The DOI matches its Crossref record.
Autoignition studies of NH3/CH4 mixtures at high pressure
Open accessAbstract
Abstract Autoignition delay times of NH3/CH4 mixtures with CH4 fractions of 0%, 5%, 10% and 50% were measured in a rapid compression machine at equivalence ratio φ = 0.5, pressures from 20 to 70 bar and temperatures from 930 to 1140 K. In addition, measurements were performed for NH3 mixtures with 10% CH4 at φ = 1.0 and 2.0. Methane shows a strong ignition-enhancing effect on NH3, which levels off at higher CH4 fractions, as the ignition delay time approaches that of pure methane. Autoignition delay times at 10% CH4 at φ = 0.5 and 1.0 are indistinguishable, while an increase of ignition delay times by factor of 1.5 was observed upon increasing φ to 2.0. The experimental data were used to evaluate six NH3 oxidation mechanisms capable of simulating NH3/CH4 mixtures. The mechanism previously used by the authors shows the best performance: generally, it predicts the measured ignition delay times to better than 30% for all conditions, except for 50% CH4 addition for which the differences increase up to 50% at the highest temperature. Sensitivity analysis based on the mechanism used indicates that under lean conditions the reaction CH4 + NH2 = CH3 + NH3 significantly promotes ignition for modest CH4 addition (5% and 10%), but becomes modestly ignition-inhibiting at 50% CH4. Sensitivity and rate-of-production analyses indicate that the ignition-enhancing effect of 50% CH4 addition is closely related to the formation and decomposition of H2O2. Flux analysis for NH3/CH4 mixtures indicates that CH4 + NH2 = CH3 + NH3 contributes substantially to the decomposition of methane early in the oxidation process, while CH3 + NO2 (+M) = CH3NO2 (+M) is a significant reservoir of NO2 at low temperature. Additionally, an anomalous pre-ignition pressure rise phenomenon, which is not reproduced by the simulations, was observed with high reproducibility for the NH3 mixture with 50% CH4 addition.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
Review on Ammonia as a Potential Fuel: From Synthesis to Economics
Valera-Medina, A., Amer-Hatem, F., Azad, A. K., Dedoussi, I. C., de Joannon, M., Fernandes, R. X., Glarborg, P., Hashemi, H., He, X., Mashruk, S., et al. (2021) · Energy & Fuels · doi:10.1021/acs.energyfuels.0c03685 · Cited by 1,061
Self-citationA review on ammonia, ammonia-hydrogen and ammonia-methane fuels
Chai, W. S., Bao, Y., Jin, P., Tang, G., & Zhou, L. (2021) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2021.111254 · Cited by 1,028
Review on the recent advances on ammonia combustion from the fundamentals to the applications
Elbaz, A. M., Wang, S., Guiberti, T. F., & Roberts, W. L. (2022) · Fuel Communications · doi:10.1016/j.jfueco.2022.100053 · Cited by 639
Effect of hydrogen blending on the high temperature auto-ignition of ammonia at elevated pressure
Chen, J., Jiang, X., Qin, X., & Huang, Z. (2021) · Fuel · doi:10.1016/j.fuel.2020.119563 · Cited by 331
Dai, L., Hashemi, H., Glarborg, P., Gersen, S., Marshall, P., Mokhov, A., & Levinsky, H. (2021) · Combustion and Flame · doi:10.1016/j.combustflame.2020.12.048 · Cited by 282
Self-citation
Metadata
- Authors
- Dai, L., Gersen, S., Glarborg, P., Mokhov, A., & Levinsky, H.
- Venue
- Combustion and Flame
- Publisher
- Elsevier BV
- Published
- 2020-08
- Volume
- 218
- Pages
- 19-26
- ISSN
- 0010-2180 (ISSN-L)
- OpenAlex
- W3021964106
- Cited by
- 234
- References
- 0
- FWCI
- 9.23
- Type
- journal article
- Language
- en
- Open access
- bronze
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Autoignition studies of NH3/CH4 mixtures at high pressure. https://app.cochat.ai/papers/10.1016/j.combustflame.2020.04.020
- The paper
- Dai, L., Gersen, S., Glarborg, P., Mokhov, A., & Levinsky, H. (2020). Autoignition studies of NH3/CH4 mixtures at high pressure. Combustion and Flame. https://doi.org/10.1016/j.combustflame.2020.04.020
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.