The DOI matches its Crossref record; 37 of the 37 references it cites were found in a registry or an index.
Review of extractive distillation. Process design, operation, optimization and control
Open accessAbstract
Extractive distillation processes enable the separation of non-ideal mixtures, including minimum or maximum boiling azeotropes and low relative volatility mixtures. Unlike azeotropic distillation, the entrainer fed at another location than the main mixture induces an extractive section within the column. A general feasibility criterion shows that intermediate and light entrainers and heterogeneous entrainers are suitable along common heavy entrainers. Entrainer selection rules rely upon selectivity ratios and residue curve map (rcm) topology including univolatility curves. For each type of entrainer, we define extractive separation classes that summarize feasibility regions, achievable products and entrainer – feed flow rate ratio limits. Case studies are listed as supplementary materials. Depending on the separation class, a direct or an indirect split column configuration will allow to obtain a distillate product or a bottom product, which is usually a saddle point of rcm. Batch and continuous process operations differ mainly by the feasible ranges for the entrainer – feed flow rate ratio and reflux ratio. The batch process is feasible under total reflux and can orient the still path by changing the reflux policy. Optimisation of the extractive process must systematically consider the extractive column along with the entrainer regeneration column that requires energy and may limit the product purity in the extractive column through recycle. For the sake of reducing the energy cost and the total cost, pressure change can be beneficial as it affects volatility, or new process structures can be devised, namely heat integrated extractive distillation, extractive divided wall column or processes with preconcentrator.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Perry's chemical engineers' handbook
(1998) · Choice Reviews Online · doi:10.5860/choice.35-3079 · Cited by 5,897
Conceptual design of distillation systems
Doherty, M. F., & Malone, M. F. (2001) · Cited by 592
Ionic liquids in separations of azeotropic systems – A review
Pereiro, A. B., Araújo, J. M. M., Esperança, J. M. S. S., Marrucho, I. M., & Rebelo, L. P. N. (2012) · The Journal of Chemical Thermodynamics · doi:10.1016/j.jct.2011.05.026 · Cited by 464
Extractive Distillation: A Review
Lei, Z., Li, C., & Chen, B. (2003) · Separation & Purification Reviews · doi:10.1081/spm-120026627 · Cited by 449
Dividing wall columns in chemical process industry: A review on current activities
Yildirim, Ö., Kiss, A. A., & Kenig, E. Y. (2011) · Separation and Purification Technology · doi:10.1016/j.seppur.2011.05.009 · Cited by 420
Enhanced bioethanol dehydration by extractive and azeotropic distillation in dividing-wall columns
Kiss, A. A., & Suszwalak, D. J. P. C. (2012) · Separation and Purification Technology · doi:10.1016/j.seppur.2011.10.022 · Cited by 396
Extractive distillation with ionic liquids: A review
Lei, Z., Dai, C., Zhu, J., & Chen, B. (2014) · AIChE Journal · doi:10.1002/aic.14537 · Cited by 346
Practical Distillation Control
(1992) · Springer eBooks · doi:10.1007/978-1-4757-0277-4 · Cited by 323
Design and Control of Distillation Systems for Separating Azeotropes
Luyben, W. L., & Chien, I. (2010) · Wiley eBooks · doi:10.1002/9780470575802 · Cited by 309
Distillation: Principles and Practices
Stichlmair, J., & Fair, J. R. (1998) · Medical Entomology and Zoology · Cited by 285
Proceedings of AIChE 2011 Annual Meeting
Sreedharan, V., Hjertager, B. H., & Solberg, T. (2011) · Cited by 210
Jork, C., Kristen, C., Pieraccini, D., Stark, A., Chiappe, C., Beste, Y. A., & Arlt, W. (2005) · The Journal of Chemical Thermodynamics · doi:10.1016/j.jct.2005.04.013 · Cited by 197
Innovative single step bioethanol dehydration in an extractive dividing-wall column
Kiss, A. A., & Ignat, R. M. (2012) · Separation and Purification Technology · doi:10.1016/j.seppur.2012.06.029 · Cited by 178
Critical Assessment of the Energy-Saving Potential of an Extractive Dividing-Wall Column
Wu, Y. C., Hsu, P. H.-C., & Chien, I. (2013) · Industrial & Engineering Chemistry Research · doi:10.1021/ie3035898 · Cited by 137
Design of an energy-efficient side-stream extractive distillation system
Tututi-Ávila, S., Medina-Herrera, N., Hahn, J., & Jiménez‐Gutiérrez, A. (2016) · Computers & Chemical Engineering · doi:10.1016/j.compchemeng.2016.12.001 · Cited by 125
Control analysis of an extractive dividing-wall column used for ethanol dehydration
Tututi-Ávila, S., Jiménez‐Gutiérrez, A., & Hahn, J. (2014) · Chemical Engineering and Processing - Process Intensification · doi:10.1016/j.cep.2014.05.005 · Cited by 116
