/c7ee02342a · Cited by 4,374
Adsorption of Carbon Dioxide for post-combustion capture: a review
Raganati, F., Miccio, F., & Ammendola, P. (2021) · Energy & Fuels · doi:10.1021/acs.energyfuels.1c01618 · Cited by 661
Abanades, J. C., Arias, B., Lyngfelt, A., Mattisson, T., Wiley, D. E., Li, H., Ho, M. T., Mangano, E., & Brandani, S. (2015) · International Journal of Greenhouse Gas Control · doi:10.1016/j.ijggc.2015.04.018 · Cited by 441
Process intensification for post-combustion CO2 capture with chemical absorption: A critical review
Wang, M., Joel, A. S., Ramshaw, C., Eimer, D., & Musa, N. M. (2015) · Applied Energy · doi:10.1016/j.apenergy.2015.08.083 · Cited by 430
A novel contactor for reducing the cost of direct air capture of CO2
Tegeler, E., Cui, Y., Masoudi, M., Bahmanpour, A. M., Colbert, T., Hensel, J., & Balakotaiah, V. (2023) · Chemical Engineering Science · doi:10.1016/j.ces.2023.119107 · Cited by 31
Pelletization of immobilized amine carbon dioxide sorbents with fly ash and poly (vinyl chloride)
Wilfong, W. C., Gray, M. L., Kail, B. W., & Howard, B. H. (2016) · Energy Technology · doi:10.1002/ente.201500419 · Cited by 27
Metadata
- Authors
- Zhang, W., Liu, H., Sun, C., Drage, T. C., & Snape, C. E.
- Venue
- Chemical Engineering Journal
- Publisher
- Elsevier BV
- Published
- 2014-09
- Volume
- 251
- Pages
- 293-303
- ISSN
- 1385-8947 (ISSN-L)
- OpenAlex
- W2164183346
- Cited by
- 89
- References
- 1
- FWCI
- 12.47
- Type
- journal article
- Language
- en
- Open access
- hybrid
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.