Minimum entrainer flows for extractive distillation: A bifurcation theoretic approach
Knapp, J. P., & Doherty, M. F. (1994) · AIChE Journal · doi:10.1002/aic.690400206 · Cited by 107
Reducing energy consumption and CO2 emissions in extractive distillation
Gutiérrez-Guerra, R., Segovia‐Hernández, J. G., & Hernández, S. (2008) · Process Safety and Environmental Protection · doi:10.1016/j.cherd.2008.07.004 · Cited by 104
Leboreiro, J., & Acevedo, J. (2004) · Computers & Chemical Engineering · doi:10.1016/j.compchemeng.2003.06.003 · Cited by 103
García‐Herreros, P., Gómez, J. M., Gil, I. D., & Rodríguez, G. (2011) · Industrial & Engineering Chemistry Research · doi:10.1021/ie101845j · Cited by 103
Low transition temperature mixtures (LTTMs) as novel entrainers in extractive distillation
Rodriguez, N. R., González, A. S. B., Tijssen, P. M. A., & Kroon, M. C. (2014) · Fluid Phase Equilibria · doi:10.1016/j.fluid.2014.10.044 · Cited by 101
Errico, M., Rong, B., Tola, G., & Spano, M. (2013) · Industrial & Engineering Chemistry Research · doi:10.1021/ie301828d · Cited by 90
Lee, F. M., & Pahl, R. H. (1985) · Industrial & Engineering Chemistry Process Design and Development · doi:10.1021/i200028a029 · Cited by 85
Pătraşcu, I., Bîldea, C. S., & Kiss, A. A. (2017) · Process Safety and Environmental Protection · doi:10.1016/j.cherd.2016.12.021 · Cited by 75
Synthesis of new separation processes for bioethanol production by extractive distillation
Errico, M., & Rong, B. (2012) · Separation and Purification Technology · doi:10.1016/j.seppur.2012.05.022 · Cited by 70
Separation of azeotropic mixtures (ethanol and water) enhanced by deep eutectic solvents
Peng, Y. L., Lü, X., Liu, B., & Zhu, J. (2017) · Fluid Phase Equilibria · doi:10.1016/j.fluid.2017.03.010 · Cited by 69
Energy-Saving Designs for Separation of a Close-Boiling 1,2-Propanediol and Ethylene Glycol Mixture
Chen, Y., Hung, S.-K., Lee, H., & Chien, I. (2015) · Industrial & Engineering Chemistry Research · doi:10.1021/ie503922f · Cited by 61
An Approach for Solvent Selection in Extractive Distillation Systems Including Safety Considerations
Medina-Herrera, N., Grossmann, I. E., Mannan, M. S., & Jiménez‐Gutiérrez, A. (2014) · Industrial & Engineering Chemistry Research · doi:10.1021/ie501205j · Cited by 59
Rodriguez, N. R., & Kroon, M. C. (2015) · The Journal of Chemical Thermodynamics · doi:10.1016/j.jct.2015.02.003 · Cited by 58
Purification of bioethanol using extractive batch distillation: Simulation and experimental studies
Pacheco-Basulto, J. Á., Hernández-McConville, D., Barroso‐Muñoz, F. O., Hernández, S., Segovia‐Hernández, J. G., Castro‐Montoya, A. J., & Bonilla‐Petriciolet, A. (2012) · Chemical Engineering and Processing - Process Intensification · doi:10.1016/j.cep.2012.06.015 · Cited by 50
Ebrahimzadeh, E., Matagi, J., Fazlollahi, F., & Baxter, L. L. (2015) · Applied Thermal Engineering · doi:10.1016/j.applthermaleng.2015.11.082 · Cited by 49
A Hybrid Evolutionary–Deterministic Optimization Approach for Conceptual Design
Skiborowski, M., Rautenberg, M., & Marquardt, W. (2015) · Industrial & Engineering Chemistry Research · doi:10.1021/acs.iecr.5b01995 · Cited by 42
Quijada‐Maldonado, E., Meindersma, G. W., & de Haan, A. B. (2016) · Separation and Purification Technology · doi:10.1016/j.seppur.2016.04.041 · Cited by 41
Increasing the Energy Efficiency of Extractive Distillation
Taylor, M., & Wankat, P. C. (2004) · Separation Science and Technology · doi:10.1081/ss-120027398 · Cited by 38
Zhang, L., Zhang, Z., Shen, D., & Lan, M. (2017) · Journal of Chemical & Engineering Data · doi:10.1021/acs.jced.6b00912 · Cited by 31
Control comparison of conventional extractive distillation with a new split-feed configuration
Luyben, W. L. (2016) · Chemical Engineering and Processing - Process Intensification · doi:10.1016/j.cep.2016.06.004 · Cited by 19
Frits, E. R., Markót, M. C., Lelkes, Z., Fonyó, Z., Csendes, T., & Rév, E. (2007) · Journal of Global Optimization · doi:10.1007/s10898-006-9111-3 · Cited by 3
Cited by
Detection and Classification of Anomalies in WSN-Enabled Cyber-Physical Systems
Gutierrez-Rojas, D., Kalalas, C., Christou, I., Almeida, G., Eldeeb, E., Bakri, S., Marchetti, N., Sant'Ana, J. M. S., Alcaraz López, O. L., Alves, H., et al. (2025) · IEEE Sensors Journal · doi:10.1109/jsen.2024.3520507 · Cited by 7
Metadata
- Authors
- Gerbaud, V., Rodriguez-Donis, I., Hegely, L., Lang, P., Denes, F., & You, X.
- Venue
- Chemical Engineering Research and Design
- Publisher
- Elsevier BV
- Published
- 2019-01
- Volume
- 141
- Pages
- 229-271
- ISSN
- 0263-8762 (ISSN-L)
- OpenAlex
- W2891167399
- Cited by
- 294
- References
- 37
- FWCI
- 11.95
- Type
- journal article
- Language
- en
- Open access
- green
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.